In the upcoming decade cadenced wide-field imaging surveys will increase the number of identified $z<0.3$ Type~Ia supernovae (SNe~Ia) from the hundreds to the hundreds of thousands. The increase in the number density and solid-angle coverage of SNe~Ia, in parallel with improvements in the standardization of their absolute magnitudes, now make them competitive probes of the growth of structure and hence of gravity. The peculiar velocity power spectrum is sensitive to the growth index $\gamma$, which captures the effect of gravity on the linear growth of structure through the relation $f=\Omega_M^\gamma$. We present the first projections for the precision in $\gamma$ for a range of realistic SN peculiar-velocity survey scenarios. In the next decade the peculiar velocities of SNe~Ia in the local $z<0.3$ Universe will provide a measure of $\gamma$ to $\pm 0.01$ precision that can definitively distinguish between General Relativity and leading models of alternative gravity.

A Si(Li) detector fabrication procedure has been developed with the aim of satisfying the unique requirements of the GAPS (General Antiparticle Spectrometer) experiment. Si(Li) detectors are particularly well-suited to the GAPS detection scheme, in which several planes of detectors act as the target to slow and capture an incoming antiparticle into an exotic atom, as well as the spectrometer and tracker to measure the resulting decay X-rays and annihilation products. These detectors must provide the absorption depth, energy resolution, tracking efficiency, and active area necessary for this technique, all within the significant temperature, power, and cost constraints of an Antarctic long-duration balloon flight. We report here on the fabrication and performance of prototype 2"-diameter, 1-1.25 mm-thick, single-strip Si(Li) detectors that provide the necessary X-ray energy resolution of $\sim$4 keV for a cost per unit area that is far below that of previously-acquired commercial detectors. This fabrication procedure is currently being optimized for the 4"-diameter, 2.5 mm-thick, multi-strip geometry that will be used for the GAPS flight detectors.