A method for accurate modeling of a reflector antenna system with a wideband phased array feed is presented and used to study the effects of the number of active antenna elements and associated receiving channels on the receiving sensitivity of the antenna system. Numerical results are shown for a practical design named APERTIF that is currently under developed at The Netherlands Institute for Radio Astronomy (ASTRON).

In this paper, we present a numerical electromagnetic model of a focal plane array in combination with a multi-channel receiver. Initial experimental validation results are shown that confirm the expected predictions from the model.

The given work is devoted to the modern developments in the field of radio astronomy instrumentation. In particular, the sensitivity of the multi-beam reflector radio telescope which is fed by phased array (PAF) is considered. Using PAF as reflector feed allows obtaining wide and continuous field of view (FOV) of the telescope. This has several advantages with compare to horn-cluster feeds which are described in this work. The sensitivity inside whole FOV was computed using three different beamforming schemes.

The model of the reflector antenna system with focal plane array, low-noise amplifier and beamformer is developed in the work. The beamformer strategy is suggested to reduce the receiving sensitivity ripple inside field of view of the telescope, while the sensitivity itself drops slightly (less than 10%). The system APERTIF (which is currently under development in Netherlands Institute For Radioastronomy, ASTRON) has been analyzed using developed model, and numerical results are presented. The obtained numerical results have been verified experimentally in anechoic chamber as well as on one of the dishes of the Westerbork Synthesis Radio Telescope (all measurements have been done in ASTRON).

A method for modeling a reflector antenna system with a wideband phased array feed is presented and used to study the effects of the number of active antenna elements and associated receiving channels on the sensitivity of the system. Numerical results are shown for a practical system named APERTIF that is currently under developed at The Netherlands Institute for Radio Astronomy (ASTRON)

In this paper we will describe the feed model for the tapered slot antennas (TSAs) and will find one of the important parameter of this model - transformation coefficient.

A concept of an axi-symmetric dish as antenna reflector for the next generation radio telescope - the Square Kilometre Array (SKA) - is presented. The reflector is based on the use of novel thermoplastic composite material (reinforced with carbon fibre) in the context of the telescope design with wide band single pixel feeds. The baseline of this design represents an array of 100's to 1000's reflector antennas of 15-m diameter and covers frequencies from <1 to 10 GHz. The purpose of our study is the analysis of the production cost of the dish and its performance in combination with a realistic wideband feed (such as the 'Eleven Antenna' feed) over a wide frequency band and a range of elevation angles. The presented initial simulation results inidicate the potential of the proposed dish concept for low-cost and mass production and demonstrate sensitivity comparable to that of the presently considered off-set Gregorian reflector antenna with the same projected aperture area. We expect this observation to be independent of the choice of the feed, as several other single-pixel wideband feeds (that have been reported in the literature) have similar beamwidth and phase center location, both being rather constant with frequency.