We describe the performance of the Boolardy Engineering Test Array (BETA), the prototype for the Australian Square Kilometre Array Pathfinder telescope ASKAP. BETA is the first aperture synthesis radio telescope to use phased array feed technology, giving it the ability to electronically form up to nine dual-polarization beams. We report the methods developed for forming and measuring the beams, and the adaptations that have been made to the traditional calibration and imaging procedures in order to allow BETA to function as a multi-beam aperture synthesis telescope. We describe the commissioning of the instrument and present details of BETA's performance: sensitivity, beam characteristics, polarimetric properties and image quality. We summarise the astronomical science that it has produced and draw lessons from operating BETA that will be relevant to the commissioning and operation of the final ASKAP telescope.

We use observations from the Boolardy Engineering Test Array (BETA) of the Australian Square Kilometre Array Pathfinder (ASKAP) telescope to search for transient radio sources in the field around the intermittent pulsar PSR J1107-5907. The pulsar is thought to switch between an "off" state in which no emission is detectable, a weak state and a strong state. We ran three independent transient detection pipelines on two-minute snapshot images from a 13 hour BETA observation in order to 1) study the emission from the pulsar, 2) search for other transient emission from elsewhere in the image and 3) to compare the results from the different transient detection pipelines. The pulsar was easily detected as a transient source and, over the course of the observations, it switched into the strong state three times giving a typical timescale between the strong emission states of 3.7 hours. After the first switch it remained in the strong state for almost 40 minutes. The other strong states lasted less than 4 minutes. The second state change was confirmed using observations with the Parkes radio telescope. No other transient events were found and we place constraints on the surface density of such events on these timescales. The high sensitivity Parkes observations enabled us to detect individual bright pulses during the weak state and to study the strong state over a wide observing band. We conclude by showing that future transient surveys with ASKAP will have the potential to probe the intermittent pulsar population.

We report the discovery of a new 21-cm HI absorption system using commissioning data from the Boolardy Engineering Test Array of the Australian Square Kilometre Array Pathfinder (ASKAP). Using the 711.5 - 1015.5 MHz band of ASKAP we were able to conduct a blind search for the 21-cm line in a continuous redshift range between $z = 0.4$ and 1.0, which has, until now, remained largely unexplored. The absorption line is detected at $z = 0.44$ towards the GHz-peaked spectrum radio source PKS B1740$-$517 and demonstrates ASKAP's excellent capability for performing a future wide-field survey for HI absorption at these redshifts. Optical spectroscopy and imaging using the Gemini-South telescope indicates that the HI gas is intrinsic to the host galaxy of the radio source. The narrow OIII emission lines show clear double-peaked structure, indicating either large-scale outflow or rotation of the ionized gas. Archival data from the \emph{XMM-Newton} satellite exhibit an absorbed X-ray spectrum that is consistent with a high column density obscuring medium around the active galactic nucleus. The HI absorption profile is complex, with four distinct components ranging in width from 5 to 300 km s$^{-1}$ and fractional depths from 0.2 to 20 per cent. In addition to systemic HI gas, in a circumnuclear disc or ring structure aligned with the radio jet, we find evidence for a possible broad outflow of neutral gas moving at a radial velocity of $v \sim 300$ km s$^{-1}$. We infer that the expanding young radio source ($t_{\rm age} \approx 2500$ yr) is cocooned within a dense medium and may be driving circumnuclear neutral gas in an outflow of $\sim$ 1 $\mathrm{M}_{\odot}$ yr$^{-1}$.

We present HI imaging of the galaxy group IC 1459 carried out with six antennas of the Australian SKA Pathfinder equipped with phased-array feeds. We detect and resolve HI in eleven galaxies down to a column density of $\sim10^{20}$ cm$^{-2}$ inside a ~6 deg$^2$ field and with a resolution of ~1 arcmin on the sky and ~8 km/s in velocity. We present HI images, velocity fields and integrated spectra of all detections, and highlight the discovery of three HI clouds -- two in the proximity of the galaxy IC 5270 and one close to NGC 7418. Each cloud has an HI mass of $10^9$ M$_\odot$ and accounts for ~15% of the HI associated with its host galaxy. Available images at ultraviolet, optical and infrared wavelengths do not reveal any clear stellar counterpart of any of the clouds, suggesting that they are not gas-rich dwarf neighbours of IC 5270 and NGC 7418. Using Parkes data we find evidence of additional extended, low-column-density HI emission around IC 5270, indicating that the clouds are the tip of the iceberg of a larger system of gas surrounding this galaxy. This result adds to the body of evidence on the presence of intra-group gas within the IC 1459 group. Altogether, the HI found outside galaxies in this group amounts to several times $10^9$ M$_\odot$, at least 10% of the HI contained inside galaxies. This suggests a substantial flow of gas in and out of galaxies during the several billion years of the group's evolution.

This paper describes the system architecture of a newly constructed radio telescope - the Boolardy Engineering Test Array, which is a prototype of the Australian Square Kilometre Array Pathfinder telescope. Phased array feed technology is used to form multiple simultaneous beams per antenna, providing astronomers with unprecedented survey speed. The test array described here is a 6-antenna interferometer, fitted with prototype signal processing hardware capable of forming at least 9 dual-polarisation beams simultaneously, allowing several square degrees to be imaged in a single pointed observation. The main purpose of the test array is to develop beamforming and wide-field calibration methods for use with the full telescope, but it will also be capable of limited early science demonstrations.

The Australian Square Kilometre Array Pathfinder (ASKAP) presents a number of challenges in the area of source finding and cataloguing. The data rates and image sizes are very large, and require automated processing in a high-performance computing environment. This requires development of new tools, that are able to operate in such an environment and can reliably handle large datasets. These tools must also be able to accommodate the different types of observations ASKAP will make: continuum imaging, spectral-line imaging, transient imaging. The ASKAP project has developed a source-finder known as Selavy, built upon the Duchamp source-finder (Whiting 2012). Selavy incorporates a number of new features, which we describe here. Since distributed processing of large images and cubes will be essential, we describe the algorithms used to distribute the data, find an appropriate threshold and search to that threshold and form the final source catalogue. We describe the algorithm used to define a varying threshold that responds to the local, rather than global, noise conditions, and provide examples of its use. And we discuss the approach used to apply two-dimensional fits to detected sources, enabling more accurate parameterisation. These new features are compared for timing performance, where we show that their impact on the pipeline processing will be small, providing room for enhanced algorithms. We also discuss the development process for ASKAP source finding software. By the time of ASKAP operations, the ASKAP science community, through the Survey Science Projects, will have contributed important elements of the source finding pipeline, and the mechanisms in which this will be done are presented.

Wide-field radio interferometric telescopes such as the Square Kilometre Array now being designed are subject to a number of aberrations. One particularly pernicious aberration is that due to non-coplanar baselines whereby long baselines incur a quadratic image-plane phase error. There are numerous algorithms for dealing with the non-coplanar baselines effect. As a result of our experience with developing processing software for the Australian Square Kilometre Array Pathfinder, we advocate the use of a hybrid algorithm, called w snapshots, based on a combination of w projection and snapshot imaging. This hybrid overcomes some of the deficiencies of each and has advantages from both. Compared to pure w projection, w snapshots uses less memory and execution time, and compared to pure snapshot imaging, w snapshots uses less memory and is more accurate. At the asymptotes, w snapshots devolves to w projection and to snapshots.