Normalized to: Kamazuka, T.
[1]
oai:arXiv.org:physics/0208090 [pdf] - 118996
Proton Irradiation Experiment for the X-ray Charge-Coupled Devices of
the Monitor of All-sky X-ray Image mission onboard the International Space
Station: I. Experimental Setup and Measurement of the Charge Transfer
Inefficiency
Miyata, E.;
Kamazuka, T.;
Kouno, H.;
Mihara, M. Fukuda M.;
Matsuta, K.;
Tsunemi, H.;
Tanaka, K.;
Minamisono, T;
Tomida, H.;
Miyaguchi, K.
Submitted: 2002-08-26
We have investigated the radiation damage effects on a CCD to be employed in
the Japanese X-ray astronomy mission including the Monitor of All-sky X-ray
Image (MAXI) onboard the International Space Station (ISS). Since low energy
protons release their energy mainly at the charge transfer channel, resulting a
decrease of the charge transfer efficiency, we thus focused on the low energy
protons in our experiments. A 171 keV to 3.91 MeV proton beam was irradiated to
a given device. We measured the degradation of the charge transfer inefficiency
(CTI) as a function of incremental fluence. A 292 keV proton beam degraded the
CTI most seriously. Taking into account the proton energy dependence of the
CTI, we confirmed that the transfer channel has the lowest radiation tolerance.
We have also developed the different device architectures to reduce the
radiation damage in orbit. Among them, the ``notch'' CCD, in which the buried
channel implant concentration is increased, resulting in a deeper potential
well than outside, has three times higher radiation tolerance than that of the
normal CCD. We then estimated the charge transfer inefficiency of the CCD in
the orbit of ISS, considering the proton energy spectrum. The CTI value is
estimated to be 1.1e-5 per each transfer after two years of mission life in the
worse case analysis if the highest radiation-tolerant device is employed. This
value is well within the acceptable limit and we have confirmed the high
radiation-tolerance of CCDs for the MAXI mission.
[2]
oai:arXiv.org:astro-ph/0107445 [pdf] - 43816
SSC of MAXI experiment
Sakano, M.;
Tomida, H.;
Matsuoka, M.;
Ueno, S.;
Komatsu, S.;
Shirasaki, Y.;
Sugizaki, M.;
Torii, K.;
Yuan, W.;
Miyata, E.;
Tsunemi, H.;
Kamazuka, T.;
Natsukari, C.;
Jobashi, M.;
Tanaka, I.;
Kawai, N.;
Mihara, T.;
Negoro, H.;
Yoshida, A.
Submitted: 2001-07-23
Monitor of All-sky X-ray Image (MAXI) on the International Space Station
(ISS) has two kinds of X-ray detectors: the Gas Slit Camera (GSC) and the
Solid-state Slit Camera (SSC). SSC is an X-ray CCD array, consisting of 16
chips, which has the best energy resolution as an X-ray all-sky monitor in the
energy band of 0.5 to 10 keV. Each chip consists of 1024x1024 pixels with a
pixel size of 24$\mu$m, thus the total area is ~200 cm^2. We have developed an
engineering model of SSC, i.e., CCD chips, electronics, the software and so on,
and have constructed the calibration system. We here report the current status
of the development and the calibration of SSC.
