We present an analysis of off-limb cool flare loops observed by SDO/AIA during the gradual phase of SOL2017-09-10T16:06 X8.2-class flare. In the EUV channels starting from the 335 {\AA} one, cool loops appear as dark structures against the bright loop arcade. These dark structures were precisely coaligned (spatially and temporally) with loops observed by SST in emission lines of hydrogen and ionized calcium. Recently published semi-empirical model of cool loops based on SST observations serves us to predict the level of hydrogen and helium recombination continua. The continua were synthesized using an approximate non-LTE approach and theoretical spectra were then transformed to AIA signals. Comparison with signals detected inside the dark loops shows that only in AIA 211 {\AA} channel the computed level of recombination continua is consistent with observations for some models, while in all other channels which are more distant from the continua edges the synthetic continuum is far too low. In analogy with on-disk observations of flares we interpret the surplus emission as due to numerous EUV lines emitted from hot but faint loops in front of the cool ones. Finally we briefly comment on failure of the standard absorption model when used for analysis of the dark-loop brightness.

Metis is the first solar coronagraph designed for a space mission capable of performing simultaneous imaging of the off-limb solar corona in both visible and UV light. The observations obtained with Metis aboard the Solar Orbiter ESA-NASA observatory will enable us to diagnose, with unprecedented temporal coverage and spatial resolution, the structures and dynamics of the full corona from 1.7 $R_\odot$ to about 9 $R_\odot$. Due to the uniqueness of the Solar Orbiter mission profile, Metis will be able to observe the solar corona from a close vantage point (down to 0.28 AU), achieving out-of-ecliptic views with the increase of the orbit inclination over time. Moreover, observations near perihelion, during the phase of lower rotational velocity of the solar surface relative to the spacecraft, will allow longer-term studies of the coronal features. Thanks to a novel occultation design and a combination of a UV interference coating of the mirrors and a spectral bandpass filter, Metis images the solar corona simultaneously in the visible light band, between 580 and 640 nm, and in the UV H I Lyman-{\alpha} line at 121.6 nm. The coronal images in both the UV Lyman-{\alpha} and polarised visible light are obtained at high spatial resolution with a spatial scale down to about 2000 km and 15000 km at perihelion, in the cases of the visible and UV light, respectively. A temporal resolution down to 1 second can be achieved when observing coronal fluctuations in visible light. The Metis measurements will allow for complete characterisation of the main physical parameters and dynamics of the electron and neutral hydrogen/proton plasma components of the corona in the region where the solar wind undergoes acceleration and where the onset and initial propagation of coronal mass ejections take place, thus significantly improving our understanding of the region connecting the Sun to the heliosphere.

Flare loops form an integral part of eruptive events, being detected in the range of temperatures from X-rays down to cool chromospheric-like plasmas. While the hot loops are routinely observed by the Solar Dynamics Observatory's Atmospheric Imaging Assembly (SDO/AIA), cool loops seen off-limb are rare. In this paper we employ unique observations of the SOL2017-09-10T16:06 X8.2-class flare which produced an extended arcade of loops. The Swedish 1-m Solar Telescope (SST) made a series of spectral images of the cool off-limb loops in the Ca II 8542 \r{A} and the hydrogen H$\beta$ lines. Our focus is on the loop apices. Non-LTE spectral inversion is achieved through the construction of extended grids of models covering a realistic range of plasma parameters. The Multilevel Accelerated Lambda Iterations (MALI) code solves the non-LTE radiative-transfer problem in a 1D externally-illuminated slab, approximating the studied loop segment. Inversion of the Ca II 8542 \r{A} and H$\beta$ lines yields two similar solutions, both indicating high electron densities around $2 \times 10^{12}$ cm$^{-3}$ and relatively large microturbulence around 25 kms$^{-1}$. These are in reasonable agreement with other independent studies of the same or similar events. In particular, the high electron densities in the range $10^{12} - 10^{13}$ cm$^{-3}$ are consistent with those derived from the SDO's Helioseismic and Magnetic Imager white-light observations. The presence of such high densities in solar eruptive flares supports the loop interpretation of the optical continuum emission of stars which manifest superflares.

The density distribution of flare loops and the mechanisms of their emission in the continuum are still open questions. On September 10, 2017 a prominent loop system appeared during the gradual phase of an X8.2 flare (SOL2017-09-10), visible in all passbands of SDO/AIA and in the white-light continuum of SDO/HMI. We investigate its electron density by taking into account all radiation processes in the flare loops, i.e. the Thomson continuum, hydrogen Paschen and Brackett recombination continua, as well as free-free continuum emission. We derive a quadratic function of the electron density for a given temperature and effective loop thickness. By absolutely calibrating SDO/HMI intensities, we convert the measured intensities into electron density at each pixel in the loops. For a grid of plausible temperatures between cool (6000 K) and hot (10^6 K) structures, the electron density is computed for representative effective thicknesses between 200 and 20 000 km. We obtain a relatively high maximum electron density, about 10^13 cm^-3. At such high electron densities, the Thomson continuum is negligible and therefore one would not expect a significant polarization degree in dense loops. We conclude that the Paschen and Brackett recombination continua are dominant in cool flare loops, while the free-free continuum emission is dominant for warmer and hot loops.

