Meteoritic analysis demonstrates that radioactive nuclei heavier than iron were present in the early Solar System. Among them, $^{129}$I and $^{247}$Cm both have a rapid neutron-capture process ($r$ process) origin and decay on the same timescale ($\simeq$ 15.6 Myr). We show that the $^{129}$I/$^{247}$Cm abundance ratio in the early Solar System (438$\pm$184) is immune to galactic evolution uncertainties and represents the first direct observational constraint for the properties of the last $r$-process event that polluted the pre-solar nebula. We investigate the physical conditions of this event using nucleosynthesis calculations and demonstrate that moderately neutron-rich ejecta can produce the observed ratio. We conclude that a dominant contribution by exceedingly neutron-rich ejecta is highly disfavoured.

Several extremely metal-poor stars are known to have an enhanced thorium abundance. These actinide-boost stars have likely inherited material from an r-process that operated under different conditions than the most frequent r-process in the galaxy. In this article, we explore the sensitivity of actinide production in r-process calculations on the hydrodynamical conditions as well as on the nuclear physics. We find that the initial electron fraction Ye is the most important factor determining the actinide yields and that the abundance ratios between long-lived actinides and lanthanides like europium can vary for different conditions in our calculations. In our setup, conditions with high entropies systematically lead to lower actinide abundances relative to other r-process elements. Furthermore, actinide-enhanced ejecta can be distinguished from the "regular" composition also in other ways, most notably in the second r-process peak abundances.

Probing the origin of r-process elements in the universe represents a multi-disciplinary challenge. We review the observational evidence that probe the properties of r-process sites, and address them using galactic chemical evolution simulations, binary population synthesis models, and nucleosynthesis calculations. Our motivation is to define which astrophysical sites have significantly contributed to the total mass of r-process elements present in our Galaxy. We found discrepancies with the neutron star (NS-NS) merger scenario. Assuming they are the only site, the decreasing trend of [Eu/Fe] at [Fe/H]\,$>-1$ in the disk of the Milky Way cannot be reproduced while accounting for the delay-time distribution (DTD) of coalescence times ($\propto~t^{-1}$) derived from short gamma-ray bursts and population synthesis models. Steeper DTD functions ($\propto~t^{-1.5}$) or power laws combined with a strong burst of mergers before the onset of Type~Ia supernovae can reproduce the [Eu/Fe] trend, but this scenario is inconsistent with the similar fraction of short gamma-ray bursts and Type~Ia supernovae occurring in early-type galaxies, and reduces the probability of detecting GW170817 in an early-type galaxy. One solution is to assume an extra production site of Eu that would be active in the early universe, but would fade away with increasing metallicity. If this is correct, this extra site could be responsible for roughly 50% of the Eu production in the early universe, before the onset of Type~Ia supernovae. Rare classes of supernovae could be this additional r-process source, but hydrodynamic simulations still need to ensure the conditions for a robust r-process pattern.

In July 2018 an FRIB Theory Alliance program was held on the implications of GW170817 and its associated kilonova for r-process nucleosynthesis. Topics of discussion included the astrophysical and nuclear physics uncertainties in the interpretation of the GW170817 kilonova, what we can learn about the astrophysical site or sites of the r process from this event, and the advances in nuclear experiment and theory most crucial to pursue in light of the new data. Here we compile a selection of scientific contributions to the workshop, broadly representative of progress in r-process studies since the GW170817 event.

The existence of neutron star mergers has been supported since the discovery of the binary pulsar and the observation of its orbital energy loss, consistent with General Relativity. They are considered nucleosynthesis sites of the rapid neutron-capture process (r-process), which is responsible for creating approximately half of all heavy elements beyond Fe and is the only source of elements beyond Pb and Bi. Detailed nucleosynthesis calculations based on the decompression of neutron star matter are consistent with solar r-process abundances of heavy nuclei. Neutron star mergers have also been identified with short-duration {\gamma}-ray bursts via their IR afterglow. The high neutron densities in ejected matter permit a violent r-process, leading to fission cycling of the heaviest nuclei in regions far from (nuclear) stability. Uncertainties in several nuclear properties affect the abundance distributions. The modeling of astrophysical events also depends on the hydrodynamic treatment, the occurrence of a neutrino wind after the merger and before the possible emergence of a black hole, and the properties of black hole accretion disks. We discuss the effect of nuclear and modeling uncertainties and conclude that binary compact mergers are probably a (or the) dominant site of the production of r-process nuclei in our Galaxy.

