Data acquired at Ceres by the visible channel of the Visible and InfraRed mapping spectrometer (VIR) on board the NASA Dawn spacecraft are affected by the temperatures of both the visible (VIS) and the infrared (IR) sensors, which are respectively a CCD and a HgCdTe array. The variations of the visible channel temperatures measured during the sessions of acquisitions are correlated with variations in the spectral slope and shape for all the mission phases. The infrared channel (IR) temperature is more stable during the acquisitions, nonetheless it is characterized by a bi-modal distribution whether the cryocooler (and therefore the IR channel) is used or not during the visible channel operations. When the infrared channel temperature is high (175K, i.e. not in use and with crycooler off), an additional negative slope and a distortion are observed in the spectra of the visible channel. We developed an empirical correction based on a reference spectrum for the whole data set; it is designed to correct the two issues related to the sensor temperatures that we have identified. The reference spectrum is calculated to be representative of the global Ceres' surface. It is also made of data acquired when the visible and infrared channel temperatures are equal to the ones measured during an observation of the Arcturus star by VIR, which is consistent with several ground-based observations. The developed correction allows reliable analysis and mapping to be performed by minimizing the artifacts induced by fluctuations of the VIS temperature. Thanks to this correction, a direct comparison between different mission phases during which VIR experienced different visible and infrared channel temperatures is now possible.

We study the spectrophotometric properties of dwarf planet Ceres in the VIS-IR spectral range by means of hyper-spectral images acquired by the VIR imaging spectrometer on board the NASA Dawn mission. Disk-resolved observations with a phase angle within the $7^{\circ}<\alpha<132^{\circ}$ interval were used to characterize Ceres' phase curve in the 0.465-4.05 $\mu$m spectral range. Hapke's model was applied to perform the photometric correction of the dataset, allowing us to produce albedo and color maps of the surface. The $V$-band magnitude phase function of Ceres was fitted with both the classical linear model and H-G formalism. The single-scattering albedo and the asymmetry parameter at 0.55$\mu$m are $w=0.14\pm0.02$ and $\xi=-0.11\pm0.08$, respectively (two-lobe Henyey-Greenstein phase function); the modeled geometric albedo is $0.094\pm0.007$; the roughness parameter is $\bar{\theta}=29^{\circ}\pm6^{\circ}$. Albedo maps indicate small variability on a global scale with an average reflectance of $0.034 \pm 0.003$. Isolated areas such as the Occator bright spots, Haulani, and Oxo show an albedo much higher than average. We measure a significant spectral phase reddening, and the average spectral slope of Ceres' surface after photometric correction is $1.1\%k\AA^{-1}$ and $0.85\%k\AA^{-1}$ at VIS and IR wavelengths, respectively. Broadband color indices are $V-R=0.38\pm0.01$ and $R-I=0.33\pm0.02$. H-G modeling of the $V$-band magnitude phase curve for $\alpha<30^{\circ}$ gives $H=3.14\pm0.04$ and $G=0.10\pm0.04$, while the classical linear model provides $V(1,1,0^{\circ})=3.48\pm0.03$ and $\beta=0.036\pm0.002$. The comparison with spectrophotometric properties of other minor bodies indicates that Ceres has a less back-scattering phase function and a slightly higher albedo than comets and C-type objects. However, the latter represents the closest match in the usual asteroid taxonomy.

Planetary sciences can benefit from several different sources of information, i.e. ground-based or near Earth-based observations, space missions and laboratory experiments. The data collected from these sources, however, are spread over a number of smaller, separate communities and stored through different facilities: this makes it difficult to integrate them. The IDIS initiative, born in the context of the Europlanet project, performed a pilot study of the viability and the issues to be overcome in order to create an integrated search system for planetary data. As part of the results of such pilot study, the IDIS Small Bodies and Dust node developed a search system based on a preliminary XML data model. Here we introduce the goals of the IDIS initiative and describe the structure and the working of this search system. The source code of the search system is released under GPL license to allow people interested in participating to the IDIS initiative both as developers and as data providers to familiarise with the search environment and to allow the creation of volunteer nodes to be integrated into the existing network.