Local helioseismology provides a unique opportunity to investigate the subsurface structure and dynamics of active regions and their effect on the large-scale flows and global circulation of the Sun. We use measurements of plasma flows in the upper convection zone, provided by the Time-Distance Helioseismology Pipeline developed for analysis of solar oscillation data obtained by Helioseismic and Magnetic Imager (HMI) on Solar Dynamics Observatory (SDO), to investigate the subsurface dynamics of emerging active region NOAA 11726. The active region emergence was detected in deep layers of the convection zone about 12 hours before the first bipolar magnetic structure appeared on the surface, and 2 days before the emergence of most of the magnetic flux. The speed of emergence determined by tracking the flow divergence with depth is about 1.4 km/s, very close to the emergence speed in the deep layers. As the emerging magnetic flux becomes concentrated in sunspots local converging flows are observed beneath the forming sunspots. These flows are most prominent in the depth range 1-3 Mm, and remain converging after the formation process is completed. On the larger scale converging flows around active region appear as a diversion of the zonal shearing flows towards the active region, accompanied by formation of a large-scale vortex structure. This process occurs when a substantial amount of the magnetic flux emerged on the surface, and the converging flow pattern remains stable during the following evolution of the active region. The Carrington synoptic flow maps show that the large-scale subsurface inflows are typical for active regions. In the deeper layers (10-13 Mm) the flows become diverging, and surprisingly strong beneath some active regions. In addition, the synoptic maps reveal a complex evolving pattern of large-scale flows on the scale much larger than supergranulation.

Of all the activity observed on the Sun, two of the most energetic events are flares and Coronal Mass Ejections (CMEs). Usually, solar active regions that produce large flares will also produce a CME, but this is not always true (Yashiro et al., 2005). Despite advances in numerical modeling, it is still unclear which circumstances will produce a CME (Webb & Howard, 2012). Therefore, it is worthwhile to empirically determine which features distinguish flares associated with CMEs from flares that are not. At this time, no extensive study has used physically meaningful features of active regions to distinguish between these two populations. As such, we attempt to do so by using features derived from [1] photospheric vector magnetic field data taken by the Solar Dynamics Observatory's Helioseismic and Magnetic Imager instrument and [2] X-ray flux data from the Geostationary Operational Environmental Satellite's X-ray Flux instrument. We build a catalog of active regions that either produced both a flare and a CME (the positive class) or simply a flare (the negative class). We then use machine-learning algorithms to [1] determine which features distinguish these two populations, and [2] forecast whether an active region that produces an M- or X-class flare will also produce a CME. We compute the True Skill Statistic, a forecast verification metric, and find that it is a relatively high value of approximately 0.8 plus or minus 0.2. We conclude that a combination of six parameters, which are all intensive in nature, will capture most of the relevant information contained in the photospheric magnetic field.

In this Letter we present a seismological detection of a rising motion of magnetic flux in the shallow convection zone of the Sun, and show estimates of the emerging speed and its decelerating nature. In order to evaluate the speed of subsurface flux that creates an active region, we apply six Fourier filters to the Doppler data of NOAA AR 10488, observed with SOHO/MDI, to detect the reduction of acoustic power at six different depths from -15 to -2 Mm. All the filtered acoustic powers show reductions, up to 2 hours before the magnetic flux first appears at the visible surface. The start times of these reductions show a rising trend with a gradual deceleration. The obtained velocity is first several km s^-1 in a depth range of 15--10 Mm, then ~1.5 km s^-1 at 10-5 Mm, finally ~0.5 km s^-1 at 5-2 Mm. If we assume that the power reduction is actually caused by the magnetic field, the velocity of order of 1 km s^-1 is well in accordance with previous observations and numerical studies. Moreover, the gradual deceleration strongly supports the theoretical model that the emerging flux slows down in the uppermost convection zone before it expands into the atmosphere to build an active region.

Investigating the properties of magnetic flux emergence is one of the most important problems of solar physics. In this study we present a newly developed deep-focus time-distance measurement scheme which is able to detect strong emerging flux events in the deep solar interior, before the flux becomes visible on the surface. We discuss in detail the differences between our method and previous methods, and demonstrate step-by-step how the signal-to-noise (S/N) ratio is increased. The method is based on detection of perturbations in acoustic phase travel times determined from cross-covariances of solar oscillations observed on the surface. We detect strong acoustic travel-time reductions of an order of 12 - 16 seconds at a depth of 42 - 75 Mm. These acoustic anomalies are detected 1 - 2 days before high peaks in the photospheric magnetic flux rate implying that the average emerging speed is 0.3 - 0.6 km/s. The results of this work contribute to our understanding of solar magnetism and benefit space weather forecasting.

We investigate how helioseismic waves that originate from effective point sources interact with a sunspot. These waves are reconstructed from observed stochastic wavefields on the Sun by cross-correlating photospheric Doppler-velocity signals. We select the wave sources at different locations relative to the sunspot, and investigate the p- and f-mode waves separately. The results reveal a complicated picture of waveform perturbations caused by the wave interaction with the sunspot. In particular, it is found that for waves originating from outside of the sunspot, p-mode waves travel across the sunspot with a small amplitude reduction and slightly higher speed, and wave amplitude and phase get mostly restored to the quiet-Sun values after passing the sunspot. The f-mode wave experiences some amplitude reduction passing through the sunspot, and the reduced amplitude is not recovered after that. The wave-propagation speed does not change before encountering the sunspot and inside the sunspot, but the wavefront becomes faster than the reference wave after passing through the sunspot. For waves originating from inside the sunspot umbra, both f- and p-mode waves show significant amplitude reductions and faster speed during all courses of propagation. A comparison of positive and negative time lags of cross-correlation functions shows an apparent asymmetry in the waveform changes for both the f- and p-mode waves. We suggest that the waveform variations of the helioseismic waves interacting with a sunspot found in this article can be used for developing a method of waveform heliotomography, similar to the waveform tomography of the Earth.

The power of solar acoustic waves is reduced inside sunspots mainly due to absorption, emissivity reduction, and local suppression. The coefficients of these power-reduction mechanisms can be determined by comparing time-distance cross-covariances obtained from sunspots and from the quiet Sun. By analyzing 47 active regions observed by SOHO/MDI without using signal filters, we have determined the coefficients of surface absorption, deep absorption, emissivity reduction, and local suppression. The dissipation in the quiet Sun is derived as well. All of the cross-covariances are width corrected to offset the effect of dispersion. We find that absorption is the dominant mechanism of the power deficit in sunspots for short travel distances, but gradually drops to zero at travel distances longer than about 6 degrees. The absorption in sunspot interiors is also significant. The emissivity-reduction coefficient ranges from about 0.44 to 1.00 within the umbra and 0.29 to 0.72 in the sunspot, and accounts for only about 21.5% of the umbra's and 16.5% of the sunspot's total power reduction. Local suppression is nearly constant as a function of travel distance with values of 0.80 and 0.665 for umbrae and whole sunspots respectively, and is the major cause of the power deficit at large travel distances.

The purpose of this work is to image solar far-side active regions using acoustic signals with three skips and improve the quality of existing images. The mapping of far-side active regions was first made possible using the helioseismic holography technique by use of four-skip acoustic signals. The quality of far-side images was later improved with the combination of four- and five-skip signals using the time-distance helioseismology technique. In this work, we explore the possibility of making three-skip far-side images of active regions, and improving the image quality by combining the three-skip images with the images obtained from existing techniques. A new method of combining images is proposed that increases the signal-to-noise ratio and reduces the appearance of spurious features.