We consider the mechanism of photophoretic transport in protoplanetary disks that are optically thick to radiation. Here, photophoresis is not caused by the central star but by temperature fluctuations that subject suspended solid particles, including chondrules, to non-isotropic thermal radiation within the disk. These short-lived temperature fluctuations can explain time-of-flight size sorting and general number density enhancements. The same mechanism will also lead to velocity fluctuations of dust aggregates beyond $100\,\mathrm{m\,s^{-1}}$ for mm-sized particles in protoplanetary disks. Applying this in future research will change our understanding of the early phases of collisional dust evolution and aggregate growth as particles cross the bouncing barrier and as mass transfer rates are altered.

In laboratory experiments, we studied collisions of ensembles of compact (filling factor 0.33) millimeter dust aggregates composed of micrometer quartz grains. We used cylindrical aggregates, triangular aggregates, square aggregates, and rectangular aggregates. Ensembles of equal size aggregates as well as ensembles with embedded larger aggregates were studied. The typical collision velocities are 10-20 mm $\rm s^{-1}$. High spatial and temporal resolution imaging unambiguously shows that individual collisions lead to sticking with a high probability of 20 percent. This leads to connected clusters of aggregates. The contact areas between two aggregates increase with collision velocity. However, this cluster growth is only temporary, as subsequent collisions of aggregates and clusters eventually lead to the detachment of all aggregates from a cluster. The contacts are very fragile as aggregates cannot be compressed further or fragment under our experimental conditions to enhance the contact stability. Therefore, the evolution of the ensemble always leads back to a distribution of individual aggregates of initial size. This supports and extends earlier experiments showing that a bouncing barrier in planetesimal formation would be robust against shape and size variations.

The illuminated dusty surface of Mars acts like a gas pump. It is driven by thermal creep at low pressure within the soil. In the top soil layer this gas flow has to be sustained by a pressure gradient. This is equivalent to a lifting force on the dust grains. The top layer is therefore under tension which reduces the threshold wind speed for saltation. We carried out laboratory experiments to quantify the thickness of this activated layer. We use basalt with an average particle size of 67 $\mu$m. We find a depth of the active layer of 100 to 200 $\rm \mu m$. Scaled to Mars the activation will reduce threshold wind speeds for saltation by about 10%.

For dust aggregates in protoplanetary discs a transition between sticking and bouncing in individual collisions at mm to cm size has been observed in the past. This lead to the notion of a bouncing barrier for which growth gets stalled. Here, we present long term laboratory experiments on the outcome of repeated aggregate collisions at the bouncing barrier. About 100 SiO$_2$ dust aggregates of 1 mm in size were observed interacting with each other. Collisions occured within a velocity range from below mm/s up to cm/s. Aggregates continuously interacted with each other over a period of 900 s. During this time more than $10^5$ collisions occured. Nearly 2000 collisions were analyzed in detail. No temporal stable net growth of larger aggregates was observed even though sticking collision occur. Larger ensembles of aggregates sticking together are formed but were disassembled again during the further collisional evolution. The concept of a bouncing barrier supports the formation of planetesimals by seeded collisional growth as well as by gravitational instability favouring a significant total mass being limited to certain size ranges. Within our parameter set the experiments confirm that bouncing barriers are one possible and likely evolutionary limit of a self consistent particle growth.

At the inner edge of a protoplanetary disk solids are illuminated by stellar light. This illumination heats the solids and creates temperature gradients along their surfaces. Interactions with ambient gas molecules lead to a radial net gas flow. Every illuminated solid particle within the edge is an individual small gas pump transporting gas inward. In total the inner edge can provide local mass flow rates as high as $\dot{M} = 10^{-5} M_{\odot}$ yr$^{-1}$.