The paper analyzes the structure and dynamics of a quiescent prominence that occurred on October 22, 2013. We aim to determine the physical characteristics of the observed prominence using MgII k and h, CII (1334 and 1336 A), and SiIV (1394 A) lines observed by IRIS. We employed the 1D non-LTE modeling of MgII lines assuming static isothermal-isobaric slabs. We selected a large grid of models with realistic input parameters and computed synthetic MgII lines. The method of Scargle periodograms was used to detect possible prominence oscillations. We analyzed 2160 points of the observed prominence in five different sections along the slit averaged over ten pixels due to low signal to noise ratio in the CII and SiIV lines. We computed the integrated intensity for all studied lines, while the central intensity and reversal ratio was determined only for both MgII and CII 1334 lines. We plotted several correlations: time evolution of the integrated intensities and central intensities, scatter plots between all combinations of line integrated intensities, and reversal ratio as a function of integrated intensity. We also compared MgII observations with the models. Results show that more than two-thirds of MgII profiles and about one-half of CII 1334 profiles are reversed. Profiles of SiIV are generally unreversed. The MgII and CII lines are optically thick, while the SiIV line is optically thin. The studied prominence shows no global oscillations in the MgII and CII lines. Therefore, the observed time variations are caused by random motions of fine structures with velocities up to 10 km/s. The observed average ratio of MgII k to MgII h line intensities can be used to determine the prominence's characteristic temperature. Certain disagreements between observed and synthetic line intensities of MgII lines point to the necessity of using more complex 2D multi-thread modeling in the future.

We determine an optimal width and shape of the narrow-band filter centered around the He\,{\sc i} D$_{3}$ line for prominence and coronal mass ejection (CME) observations with the ASPIICS ({\it Association of Spacecraft for Polarimetric and Imaging Investigation of the Corona of the Sun}) coronagraph onboard the PROBA-3 ({\it Project for On-board Autonomy}) satellite, to be launched in 2020. We analyze He\,{\sc i} D$_{3}$ line intensities for three representative non-LTE prominence models at temperatures 8, 30 and 100~kK computed by the radiative transfer code and the prominence visible-light (VL) emission due to Thomson scattering on the prominence electrons. We compute various useful relations at prominence line-of-sight (LOS) velocities of 0, 100, and 300~km~s$^{-1}$ for 20~\AA~wide flat filter and three Gaussian filters with full width at half maximum (FWHM) equal to 5, 10, and 20~\AA~to show the relative brightness contribution of the He\,{\sc i} D$_{3}$ line and the prominence VL to the visibility in a given narrow-band filter. We also discuss possible signal contamination by Na\,{\sc i} D$_{1}$ and D$_{2}$ lines which otherwise may be useful to detect comets. Results mainly show: i) an optimal narrow-band filter should be flat or somewhere between flat and Gaussian with FWHM of 20~\AA~in order to detect fast moving prominence structures, ii) the maximum emission in the He\,{\sc i} D$_3$ line is at 30~kK and the minimal at 100~kK, and iii) the ratio of emission in the He\,{\sc i} D$_3$ line to the VL emission can provide a useful diagnostic for the temperature of prominence structures. This ratio is up to 10 for hot prominence structures, up to 100 for cool structures and up to 1000 for warm structures.

This work deals with the study of an erupting prominence embedded in the core of a CME and focuses on the derivation of the prominence plasma filling factor. We explore two methods to measure the prominence plasma filling factor that are based on the combination of visible-light and ultraviolet spectroscopic observations. Theoretical relationships for resonant scattering and collisional excitation are used to evaluate the intensity of the H I Lyman-{\alpha} and Lyman-{\beta} lines, in two prominence points where simultaneous and cospatial LASCO-C2 and UVCS data were available. Thermodynamic and geometrical parameters assumed for the calculation are provided by both observations and the results of a detailed 1D non-LTE radiative-transfer model of the prominence, developed in our previous work (Heinzel 2016). The filling factor is derived from the comparison between the calculated and the measured intensities of the two lines. The results are then checked against the non-LTE model in order to verify the reliability of the methods. The resulting filling factors are consistent with the model in both the prominence points when the separation of the radiative and collisional components of the total intensity, required to estimate the filling factor, is performed using both the line intensities. An exploration of the parameter space shows that the results are weakly sensitive to the plasma velocity, but they depends more strongly on the assumed kinetic temperatures. The combination of visible-light and ultraviolet Lyman-{\alpha} and Lyman-{\beta} data can be used to approximately estimate the geometrical filling factor in erupting prominences, but the proposed techniques are reliable only for emission that is optically thin in the lines considered, condition that is not in general representative of prominence plasma.