The profile of the differential rotation together with the sign of the alpha-effect determine the dynamo wave direction. In early models of the solar dynamo the dynamo wave often leads to a poleward migration of the activity belts. Flux transport by the meridional flow or the effect of the surface shear layer are possible solutions. In a model including the corona, we show that various migrations can be obtained by varying the properties of the corona. A new dynamo of Babcock-Leighton type also leads to the correct equatorward migration by the non-linear relation between flux density and rise time of the flux.

Context. Solar dynamo models of Babcock-Leighton type typically assume the rise of magnetic flux tubes to be instantaneous. Solutions with high-magnetic-diffusivity have too short periods and a wrong migration of their active belts. Only the low-diffusivity regime with advective meridional flows is usually considered. Aims. In the present paper we discuss these assumptions and applied a time delay in the source term of the azimuthally averaged induction equation. This delay is set to be the rise time of magnetic flux tubes which supposedly form at the tachocline. We study the effect of the delay, which adds to the spacial non-locality a non-linear temporal one, in the advective but particularly in the diffusive regime. Methods. Fournier et al. (2017) obtained the rise time according to stellar parameters such as rotation, and the magnetic field strength at the bottom of the convection zone. These results allowed us to constrain the delay in the mean-field model used in a parameter study. Results. We identify an unknown family of solutions. These solutions self-quench, and exhibit longer periods than their non-delayed counterparts. Additionally, we demonstrate that the non-linear delay is responsible for the recover of the equatorward migration of the active belts at high turbulent diffusivities. Conclusions. By introducing a non-linear temporal non-locality (the delay) in a Babcock-Leighton dynamo model, we could obtain solutions quantitatively comparable to the solar butterfly diagram in the diffusion-dominated regime.

Context: Long-term variability in solar cycles represents a challenging constraint for theoretical models. Mean-field Babcock-Leighton dynamos that consider non-instantaneous rising flux tubes have been shown to exhibit long-term variability in their magnetic cycle. However a relation that parameterizes the rise-time of non-axisymmetric magnetic flux tubes in terms of stellar parameters is still missing. Aims: We aim to find a general parameterization of the rise-time of magnetic flux tubes for solar-like stars. Methods: By considering the influence of magnetic tension on the rise of non-axisymmetric flux tubes, we predict the existence of a control parameter referred as $\Gamma_{\alpha_1}^{\alpha_2}$. This parameter is a measure of the balance between rotational effects and magnetic effects (buoyancy and tension) acting on the magnetic flux tube. We carry out two series of numerical experiments (one for axisymmetric rise and one for non-axisymmetric rise) and demonstrate that $\Gamma_{\alpha_1}^{\alpha_2}$ indeed controls the rise-time of magnetic flux tubes. Results: We find that the rise-time follows a power law of $\Gamma_{\alpha_1}^{\alpha_2}$ with an exponent that depends on the azimuthal wavenumber of the magnetic flux loop. Conclusions: Compressibility does not impact the rise of magnetic flux tubes, while non-axisymmetry does. In the case of non-axisymmetric rise, the tension force modifies the force balance acting on the magnetic flux tube. We identified the three independent parameters required to predict the rise-time of magnetic flux tubes, that is, the stellar rotation rate, the magnetic flux density of the flux tube, and its azimuthal wavenumber. We combined these into one single relation that is valid for any solar-like star. We suggest using this generalized relation to constrain the rise-time of magnetic flux tubes in Babcock-Leighton dynamo models.