Normalized to: Kelly, G.
[1]
oai:arXiv.org:1611.08587 [pdf] - 1522672
Geomagnetically Induced Currents in the Irish Power Network during
Geomagnetic Storms
Submitted: 2016-11-23
Geomagnetically induced currents (GICs) are a well-known terrestrial space
weather hazard. They occur in power transmission networks and are known to have
adverse effects in both high and mid-latitude countries. Here, we study GICs in
the Irish power transmission network (geomagnetic latitude 54.7--58.5$^{\circ}$
N) during five geomagnetic storms (06-07 March 2016, 20-21 December 2015, 17-18
March 2015, 29-31 October 2003 and 13-14 March 1989). We simulate electric
fields using a plane wave method together with two ground resistivity models,
one of which is derived from magnetotelluric measurements (MT model). We then
calculate GICs in the 220, 275 and 400~kV transmission network. During the
largest of the storm periods studied, the peak electric field was calculated to
be as large as 3.8~V~km\textsuperscript{-1}, with associated GICs of up to 23~A
using our MT model. Using our homogenous resistivity model, those peak values
were 1.46~V~km\textsuperscript{-1} and 25.8~A. We find that three 400 and
275~kV substations are the most likely locations for the Irish transformers to
experience large GICs.
[2]
oai:arXiv.org:1609.02023 [pdf] - 1531503
Molecular shock tracers in NGC 1068: SiO and HNCO
Submitted: 2016-09-07
SiO(3-2) and HNCO(6-5) emission has been imaged in NGC 1068 with the Plateau
de Bure Interferometer (PdBI). We perform an LTE and RADEX analysis to
determine the column densities and physical characteristics of the gas emitting
these two lines. We then use a chemical model to determine the origin of the
emission. There is a strong SiO peak to the East of the AGN, with weak
detections to the West. This distribution contrasts that of HNCO, which is
detected more strongly to the West. The SiO emission peak in the East is
similar to the peak of the molecular gas mass traced by CO. HNCO emission is
offset from this peak by as much as 80 pc ( 1"). We compare velocity integrated
line ratios in the East and West. We confirm that SiO emission strongly
dominates in the East, while the reverse is true in the West. We use RADEX to
analyse the possible gas conditions that could produce such emission. We find
that, in both East and West, we cannot constrain a single temperature for the
gas. We run a grid of chemical models of potential shock processes in the CND
and find that SiO is significantly enhanced during a fast (60 km/s) shock but
not during a slow (20 km/s) shock, nor in a gas not subjected to shocks at all.
We find the inverse for HNCO, whose abundance increases during slow shocks and
in warm non-shocked gas. High SiO and low HNCO indicated a fast shock, while
high HNCO and low SiO indicates either a slow shock or warm, dense, non-shocked
gas. The East Knot is therefore likely to contain gas that is heavily shocked.
From chemical modelling, gas in the West Knot may be non-shocked, or maybe
undergoing a much milder shock event. When taking into account RADEX results,
the milder shock event is the more likely of the two scenarios.
[3]
oai:arXiv.org:1502.04601 [pdf] - 1129013
Mapping CS in Starburst Galaxies: Disentangling and Characterising Dense
Gas
Submitted: 2015-02-16, last modified: 2015-03-12
Aims. We observe the dense gas tracer CS in two nearby starburst galaxies to
determine how the conditions of the dense gas varies across the circumnuclear
regions in starburst galaxies. Methods. Using the IRAM-30m telescope, we mapped
the distribution of the CS(2-1) and CS(3-2) lines in the circumnuclear regions
of the nearby starburst galaxies NGC 3079 and NGC 6946. We also detected the
formaldehyde (H2CO) and methanol (CH3OH) in both galaxies. We marginally detect
the isotopologue C34S. Results. We calculate column densities under LTE
conditions for CS and CH3OH. Using the detections accumulated here to guide our
inputs, we link a time and depth dependent chemical model with a molecular line
radiative transfer model; we reproduce the observations, showing how conditions
where CS is present are likely to vary away from the galactic centres.
Conclusions. Using the rotational diagram method for CH3OH, we obtain a lower
limit temperature of 14 K. In addition to this, by comparing the chemical and
radiative transfer models to observations, we determine the properties of the
dense gas as traced by CS (and CH3OH). We also estimate the quantity of the
dense gas. We find that, provided that there are a between 10^5 and 10^6 dense
cores in our beam, for both target galaxies, emission of CS from warm (T = 100
- 400 K), dense (n(H2) = 10^5-6 cm-3) cores, possibly with a high cosmic ray
ionisation rate (zeta = 100 zeta0) best describes conditions for our central
pointing. In NGC 6946, conditions are generally cooler and/or less dense
further from the centre, whereas in NGC 3079, conditions are more uniform. The
inclusion of shocks allows for more efficient CS formation, leading to an order
of magnitude less dense gas being required to replicate observations in some
cases.
[4]
oai:arXiv.org:1202.4938 [pdf] - 1116828
On the formation of glycolaldehyde in dense molecular cores
Submitted: 2012-02-22
Glycolaldehyde is a simple monosaccharide sugar linked to prebiotic
chemistry. Recently it was detected in a molecular core in the star-forming
region G31.41+0.31 at a reasonably high abundance. We investigate the formation
of glycolaldehyde at 10K to determine whether it can form efficiently under
typical dense core conditions. Using an astrochemical model, we test five
different reaction mechanisms that have been proposed in the astrophysical
literature, finding that a gas-phase formation route is unlikely. Of the
grain-surface formation routes, only two are efficient enough at very low
temperatures to produce sufficient glycolaldehyde to match the observational
estimates, with the mechanism culminating in CH3OH + HCO being favoured.
However, when we consider the feasibility of these mechanisms from a reaction
chemistry perspective, the second grain-surface route looks more promising,
H3CO + HCO.