The EXoplanetary Circumstellar Environments and Disk Explorer (EXCEDE) science mission concept uses a visible-wavelength Phase-Induced Amplitude Apodization (PIAA) coronagraph to enable high-contrast imaging of circumstellar debris systems and some giant planets at angular separations reaching into the habitable zones of some of the nearest stars. We report on the experimental results obtained in the vacuum chamber at the Lockheed Martin Advanced Technology Center in 10% broadband light centered about 650 nm, with a median contrast of $1 \times 10^{-5}$ between 1.2 and 2.0 $\lambda$/D simultaneously with $3 \times 10^{-7}$ contrast between 2 and 11 $\lambda/D$ for a single-sided dark hole using a deformable mirror (DM) upstream of the PIAA coronagraph. These results are stable and repeatable as demonstrated by three measurements runs with DM settings set from scratch and maintained on the best 90% out of the 1000 collected frames. We compare the reduced experimental data with simulation results from modeling observed experimental limits; observed performance is consistent with uncorrected low-order modes not estimated by the Low Order Wavefront Sensor (LOWFS). Modeled sensitivity to bandwidth and residual tip/tilt modes is well-matched to the experiment.

This paper is the third in the series on the technology development for the EXCEDE (EXoplanetary Circumstellar Environments and Disk Explorer) mission concept, which in 2011 was selected by NASA's Explorer program for technology development (Category III). EXCEDE is a 0.7m space telescope concept designed to achieve raw contrasts of 1e6 at an inner working angle of 1.2 l/D and 1e7 at 2 l/D and beyond. This will allow it to directly detect and spatially resolve low surface brightness circumstellar debris disks as well as image giant planets as close as in the habitable zones of their host stars. In addition to doing fundamental science on debris disks, EXCEDE will also serve as a technological and scientific precursor for any future exo-Earth imaging mission. EXCEDE uses a Starlight Suppression System (SSS) based on the PIAA coronagraph, enabling aggressive performance. We report on our continuing progress of developing the SSS for EXCEDE, and in particular (a) the reconfiguration of our system into a more flight-like layout, with an upstream deformable mirror and an inverse PIAA system, as well as a LOWFS, and (b) testing this system in a vacuum chamber, including IWA, contrast, and stability performance. The results achieved so far are 2.9e-7 contrast between 1.2-2.0 l/D and 9.7e-8 contrast between 2.0-6.0 l/D in monochromatic light; as well as 1.4e-6 between 2.0-6.0 l/D in a 10% band, all with a PIAA coronagraph operating at an inner working angle of 1.2 l/D. This constitutes better contrast than EXCEDE requirements (in those regions) in monochromatic light, and progress towards requirements in broadband light. Even though this technology development is primarily targeted towards EXCEDE, it is also germane to any exoplanet direct imaging space-based telescopes because of the many challenges common to different coronagraph architectures and mission requirements.