Context. The water snowline divides dry and icy solid material in protoplanetary disks, and has been thought to significantly affect planet formation at all stages. If dry particles break up more easily than icy ones, then the snowline causes a traffic jam, because small grains drift inward at lower speeds than larger pebbles. Aims. We aim to evaluate the effect of high dust concentrations around the snowline onto the gas dynamics. Methods. Using numerical simulations, we model the global radial evolution of an axisymmetric protoplanetary disk. Our model includes particle growth, evaporation and recondensation of water, and the back-reaction of dust onto the gas, taking into account the vertical distribution of dust particles. Results. We find that the dust back-reaction can stop and even reverse the net flux of gas outside the snowline, decreasing the gas accretion rate onto the star to under $50\%$ of its initial value. At the same time the dust accumulates at the snowline, reaching dust-to-gas ratios of $\epsilon \gtrsim 0.8$, and delivers large amounts of water vapor towards the inner disk, as the icy particles cross the snowline. However, the accumulation of dust at the snowline and the decrease in the gas accretion rate only take place if the global dust-to-gas ratio is high ($\varepsilon_0 \gtrsim 0.03$), if the viscous turbulence is low ($\alpha_\nu \lesssim 10^{-3} $), if the disk is large enough ($r_c \gtrsim 100\, \textrm{au}$), and only during the early phases of the disk evolution ($t \lesssim 1\, \textrm{Myr}$). Otherwise the dust back-reaction fails to perturb the gas motion.

RW Aur A has experienced various dimming events in the last years, decreasing its brightness by $\sim 2\ \textrm{mag}$ for periods of months to years. Multiple observations indicate that a high concentration of dust grains, from the protoplanetary disk's inner regions, is blocking the starlight during these events. We propose a new mechanism that can send large amounts of dust close to the star on short timescales, through the reactivation of a dead zone in the protoplanetary disk. Using numerical simulations we model the accretion of gas and dust, along with the growth and fragmentation of particles in this scenario. We find that after the reactivation of the dead zone, the accumulated dust is rapidly accreted towards the star in around 15 years, at rates of $\dot{M}_\textrm{d} = 6 \times 10^{-6}\, \textrm{M}_\odot/\textrm{yr}$ and reaching dust-to-gas ratios of $\epsilon \approx 5$, preceding an increase in the gas accretion by a few years. This sudden rise of dust accretion can provide the material required for the dimmings, although the question of how to put the dust into the line of sight remains open to speculation.

Planets form in discs of gas and dust around stars, and keep growing by accretion of disc material while available. Massive planets clear a gap in that protoplanetary disc, but still accrete through spiral wakes. On its way to the planet, the gas will settle on a \emph{circumplanetary} disc around the planet and slowly accrete on to it. The energy of the accreted gas will be released, heating the planet surroundings in a feedback process. For high enough accretion rates the planet should be detectable at infrared wavelengths. We aim to find whether detectable planet luminosities, $\gtrsim 10^{-3} \, \textrm{L}_\odot$, can occur when considering that the planet luminosity is coupled to the accretion, and also to study which other effects has the feedback on the dynamics of the circumplanetary and the gap regions. We model a planet with mass ratio $q=10^{-3}$, orbiting at 10 AU from a solar mass star, using a modified version of the 2D code FARGO-AD, which includes a prescription for the accretion and feedback luminosity of the planet. We find that the planetary feedback is able to partially deplete the circumplanetary disc, and to reduce the accretion rate onto the planet. However, detectable luminosities of $L_\textrm{p}\gtrsim 10^{-3}\, \textrm{L}_\odot$ are still produced. The feedback also contributes to partially refilling the gap, to heat up the coorbital region, and to perturb the orbital velocity of the gas.

Context: In the last six years, the VVV survey mapped 562 sq. deg. across the bulge and southern disk of the Galaxy. However, a detailed study of these regions, which includes $\sim 36$ globular clusters (GCs) and thousands of open clusters is by no means an easy challenge. High differential reddening and severe crowding along the line of sight makes highly hamper to reliably distinguish stars belonging to different populations and/or systems. Aims: The aim of this study is to separate stars that likely belong to the Galactic GC NGC 6544 from its surrounding field by means of proper motion (PM) techniques. Methods: This work was based upon a new astrometric reduction method optimized for images of the VVV survey. Results: Photometry over the six years baseline of the survey allowed us to obtain a mean precision of $\sim0.51$ mas/yr, in each PM coordinate, for stars with Ks < 15 mag. In the area studied here, cluster stars separate very well from field stars, down to the main sequence turnoff and below, allowing us to derive for the first time the absolute PM of NGC 6544. Isochrone fitting on the clean and differential reddening corrected cluster color magnitude diagram yields an age of $\sim$ 11-13 Gyr, and metallicity [Fe/H] = -1.5 dex, in agreement with previous studies restricted to the cluster core. We were able to derive the cluster orbit assuming an axisymmetric model of the Galaxy and conclude that NGC 6544 is likely a halo GC. We have not detected tidal tail signatures associated to the cluster, but a remarkable elongation in the galactic center direction has been found. The precision achieved in the PM determination also allows us to separate bulge stars from foreground disk stars, enabling the kinematical selection of bona fide bulge stars across the whole survey area. Our results show that VVV data is perfectly suitable for this kind of analysis.

The growth of computational astrophysics and complexity of multidimensional datasets evidences the need for new versatile visualization tools for both analysis and presentation of the data. In this work we show how to use the open source software Blender as a 3D visualization tool to study and visualize numerical simulation results, focusing on astrophysical hydrodynamic experiments. With a datacube as input, the software can generate a volume rendering of the 3D data, show the evolution of a simulation in time, and do a fly-around camera animation to highlight the points of interest. We explain the process to import simulation outputs into Blender using the Voxel Data format, and how to set up a visualization scene in the software interface. This method allows scientists to perform a complementary visual analysis of their data, and display their results in an appealing way, both for outreach and science presentations.