Transporting solids of different sizes is an essential process in the evolution of protoplanetary disks and planet formation. Large solids are supposed to drift inward; high-temperature minerals found in comets are assumed to have been transported outward. From low-gravity experiments on parabolic flights we studied the light-induced erosion of dusty bodies caused by a solid-state greenhouse effect and photophoresis within a dust bed's upper layers. The gravity levels studied were 0.16g, 0.38g, 1g, and 1.7g. The light flux during the experiments was 12 +/- 2 kW/m^2 and the ambient pressure was 6 +/- 0.9 mbar. Light-induced erosion is strongly gravity dependent, which is in agreement with a developed model. In particular for small dusty bodies ((sub)-planetesimals), efficient erosion is possible at the optically thin inner edges of protoplanetary disks. Light-induced erosion prevents significant parts of a larger body from moving too close to the host star and be being subsequently accreted. The small dust produced continues to be subject to photophoresis and is partially transported upward and outward over the surface of the disk; the resulting small dust particles observed over the disk's lifetime. The fraction of eroded dust participates in subsequent cycles of growth during planetesimal formation. Another fraction of dust might be collected by a body of planetary size if this body is already present close to the disk edge. Either way, light induced erosion is an efficient recycling process in protoplanetary disks.

Collisions of mm-size dust aggregates play a crucial role in the early phases of planet formation. We developed a laboratory setup to observe collisions of dust aggregates levitating at mbar pressures and elevated temperatures of 800 K. We report on collisions between basalt dust aggregates of from 0.3 to 5 mm in size at velocities between 0.1 and 15 cm/s. Individual grains are smaller than 25 \mum in size. We find that for all impact energies in the studied range sticking occurs at a probability of 32.1 \pm 2.5% on average. In general, the sticking probability decreases with increasing impact parameter. The sticking probability increases with energy density (impact energy per contact area). We also observe collisions of aggregates that were formed by a previous sticking of two larger aggregates. Partners of these aggregates can be detached by a second collision with a probability of on average 19.8 \pm 4.0%. The measured accretion efficiencies are remarkably high compared to other experimental results. We attribute this to the rel. large dust grains used in our experiments, which make aggregates more susceptible to restructuring and energy dissipation. Collisional hardening by compaction might not occur as the aggregates are already very compact with only 54 \pm 1% porosity. The disassembly of previously grown aggregates in collisions might stall further aggregate growth. However, owing to the levitation technique and the limited data statistics, no conclusive statement about this aspect can yet be given. We find that the detachment efficiency decreases with increasing velocities and accretion dominates in the higher velocity range. For high accretion efficiencies, our experiments suggest that continued growth in the mm-range with larger constituent grains would be a viable way to produce larger aggregates, which might in turn form the seeds to proceed to growing planetesimals.

Small (sub)-micron dust is present over the entire lifetime of protoplanetary disks. As aggregation readily depletes small particles, one explanation might be that dust is continuously generated by larger bodies in the midplane and transported to the surface of the disks. In general, in a first step of this scenario, the larger bodies have to be destroyed again and different mechanisms exist with the potential to accomplish this. Possible destructive mechanisms are fragmentation in collisions, erosion by gas drag or light induced erosion. In laboratory experiments we find that the latter, light induced erosion by Knudsen compression and photophoresis, can provide small particles. It might be a preferred candidate as the dust is released into a low particle density region. The working principle of this mechanism prevents or decreases the likelihood for instant re-accretion or re-growth of large dense aggregates. Provided that there is a particle lift, e.g. turbulence, these particles might readily reach the surface of the disk.

Laboratory experiments show that dusty bodies in a gaseous environment eject dust particles if they are illuminated. We find that even more intense dust eruptions occur when the light source is turned off. We attribute this to a compression of gas by thermal creep in response to the changing temperature gradients in the top dust layers. The effect is studied at a light flux of 13 kW/(m*m) and 1 mbar ambient pressure. The effect is applicable to protoplanetary disks and Mars. In the inner part of protoplanetary disks, planetesimals can be eroded especially at the terminator of a rotating body. This leads to the production of dust which can then be transported towards the disk edges or the outer disk regions. The generated dust might constitute a significant fraction of the warm dust observed in extrasolar protoplanetary disks. We estimate erosion rates of about 1 kg/s for 100 m parent bodies. The dust might also contribute to subsequent planetary growth in different locations or on existing protoplanets which are large enough not to be susceptible to particle loss by light induced ejection. Due to the ejections, planetesimals and smaller bodies will be accelerated or decelerated and drift outward or inward, respectively. The effect might also explain the entrainment of dust in dust devils on Mars, especially at high altitudes where gas drag alone might not be sufficient.