Running hydrodynamical simulations to produce mock data of large-scale structure and baryonic probes, such as the thermal Sunyaev-Zeldovich (tSZ) effect, at cosmological scales is computationally challenging. We propose to leverage the expressive power of deep generative models to find an effective description of the large-scale gas distribution and temperature. We train two deep generative models, a variational auto-encoder and a generative adversarial network, on pairs of matter density and pressure slices from the BAHAMAS hydrodynamical simulation. The trained models are able to successfully map matter density to the corresponding gas pressure. We then apply the trained models on 100 lines-of-sight from SLICS, a suite of N-body simulations optimised for weak lensing covariance estimation, to generate maps of the tSZ effect. The generated tSZ maps are found to be statistically consistent with those from BAHAMAS. We conclude by considering a specific observable, the angular cross-power spectrum between the weak lensing convergence and the tSZ effect and its variance, where we find excellent agreement between the predictions from BAHAMAS and SLICS, thus enabling the use of SLICS for tSZ covariance estimation.

The Burst and Transient Source Experiment (BATSE) aboard CGRO monitored the whole sky through 8 NaI(Tl) crystal scintillators sensitive in the 20 keV - 2 MeV energy band continuously from April 1991 until June 2000. Results are presented on the long term variabilty observed in the brightest Active Galactic Nuclei (AGN) present in the BATSE data archive. This was achieved through the application of the Earth Occultation technique to data flat-fielded using the BATSE Mass Model. Removal of the temporal background variations from the data should allow a more sensitive extraction of source parameters. Analysis of the general trends of the 9-year light curves are also presented.

Intense and complex instrumental backgrounds, against which the much smaller signals from celestial sources have to be discerned, are a notorious problem for low and intermediate energy gamma-ray astronomy (~50 keV - 10 MeV). Therefore a detailed qualitative and quantitative understanding of instrumental line and continuum backgrounds is crucial for most stages of gamma-ray astronomy missions, ranging from the design and development of new instrumentation through performance prediction to data reduction. We have developed MGGPOD, a user-friendly suite of Monte Carlo codes built around the widely used GEANT (Version 3.21) package, to simulate ab initio the physical processes relevant for the production of instrumental backgrounds. These include the build-up and delayed decay of radioactive isotopes as well as the prompt de-excitation of excited nuclei, both of which give rise to a plethora of instrumental gamma-ray background lines in addition to continuum backgrounds. The MGGPOD package and documentation are publicly available for download from http://sigma-2.cesr.fr/spi/MGGPOD/. We demonstrate the capabilities of the MGGPOD suite by modeling high resolution gamma-ray spectra recorded by the Transient Gamma-Ray Spectrometer (TGRS) on board Wind during 1995. The TGRS is a Ge spectrometer operating in the 40 keV to 8 MeV range. Due to its fine energy resolution, these spectra reveal the complex instrumental background in formidable detail, particularly the many prompt and delayed gamma-ray lines. We evaluate the successes and failures of the MGGPOD package in reproducing TGRS data, and provide identifications for the numerous instrumental lines.

The BATSE mission aboard CGRO observed the whole sky for 9 years in the 20 keV - 2 MeV energy band. Flat-fielding of the temporal variations in the background present in the data set has been accomplished through a GEANT3 Monte-Carlo simulation - the BATSE Mass Model (BAMM). The Earth Occultation technique (EOT) is used together with a maximum-likelihood imaging approach to construct all-sky maps with ~mCrab sensitivity. Additionally, a non-linear CLEAN algorithm is applied to the all-sky maps to remove large artefacts that are systematic of the EOT. The latest survey results produced through the application of this technique to a subset of the BATSE data set are presented.

We have developed MGGPOD, a user-friendly suite of Monte Carlo codes built around the widely used GEANT (Version 3.21) package. The MGGPOD Monte Carlo suite and documentation are publicly available for download. MGGPOD is an ideal tool for supporting the various stages of gamma-ray astronomy missions, ranging from the design, development, and performance prediction through calibration and response generation to data reduction. In particular, MGGPOD is capable of simulating ab initio the physical processes relevant for the production of instrumental backgrounds. These include the build-up and delayed decay of radioactive isotopes as well as the prompt de-excitation of excited nuclei, both of which give rise to a plethora of instrumental gamma-ray background lines in addition to continuum backgrounds.

The BATSE mission aboard CGRO monitored the whole sky in the 20 keV - 1 MeV energy band continuously from April 1991 until June 2000. Although BATSE had very poor intrinsic angular resolution, the data can be used to survey the entire soft gamma-ray sky with < 1 degree angular resolution and ~ 1 mCrab sensitivity by using the Earth occultation method. This method determines flux by measuring the step in the count rate profile in each BATSE detector as a source rises above or sets below the Earth's limb. A maximum likelihood imaging technique can then be used to build up all-sky maps from the images of the Earth's limb produced by occulting sources. However, since the Earth seen from BATSE has a radius of ~ 70 degrees, the limb images that intersect at the positions of bright point sources have a significant effect over the area of the all-sky map. A method for performing image cleaning on likelihood data has also been developed and is used to effectively remove artefacts from the all-sky maps. This paper describes the 'LIMBO' imaging technique and presents preliminary all-sky maps of 25 - 160 keV emission, the first to be made since the HEAO1-A4 mission of 1978-79.

Orbiting x-ray and gamma ray instruments are subject to large background count rates due to local particle fluxes in the space environment. The ability of an instrument to make calibrated measurements of the flux from a source of interest is highly dependent on accurately determining the background level. We present here a method of calculating the energy dependent background flux for any point in the complete data set recorded by the Burst and Transient Source Experiment (BATSE) in its nine year mission. The BATSE Mass Model (BAMM) uses a Monte Carlo mass modelling approach to produce a data base of the gamma ray background which is then filtered to simulate the background count rate with a 2.048 second time resolution. This method is able to reduce the variations in the background flux by a factor of 8 - 10, effectively `flat-fielding' the detector response. With flat-fielded BATSE data it should be possible to use the Earth occultation technique to produce a hard x-ray all sky survey to the 1-2 mCrab sensitivity limit. BAMM is also capable of estimating the contribution to the spectra measured from gamma ray sources due to the reprocessing of source photons in inactive material surrounding a gamma ray detector. Possible applications of this aspect of the model in the area of Gamma Ray Burst spectral analysis are discussed.

The BATSE mission aboard CGRO can be used to observe hard X-ray sources by using the Earth occultation method. This method relies on measuring a step in the count rate profile in each BATSE detector as a source rises above or sets below the Earth's limb. A major problem in determining the step sizes (and hence the flux) is in extracting the steps from the varying background. A technique for flat-fielding the response of gamma ray detectors has been developed at Southampton. The technique uses a dynamic Monte-Carlo model to simulate the dominant components of the gamma-ray background encountered by the experiment at any point in its orbit. A maximum likelihood imaging method is also being developed that will be used to make a sky survey with all 9 years of the BATSE Continuous data set in the 20 - 500 keV range. An all sky map of 25 - 35 keV emission has been made using 60 days of data and has a 3 sigma flux sensitivity of 14 mCrab.