sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Jarvis, R. M.

Normalized to: Jarvis, R.

3 article(s) in total. 28 co-authors. Median position in authors list is 3,0.

[1]  oai:arXiv.org:nucl-ex/0608027  [pdf] - 118485
In Beam Tests of Implanted Helium Targets
Comments: Submitted to the New Online Journal of Instrumentation, JINST. Work Supported by USDOE Grant Nos: DE-FG02-94ER40870, DE-FG02-91ER40609, DE-FG02-97ER41033, and DE-FG02-97ER41046
Submitted: 2006-08-16
Targets consisting of 3,4He implanted into thin aluminum foils (approximately 100, 200 or 600 ug/cm^2) were prepared using intense (a few uA) helium beams at low energy (approximately 20, 40 or 100 keV). Uniformity of the implantation was achieved by a beam raster across a 12 mm diameter tantalum collimator at the rates of 0.1 Hz in the vertical direction and 1 Hz in the horizontal direction. Helium implantation into the very thin (approximately 80-100 ug/cm^2) aluminum foils failed to produce useful targets (with only approximately 10% of the helium retained) due to an under estimation of the range by the code SRIM. The range of low energy helium in aluminum predicted by Northcliffe and Shilling and the NIST online tabulation are observed on the other hand to over estimate the range of low energy helium ions in aluminum. An attempt to increase the amount of helium by implanting a second deeper layer was also carried out, but it did not significantly increase the helium content beyond the blistering limit (approximately 6 x 10^17 helium/cm^2). The implanted targets were bombarded with moderately intense 4He and 16O beams of 50-100 particle nA . Rutherford Back Scattering of 1.0 and 2.5 MeV proton beams and recoil helium from 15.0 MeV oxygen beams were used to study the helium content and profile before, during and after bombardments. We observed the helium content and profile to be very stable even after a prolonged bombardment (up to two days) with moderately intense beams of 16O or 4He. Helium implanted into thin (aluminum) foils is a good choice for thin helium targets needed, for example, for a measurement of the 3he(a,g)7Be reaction and the associated S34 astrophysical cross section factor (S-factor).
[2]  oai:arXiv.org:astro-ph/0010071  [pdf] - 38419
Weak Lensing Determination of the Mass in Galaxy Halos
Comments: 18 pages, incl. 3 figures. Submitted to ApJ 6/7/00, still no response from the referee after four months!
Submitted: 2000-10-03
We detect the weak gravitational lensing distortion of 450,000 background galaxies (20<R<23) by 790 foreground galaxies (R<18) selected from the Las Campanas Redshift Survey (LCRS). This is the first detection of weak lensing by field galaxies of known redshift, and as such permits us to reconstruct the shear profile of the typical field galaxy halo in absolute physical units (modulo H_0), and to investigate the dependence of halo mass upon galaxy luminosity. This is also the first galaxy-galaxy lensing study for which the calibration errors are negligible. Within a projected radius of 200 \hkpc, the shear profile is consistent with an isothermal profile with circular velocity 164+-20 km/s for an L* galaxy, consistent with typical disk rotation at this luminosity. This halo mass normalization, combined with the halo profile derived by Fischer et al (2000) from lensing analysis SDSS data, places a lower limit of (2.7+-0.6) x 10^{12}h^{-1} solar masses on the mass of an L* galaxy halo, in good agreement with satellite galaxy studies. Given the known luminosity function of LCRS galaxies, and the assumption that $M\propto L^\beta$ for galaxies, we determine that the mass within 260\hkpc of normal galaxies contributes $\Omega=0.16\pm0.03$ to the density of the Universe (for $\beta=1$) or $\Omega=0.24\pm0.06$ for $\beta=0.5$. These lensing data suggest that $0.6<\beta<2.4$ (95% CL), only marginally in agreement with the usual $\beta\approx0.5$ Faber-Jackson or Tully-Fisher scaling. This is the most complete direct inventory of the matter content of the Universe to date.
[3]  oai:arXiv.org:astro-ph/9810491  [pdf] - 103607
Possible High-Redshift, Low-Luminosity AGN Activity in the Hubble Deep Field
Comments: 10 pages LaTex plus 2 separate files (Table 1 which is a two-page landscape LaTex file; and Figure 6 which is a large (0.7 MB) non-encapsulated postscript file). Accepted for publication in the Astronomical Journal
Submitted: 1998-10-30
In the Hubble Deep Field (HDF), twelve candidate sources of high-redshift (z > 3.5) AGN activity have been identified. The color selection criteria were established by passing spectra of selected quasars and Seyfert galaxies (appropriately redshifted and modified for "Lyman forest" absorption), as well as stars, observed normal and starburst galaxies, and galaxy models for various redshifts through the filters used for the HDF observations. The actual identification of AGN candidates also involved convolving a Laplacian-of-Gaussian filter with the HDF images, thereby removing relatively flat galactic backgrounds and leaving only the point-like components in the centers. Along with positions and colors, estimated redshifts and absolute magnitudes are reported, with the candidates falling toward the faint end of the AGN luminosity function. One candidate has been previously observed spectroscopically, with a measured redshift of 4.02. The number of sources reported here is consistent with a simple extrapolation of the observed quasar luminosity function to magnitude 30 in B_Johnson. Implications for ionization of the intergalactic medium and for gravitational lensing are discussed.