Ultraviolet over-ionisation of iron atoms in the solar atmosphere leads to deviations in their level populations from the Saha-Boltzmann statistics. This causes their line profiles to form in Non-Local Thermodynamic Equilibrium (NLTE) conditions. While inverting such profiles to determine atmospheric parameters, the NLTE effects are often neglected and deviations from LTE are compensated for by tweaking other quantities. We investigate how the routinely employed LTE inversion of iron lines formed in NLTE under- or over-estimates atmospheric quantities such as temperature (T), line-of-sight velocity (v_LOS), magnetic field strength (B) and inclination (gamma) while the previous papers have focused mainly on T. We synthesize the Stokes profiles of Fe I 6301.5 A and 6302.5 A lines in both LTE and NLTE using a snapshot of a 3D MHD simulation. The profiles are then inverted in LTE. By considering the atmosphere inferred from inversion of LTE profiles to be the fiducial model, we compare atmosphere from the inversion of NLTE profiles with it. Any differences observed are attributed to NLTE effects. Neglecting the NLTE effects introduces errors in the inverted atmosphere. While the errors in T can go up to 13%, in v_LOS and B the errors can be as high as 50% or more. We find these errors to be present at all three inversion nodes. Importantly, they survive degradation from spatial averaging of the profiles. We give an overview of how the neglect of NLTE effects influences the values of T, v_LOS, B and gamma determined by inverting Fe I 6300 A line pair, as observed, e.g., by Hinode. Errors are found at the sites of granules, intergranular lanes, magnetic elements, basically in every region susceptible to NLTE effects. For an accurate determination of atmospheric quantities and their stratification, it is therefore important to take account of NLTE effects.

Non-local thermodynamic equilibrium (NLTE) effects in diagnostically important solar Fe I lines are important due to the strong sensitivity of Fe I to ionizing UV radiation, which may lead to a considerable under-population of the Fe I levels in the solar atmosphere and, therefore, to a sizeable weakening of Fe I lines. Such NLTE effects may be intensified or weakened by horizontal radiative transfer (RT) in a three-dimensionally (3-D) structured atmosphere. We analyze the influence of horizontal RT on commonly used Fe I lines in a snapshot of a 3-D radiation magneto-hydrodynamic (MHD) simulation of a plage region. NLTE- and horizontal RT effects occur with considerable strength (up to 50% in line depth or equivalent width) in the analyzed snapshot. As they may have either sign and both signs occur with approximately the same frequency and strength, the net effects are small when considering spatially averaged quantities. The situation in the plage atmosphere turns out to be rather complex. Horizontal transfer leads to line-weakening relative to 1-D NLTE transfer near the boundaries of kG magnetic elements. Around the centers of these elements, however, we find an often significant line-strengthening. This behavior is in contrast to that expected from previous 3-D RT computations in idealized flux-tube models, which display only a line weakening. The origin of this unexpected behavior lies in the fact that magnetic elements are surrounded by dense and relatively cool down-flowing gas, which forms the walls of the magnetic elements. The continuum in these dense walls is often formed in colder gas than in the central part of the magnetic elements. Consequently, the central parts of the magnetic element experience a sub-average UV-irradiation leading to the observed 3-D NLTE line strengthening.

We investigate the effects of horizontal radiative transfer (RT) a NLTE on important diagnostic iron lines in a realistic 3-D HD simulation. Using a multi-level atom we compute and compare widely used Fe I line profiles at 3 different levels of approximation (3-D NLTE, 1-D NLTE, LTE). We find that the influence of horizontal RT is of the same order of magnitude as that of NLTE, although spatially more localized. Also, depending on the temperature of the surroundings, horizontal RT is found to weaken or strengthen spectral lines. Line depths and equivalent width may differ by up to 20% against the corresponding LTE value if 3-D RT is applied. Residual intensity contrasts in LTE are found to be larger than those in 3-D NLTE by up to a factor of two. When compared to 1-D NLTE, we find that horizontal RT weakens the contrast by up to 30% almost independently of the angle of line of sight. While the CLV of the 1-D and 3-D NLTE contrasts are of similar form, the LTE contrast CLV shows a different run. The determination of temperatures by 1-D NLTE inversions of spatially resolved observations may produce errors of up to 200 K if one neglects 3-D RT. We find a linear correlation between the intensity difference of 1-D and 3-D NLTE and a simple estimate of the temperature in the horizontal environment of the line formation region. This correlation could be used to coarsely correct for the effects of horizontal RT in inversions done in 1-D NLTE. Horizontal RT is less important if one considers spatially averaged line profiles because local line strengthening and weakening occur with similar frequency in our HD atmosphere. Thus, the iron abundance is underestimated by 0.012 dex if calculated using 1-D NLTE RT. Since effects of horizontal RT are largest for spatially resolved quantities, the use of 3-D RT is particularly important for the interpretation of high spatial resolution observations.

In network and active region plages, the magnetic field is concentrated into structures often described as flux tubes (FTs) and sheets (FSs). 3-D radiative transfer (RT) is important for energy transport in these concentrations. It is also expected to be important for diagnostic purposes but has rarely been applied for that purpose. Using true 3-D, non-LTE (NLTE) RT in FT/FS models, we compute Fe line profiles commonly used to diagnose the Sun's magnetic field by comparing the results with those obtained from LTE/1-D (1.5-D) NLTE calculations. Employing a multilevel iron atom, we study the influence of basic parameters such as Wilson depression, wall thickness, radius/width, thermal stratification or magnetic field strength on all Stokes $I$ parameters in the thin-tube approximation. The use of different levels of approximations of RT may lead to considerable differences in profile shapes, intensity contrasts, equivalent widths, and the determination of magnetic field strengths. In particular, LTE, which often provides a good approach in planar 1-D atmospheres, is a poor approximation in our flux sheet model for some of the most important diagnostic Fe I lines (524.7nm, 525.0nm, 630.1nm, and 630.2nm). The observed effects depend on parameters such as the height of line formation, field strength, and internal temperature stratification. Differences between the profile shapes may lead to errors in the determination of magnetic fields on the order of 10 to 20%, while errors in the determined temperature can reach 300-400K. The empirical FT models NET and PLA turn out to minimize the effects of 3D RT, so that results obtained with these models by applying LTE may also remain valid for 3-D NLTE calculations. Finally, horizontal RT is found to only insignificantly smear out structures such as the optically thick walls of FTs and FSs, allowing features as narrow as 10km to remain visible.

Chromospheric magnetic fields are notoriously diffcult to measure. The chromospheric lines are broad, while the fields are producing a minuscule Zeeman-effect polarization. A promising diagnostic alternative is provided by the forward-scattering Hanle effect, which can be recorded in chromospheric lines such as the He i 10830 {\AA} and the Ca i 4227 {\AA} lines. We present a set of spectropolarimetric observations of the full Stokes vector obtained near the center of the solar disk in the Ca i 4227 {\AA} line with the ZIMPOL polarimeter at the IRSOL observatory.We detect a number of interesting forward-scattering Hanle effect signatures, which we model successfully using polarized radiative transfer. Here we focus on the observational aspects, while a separate companion paper deals with the theoretical modeling.