Elhalkouj, Thami
Normalized to: Elhalkouj, T.
3 article(s) in total. 13 co-authors, from 1 to 3 common article(s). Median position in authors list is 3,0.
[1]
oai:arXiv.org:1610.08287 [pdf] - 1503526
Hierarchical fringe tracker to co-phase and coherence very large optical
interferometers
Submitted: 2016-10-26
The full scientific potential of the VLTI with its second generation
instruments MATISSE and GRAVITY require fringe tracking up to magnitudes K>14
with the UTs and K>10 with the ATs. The GRAVITY fringe tracker (FT) will be
limited to K~10.5 with UTs and K~7.5 with ATs, for fundamental conceptual
reasons: the flux of each telescope is distributed among 3 cophasing pairs and
then among 5 spectral channels for coherencing. To overcome this limit we
propose a new FT concept, called Hierarchical Fringe Tracker (HFT) that cophase
pairs of apertures with all the flux from two apertures and only one spectral
channel. When the pair is cophased, most of the flux is transmitted as if it
was produced by an unique single mode beam and then used to cophase pairs of
pairs and then pairs of groups. At the deeper level, the flux is used in an
optimized dispersed fringe device for coherencing. On the VLTI such a system
allows a gain of about 3 magnitudes over the GRAVITY FT. On interferometers
with more apertures such as CHARA (6 telescopes) or a future Planet Formation
Imager (12 to 20 telescopes), the HFT would be even more decisive, as its
performance does not decrease with the number of apertures. It would allow
building a PFI reaching a coherent magnitude H~10 with 16 apertures with
diameters smaller than 2 m. We present the HFT concept, the first steps of its
feasibility demonstration from computer simulations and the optical design of a
4 telescopes HFT prototype.
[2]
oai:arXiv.org:1610.08289 [pdf] - 1503527
Cophasing the Planet Formation Imager
Submitted: 2016-10-26
The Planet Formation Imager (PFI) is a project for a very large optical
interferometer intended to obtain images of the planet formation process at
scales as small as the Hill sphere of giant exoplanets. Its main science
instruments will work in the thermal infrared but it will be cophased in the
near infrared, where it requires also some capacity for scientific imaging. PFI
imaging and resolution specifications imply an array of 12 to 20 apertures and
baselines up to a few kilometers cophased at near infrared coherent magnitudes
as large as 10. This paper discusses various cophasing architectures and the
corresponding minimum diameter of individual apertures, which is the dominant
element of PFI cost estimates. From a global analysis of the possible
combinations of pairwise fringe sensors, we show that conventional approaches
used in current interferometers imply the use of prohibitively large telescopes
and we indicate the innovative strategies that would allow building PFI with
affordable apertures smaller than 2 m in diameter. The approach with the best
potential appears to be Hierarchical Fringe Tracking based on "two beams
spatial filters" that cophase pairs of neighboring telescopes with all the
efficiency of a two telescopes fringe tracker and transmit most of the flux as
if it was produced by an unique single mode aperture to cophase pairs of pairs
and then pairs of groups of apertures. We consider also the adaptation to PFI
of more conventional approaches such as a combination of GRAVITY like fringe
trackers or single or multiple chains of 2T fringe trackers.
[3]
oai:arXiv.org:1410.4822 [pdf] - 884094
Hierarchical fringe tracking
Submitted: 2014-10-17
The limiting magnitude is a key issue for optical interferometry. Pairwise
fringe trackers based on the integrated optics concepts used for example in
GRAVITY seem limited to about K=10.5 with the 8m Unit Telescopes of the VLTI,
and there is a general "common sense" statement that the efficiency of fringe
tracking, and hence the sensitivity of optical interferometry, must decrease as
the number of apertures increases, at least in the near infrared where we are
still limited by detector readout noise. Here we present a Hierarchical Fringe
Tracking (HFT) concept with sensitivity at least equal to this of a two
apertures fringe trackers. HFT is based of the combination of the apertures in
pairs, then in pairs of pairs then in pairs of groups. The key HFT module is a
device that behaves like a spatial filter for two telescopes (2TSF) and
transmits all or most of the flux of a cophased pair in a single mode beam. We
give an example of such an achromatic 2TSF, based on very broadband dispersed
fringes analyzed by grids, and show that it allows piston measures from very
broadband fringes with only 3 to 5 pixels per fringe tracker. We show the
results of numerical simulation indicating that our device is a good achromatic
spatial filter and allowing a first evaluation of its coupling efficiency,
which is similar to this of a single mode fiber on a single aperture. Our very
preliminary results indicate that HFT has a good chance to be a serious
candidate for the most sensitive fringe tracking with the VLTI and also
interferometers with much larger number of apertures. On the VLTI the first
rough estimate of the magnitude gain with regard to the GRAVITY internal FT is
between 2.5 and 3.5 magnitudes in K, with a decisive impact on the VLTI science
program for AGNs, Young stars and planet forming disks.