Core-collapse supernovae are the first polluters of heavy elements in the galactic history. As such, it is important to study the nuclear compositions of their ejecta, and understand their dependence on the progenitor structure (e.g., mass, compactness, metallicity). Here, we present a detailed nucleosynthesis study based on two long-term, two-dimensional core-collapse supernova simulations of a 11.2 M$_{\odot}$ and a 17.0 M$_{\odot}$ star. We find that in both models nuclei well beyond the iron group (up to $Z \approx 44$) can be produced, and discuss in detail also the nucleosynthesis of the p-nuclei $^{92,94}$Mo and $^{96,98}$Ru. While we observe the production of $^{92}$Mo and $^{94}$Mo in slightly neutron-rich conditions in both simulations, $^{96,98}$Ru can only be produced efficiently via the $\nu$p-process. Furthermore, the production of Ru in the $\nu$p-process heavily depends on the presence of very proton-rich material in the ejecta. This disentanglement of production mechanisms has interesting consequences when comparing to the abundance ratios between these isotopes in the solar system and in presolar grains.

Core-collapse supernovae (CCSNe) are the extremely energetic deaths of massive stars. They play a vital role in the synthesis and dissemination of many heavy elements in the universe. In the past, CCSN nucleosynthesis calculations have relied on artificial explosion methods that do not adequately capture the physics of the innermost layers of the star. The PUSH method, calibrated against SN1987A, utilizes the energy of heavy-flavor neutrinos emitted by the proto-neutron star (PNS) to trigger parametrized explosions. This makes it possible to follow the consistent evolution of the PNS and to ensure a more accurate treatment of the electron fraction of the ejecta. Here, we present the Iron group nucleosynthesis results for core-collapse supernovae, exploded with PUSH, for two different progenitor series. Comparisons of the calculated yields to observational metal-poor star data are also presented. Nucleosynthesis yields will be calculated for all elements and over a wide range of progenitor masses. These yields can be immensely useful for models of galactic chemical evolution.

We report on a method, PUSH, for triggering core-collapse supernova (CCSN) explosions of massive stars in spherical symmetry. This method provides a framework to study many important aspects of core collapse supernovae: the effects of the shock passage through the star, explosive supernova nucleosynthesis and the progenitor-remnant connection. Here we give an overview of the method, compare the results to multi-dimensional simulations and investigate the effects of the progenitor and the equation of state on black hole formation.

Comparing observational abundance features with nucleosynthesis predictions of stellar evolution or explosion simulations can scrutinize two aspects: (a) the conditions in the astrophysical production site and (b) the quality of the nuclear physics input utilized. We test the abundance features of r-process nucleosynthesis calculations for the dynamical ejecta of neutron star merger simulations based on three different nuclear mass models: The Finite Range Droplet Model (FRDM), the (quenched version of the) Extended Thomas Fermi Model with Strutinsky Integral (ETFSI-Q), and the Hartree-Fock-Bogoliubov (HFB) mass model. We make use of corresponding fission barrier heights and compare the impact of four different fission fragment distribution models on the final r-process abundance distribution. In particular, we explore the abundance distribution in the second r-process peak and the rare-earth sub-peak as a function of mass models and fission fragment distributions, as well as the origin of a shift in the third r-process peak position. The latter has been noticed in a number of merger nucleosynthesis predictions. We show that the shift occurs during the r-process freeze-out when neutron captures and {\beta}-decays compete and an (n,{\gamma})-({\gamma},n) equilibrium is not maintained anymore. During this phase neutrons originate mainly from fission of material above A = 240. We also investigate the role of {\beta}-decay half-lives from recent theoretical advances, which lead either to a smaller amount of fissioning nuclei during freeze-out or a faster (and thus earlier) release of fission neutrons, which can (partially) prevent this shift and has an impact on the second and rare-earth peak as well.

We report on a method, PUSH, for triggering core-collapse supernova explosions of massive stars in spherical symmetry. We explore basic explosion properties and calibrate PUSH such that the observables of SN1987A are reproduced. Our simulations are based on the general relativistic hydrodynamics code AGILE combined with the detailed neutrino transport scheme IDSA for electron neutrinos and ALS for the muon and tau neutrinos. To trigger explosions in the otherwise non-exploding simulations, we rely on the neutrino-driven mechanism. The PUSH method locally increases the energy deposition in the gain region through energy deposition by the heavy neutrino flavors. Our setup allows us to model the explosion for several seconds after core bounce. We explore the progenitor range 18-21M$_{\odot}$. Our studies reveal a distinction between high compactness (HC) and low compactness (LC) progenitor models, where LC models tend to explore earlier, with a lower explosion energy, and with a lower remnant mass. HC models are needed to obtain explosion energies around 1 Bethe, as observed for SN1987A. However, all the models with sufficiently high explosion energy overproduce $^{56}$Ni. We conclude that fallback is needed to reproduce the observed nucleosynthesis yields. The nucleosynthesis yields of $^{57-58}$Ni depend sensitively on the electron fraction and on the location of the mass cut with respect to the initial shell structure of the progenitor star. We identify a progenitor and a suitable set of PUSH parameters that fit the explosion properties of SN1987A when assuming 0.1M$_{\odot}$ of fallback. We predict a neutron star with a gravitational mass of 1.50M$_{\odot}$. We find correlations between explosion properties and the compactness of the progenitor model in the explored progenitors. However, a more complete analysis will require the exploration of a larger set of progenitors with PUSH.