sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Hoover, Andrew S.

Normalized to: Hoover, A.

5 article(s) in total. 63 co-authors, from 1 to 3 common article(s). Median position in authors list is 10,0.

[1]  oai:arXiv.org:1212.1738  [pdf] - 600827
Filters for High Rate Pulse Processing
Comments: 5 pages, 6 figures, 1 table
Submitted: 2012-12-07
We introduce a filter-construction method for pulse processing that differs in two respects from that in standard optimal filtering, in which the average pulse shape and noise-power spectral density are combined to create a convolution filter for estimating pulse heights. First, the proposed filters are computed in the time domain, to avoid periodicity artifacts of the discrete Fourier transform, and second, orthogonality constraints are imposed on the filters, to reduce the filtering procedure's sensitivity to unknown baseline height and pulse tails. We analyze the proposed filters, predicting energy resolution under several scenarios, and apply the filters to high-rate pulse data from gamma-rays measured by a transition-edge-sensor microcalorimeter.
[2]  oai:arXiv.org:0908.0450  [pdf] - 1003263
The Fermi Gamma-Ray Burst Monitor
Comments: 36 pages, 18 figures, to be published in Astrophysical Journal
Submitted: 2009-08-04
The Gamma-Ray Burst Monitor (GBM) will significantly augment the science return from the Fermi Observatory in the study of Gamma-Ray Bursts (GRBs). The primary objective of GBM is to extend the energy range over which bursts are observed downward from the energy range of the Large Area Telescope (LAT) on Fermi into the hard X-ray range where extensive previous data exist. A secondary objective is to compute burst locations on-board to allow re-orientiong the spacecraft so that the LAT can observe delayed emission from bright bursts. GBM uses an array of twelve sodium iodide scintillators and two bismuth germanate scintillators to detect gamma rays from ~8 keV to ~40 MeV over the full unocculted sky. The on-board trigger threshold is ~0.7 photons/cm2/s (50-300 keV, 1 s peak). GBM generates on-board triggers for ~250 GRBs per year.
[3]  oai:arXiv.org:0812.2908  [pdf] - 19533
Ground-based calibration and characterization of the Fermi Gamma-Ray Burst Monitor Detectors
Comments: 36 pages, 28 figures, accepted for publication in Experimental Astronomy
Submitted: 2008-12-16
One of the scientific objectives of NASA's Fermi Gamma-ray Space Telescope is the study of Gamma-Ray Bursts (GRBs). The Fermi Gamma-Ray Burst Monitor (GBM) was designed to detect and localize bursts for the Fermi mission. By means of an array of 12 NaI(Tl) (8 keV to 1 MeV) and two BGO (0.2 to 40 MeV) scintillation detectors, GBM extends the energy range (20 MeV to > 300 GeV) of Fermi's main instrument, the Large Area Telescope, into the traditional range of current GRB databases. The physical detector response of the GBM instrument to GRBs is determined with the help of Monte Carlo simulations, which are supported and verified by on-ground individual detector calibration measurements. We present the principal instrument properties, which have been determined as a function of energy and angle, including the channel-energy relation, the energy resolution, the effective area and the spatial homogeneity.
[4]  oai:arXiv.org:astro-ph/0608532  [pdf] - 1938972
The Advanced Compton Telescope Mission
Comments: NASA Vision Mission Concept Study Report, final version. (A condensed version of this report has been submitted to AIAA.)
Submitted: 2006-08-24
The Advanced Compton Telescope (ACT), the next major step in gamma-ray astronomy, will probe the fires where chemical elements are formed by enabling high-resolution spectroscopy of nuclear emission from supernova explosions. During the past two years, our collaboration has been undertaking a NASA mission concept study for ACT. This study was designed to (1) transform the key scientific objectives into specific instrument requirements, (2) to identify the most promising technologies to meet those requirements, and (3) to design a viable mission concept for this instrument. We present the results of this study, including scientific goals and expected performance, mission design, and technology recommendations.
[5]  oai:arXiv.org:astro-ph/0407144  [pdf] - 65986
The GLAST Burst Monitor
Comments: 8 pages, 7 figures, to appear in SPIE conference proceedings vol 5488, "UV-Gamma Ray Space Telescope Systems," Glasgow UK, 21-24 June 2004
Submitted: 2004-07-07
The next large NASA mission in the field of gamma-ray astronomy, GLAST, is scheduled for launch in 2007. Aside from the main instrument LAT (Large-Area Telescope), a gamma-ray telescope for the energy range between 20 MeV and > 100 GeV, a secondary instrument, the GLAST burst monitor (GBM), is foreseen. With this monitor one of the key scientific objectives of the mission, the determination of the high-energy behaviour of gamma-ray bursts and transients can be ensured. Its task is to increase the detection rate of gamma-ray bursts for the LAT and to extend the energy range to lower energies (from ~10 keV to \~30 MeV). It will provide real-time burst locations over a wide FoV with sufficient accuracy to allow repointing the GLAST spacecraft. Time-resolved spectra of many bursts recorded with LAT and the burst monitor will allow the investigation of the relation between the keV and the MeV-GeV emission from GRBs over unprecedented seven decades of energy. This will help to advance our understanding of the mechanisms by which gamma-rays are generated in gamma-ray bursts.