sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Gormaz-Matamala, Alex C.

Normalized to: Gormaz-Matamala, A.

4 article(s) in total. 21 co-authors, from 1 to 2 common article(s). Median position in authors list is 3,5.

[1]  oai:arXiv.org:2002.07580  [pdf] - 2050521
Evolution of Line-Force Multiplier Parameters in Radiation Driven Winds of Massive Stars
Comments:
Submitted: 2020-02-18
We present two self-consistent procedures that couple the hydrodynamics with calculations of the line-force in the frame of radiation wind theory. These procedures give us the line-force parameters, the velocity field, and the mass-loss rate. The first one is based on the so-called m-CAK theory. A full set of line-force parameters for $T_\text{eff}\ge 32,000$ K and surface gravities higher than 3.4 dex for two different metallicities are presented, along with their corresponding wind parameters. We find that the dependence of line-force parameters on effective temperature is enhanced by the dependence on $\log g$. For the case of homogeneous winds (without clumping) comparison of self-consistent mass-loss rates shows a good agreement with empirical values. We also consider self-consistent wind solutions that are used as input in FASTWIND to calculate synthetic spectra. By comparison with the observed spectra for three stars with clumped winds, we found that varying the clumping factor the synthetic spectra rapidly converge into the neighbourhood region of the solution. Therefore, this self-consistent m-CAK procedure significantly reduces the number of free parameters needed to obtain a synthetic spectrum. The second procedure (called Lambert-procedure) provides a self-consistent solution beyond m-CAK theory, and line-acceleration is calculated by the full NLTE radiative transfer code CMFGEN. Both the mass-loss rate and the clumping factor are set as free parameters, hence their values are obtained by spectral fitting after the respective self-consistent hydrodynamics is calculated. Since performing the Lambert-procedure requires significant computational power, the analysis is made only for the star z-Puppis. The promising results gives a positive balance about the future applications for the self-consistent solutions presented on this thesis.
[2]  oai:arXiv.org:1903.00417  [pdf] - 1851728
Self-consistent solutions for line-driven winds of hot massive stars. The m-CAK procedure
Comments:
Submitted: 2019-03-01
Massive stars present strong stellar that which are described by the radiation driven wind theory. Accurate mass-loss rates are necessary to properly describe the stellar evolution across the Hertzsprung--Russel Diagram. We present a self-consistent procedure that coupled the hydrodynamics with calculations of the line-force, giving as results the line-force parameters, the velocity field, and the mass-loss rate. Our calculations contemplate the contribution to the line-force multiplier from more than $\sim 900,000$ atomic transitions, an NLTE radiation flux from the photosphere and a quasi-LTE approximation for the occupational numbers. A full set of line-force parameters for $T_\text{eff}\ge 32,000$ K, surface gravities higher than 3.4 dex for two different metallicities are presented, with their corresponding wind parameters (terminal velocities and mass-loss rates). The already known dependence of line-force parameters on effective temperature is enhanced by the dependence on $\log g$. The terminal velocities present a stepper scaling relation with respect to the escape velocity, this might explain the scatter values observed in the hot side of the bistability jump. Moreover, a comparison of self-consistent mass-loss rates with empirical values shows a good agreement. Self-consistent wind solutions are used as input in FASTWIND to calculate synthetic spectra. We show, comparing with the observed spectra for three stars, that varying the clumping factor, the synthetic spectra rapidly converge into the neighbourhood region of the solution. It is important to stress that our self-consistent procedure significantly reduces the number of free parameters needed to obtain a synthetic spectrum.
[3]  oai:arXiv.org:1401.0014  [pdf] - 1202485
Deriving Metallicities from Calcium Triplet Spectroscopy in combination with Near Infrared Photometry
Comments: 41 pages, 8 tables, 42 figures A&A: recommended publication after revision
Submitted: 2013-12-30
Context. [...] One of the most efficient methods is the measurement of the equivalent width (EW) of the Calcium II Triplet (CaT), corrected for the luminosity and temperature effects via magnitude differences from the horizontal branch (HB). Methods. We use the Ks magnitude difference between the star and the reddest part of the HB (RHB) to generate reduced equivalent widths (rEW) from the datasets presented in Saviane et al. (2012) and Rutledge et al. (1997). Subsequently we calibrated these rEW against three different metellicity (met) scales: the one presented in Carretta et al. (2009), the met values given in Harris (2010) and a version of the former corrected via high-resolution spectroscopic met. Results. We calculated the calibration relations for the two datasets and the three met scales and found that they are approximately equivalent, with differences almost negligible. We compared our nIR calibrations with the corresponding optical ones, and found them to be equivalent, establishing that the luminosity-corrected rEW using the Ks magnitude is compatible with the one obtained from the V magnitude. We then used the met obtained from the calibration to investigate the internal met distributions of the GCs. Conclusions. We have established that the ([Fe/H]:rEW) relation is independent from the mag used for the luminosity correction and find that the calibration relations only change slightly for different met scales. The CaT technique using NIR photometry is thus a powerful tool to derive met. In particular, it can be used to study the internal met spread of a GC. We confirm the presence of at least two met populations in NGC 6656 and find that several other GCs present peculiar met distributions.
[4]  oai:arXiv.org:1311.0760  [pdf] - 1180458
Investigating potential planetary nebula/cluster pairs
Comments: Accepted for publication in A&A
Submitted: 2013-11-04, last modified: 2013-12-16
Fundamental parameters characterizing the end-state of intermediate-mass stars may be constrained by discovering planetary nebulae (PNe) in open clusters (OCs). Cluster membership may be exploited to establish the distance, luminosity, age, and physical size for PNe, and the intrinsic luminosity and mass of its central star. Four potential PN-OC associations were investigated, to assess the cluster membership for the PNe. Radial velocities were measured from intermediate-resolution optical spectra, complemented with previous estimates in the literature. When the radial velocity study supported the PN/OC association, we analyzed if other parameters (e.g., age, distance, reddening, central star brightness) were consistent with this conclusion. Our measurements imply that the PNe VBe3 and HeFa1 are not members of the OCs NGC5999 and NGC6067, respectively, and likely belong to the background bulge population. Conversely, consistent radial velocities indicate that NGC2452/NGC2453 could be associated, but our results are not conclusive and additional observations are warranted. Finally, we demonstrate that all the available information point to He2-86 being a young, highly internally obscured PN member of NGC4463. New near-infrared photometry acquired via the Vista Variables in the Via Lactea ESO public survey was used in tandem with existing UBV photometry to measure the distance, reddening, and age of NGC4463, finding d=1.55+-0.10 kpc, E(B-V)=0.41+-0.02, and tau=65+-10 Myr, respectively. The same values should be adopted for the PN if the proposed cluster membership will be confirmed.