sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Inbanathan, S. S. R.

Normalized to: Inbanathan, S.

2 article(s) in total. 25 co-authors, from 1 to 2 common article(s). Median position in authors list is 7,0.

[1]  oai:arXiv.org:2005.00994  [pdf] - 2088316
Energy sensitivity of the GRAPES-3 EAS array for primary cosmic ray protons
Comments: 15 pages, 6 figures
Submitted: 2020-05-03
Low energy ground-based cosmic ray air shower experiments generally have energy threshold in the range of a few tens to a few hundreds of TeV. The shower observables are measured indirectly with an array of detectors. The atmospheric absorption of low energy secondaries limits their detection frequencies at the Earth's surface. However, due to selection effects, a tiny fraction of low energy showers, which are produced in the lower atmosphere can reach the observational level. But, due to less information of shower observables, the reconstruction of these showers are arduous. Hence, it is believed that direct measurements by experiments aboard on satellites and balloon flights are more reliable at low energies. Despite having very small efficiency ($\sim$0.1%) at low energies, the large acceptance ($\sim$5 m$^2$sr) of GRAPES-3 experiment allows observing primary cosmic rays down below to $\sim$1 TeV and opens up the possibility to measure primary energy spectrum spanning from a few TeV to beyond cosmic ray knee (up to 10$^{16}$ eV), covering five orders of magnitude. The GRAPES-3 energy threshold for primary protons through Monte Carlo simulations are calculated, which gives reasonably good agreement with data. Furthermore, the total efficiencies and acceptance are also calculated for protons primaries. The ability of GRAPES-3 experiment to cover such a broader energy range may provide a unique handle to bridge the energy spectrum between direct measurements at low energies and indirect measurements at ultra-high energies.
[2]  oai:arXiv.org:1908.05948  [pdf] - 1944328
Modeling of rigidity dependent CORSIKA simulations for GRAPES-3
Comments: Exp Astron (2019)
Submitted: 2019-08-16
The GRAPES-3 muon telescope located in Ooty, India records 4x10^9 muons daily. These muons are produced by interaction of primary cosmic rays (PCRs) in the atmosphere. The high statistics of muons enables GRAPES-3 to make precise measurement of various sun-induced phenomenon including coronal mass ejections (CME), Forbush decreases, geomagnetic storms (GMS) and atmosphere acceleration during the overhead passage of thunderclouds. However, the understanding and interpretation of observed data requires Monte Carlo (MC) simulation of PCRs and subsequent development of showers in the atmosphere. CORSIKA is a standard MC simulation code widely used for this purpose. However, these simulations are time consuming as large number of interactions and decays need to be taken into account at various stages of shower development from top of the atmosphere down to ground level. Therefore, computing resources become an important consideration particularly when billion of PCRs need to be simulated to match the high statistical accuracy of the data. During the GRAPES-3 simulations, it was observed that over 60% of simulated events don't really reach the Earth's atmosphere. The geomagnetic field (GMF) creates a threshold to PCRs called cutoff rigidity Rc, a direction dependent parameter below which PCRs can't reach the Earth's atmosphere. However, in CORSIKA there is no provision to set a direction dependent threshold. We have devised an efficient method that has taken into account of this Rc dependence. A reduction by a factor ~3 in simulation time and ~2 in output data size was achieved for GRAPES-3 simulations. This has been incorporated in CORSIKA version v75600 onwards. Detailed implementation of this along the potential benefits are discussed in this work.