From data by LASCO C2 and C3 coronagraphs, depending on time (distance), we have determined positions and velocities of the front for fast limb CMEs' body with their sources near the limb, and for the body of halo-type CME with the sources near the solar disk center. These characteristics of CME body are compared to similar kinematic characteristics obtained for CME body-associated shock waves (shocks). For the body of halo-type CME with the sources near the solar disk center and associated shocks, we determined and compared their kinematic characteristics in 3D space. It has been shown that for all the considered CME groups, the shock velocity is higher than the CME body velocity, both velocities decrease as the mass ejection moves. As this takes place, the distance between CME body and shock grows. On average, distance from CME body to shock, and velocity difference of these structures is greater for a halo CME, and even greater for a model CME in 3D.

We study the origin of a CME-related shock within the LASCO C3 field-of-view (FOV). A shock originates, when a CME body velocity on its axis surpasses the total velocity $V_A + V_{SW}$, where $V_A$ is the Alfv\'en velocity, $V_{SW}$ is the slow solar wind velocity. The formed shock appears collisionless, because its front width is manifold less, than the free path of coronal plasma charged particles. The Alfv\'en velocity dependence on the distance was found by using characteristic values of the magnetic induction radial component and of the proton concentration in the Earth orbit, and by using the known regularities of the variations in these solar wind characteristics with distance. A peculiarity of the analyzed CME is its formation at a relatively large height, and the CME body slow acceleration with distance. We arrived at a conclusion that the formed shock is a bow one relative to the CME body moving at a super Alfv\'en velocity. At the same time, the shock formation involves a steeping of the front edge of the coronal plasma disturbed region ahead of the CME body, which is characteristic of a piston shock.

Based on the method of finding coronal magnetic field value radial profiles B(R) described in (Gopalswamy and Yashiro, 2011), and applied for the directions close to the sky plane, we determined magnetic field value radial distributions along the directions close to the Sun-Earth axis. For this purpose, by using the method in (Xue, Wang, and Dou, 2005), from the SOHO/LASCO data, we found 3D characteristics for fast halo coronal mass ejections (HCMEs) and for the HCME-related shocks. Through these data, we managed to obtain the B(R) distributions as far as 43 solar radii from the Sun center, which is approximately by a factor of 2 farther, than those in (Gopalswamy and Yashiro, 2011). We drew a conclusion that, to improve the accuracy of the Gopalswamy-Yashiro method to find the coronal magnetic field, one should develop a technique to detect the CME sites that move in the slow and in the fast solar wind. We propose a technique to select the CMEs, whose central (paraxial) part moves, indeed, in the slow wind.

From vector measurements of the photospheric magnetic field with the SDO/HMI instrument, we studied the field variations within the 2011 June 7 eruptive event related to the filament eruption (FE), flare, and coronal mass ejection (CME). We analyzed the variations in modulus (B), in radial (Br) and transversal (Bt) magnetic induction components, as well as in the field line inclination angle ({\alpha}) to the radial direction from the Sun center were. The conclusion is that the most probable cause for the FE onset being the trigger related to the flares and CME, as well as for Stage 1 of the filament dramatic acceleration, is {\guillemotleft}magnetic flux cancellation{\guillemotright} in several sites inside and around the filament channel. We assumed that the flare and the stage of the filament fastest acceleration are related to a spot emergence near the south-eastern filament footpoint, in which the field polarity and value satisfy a possibility of this field magnetic reconnection with the field surrounding the filament. We studied in detail the time variations in the field line inclination angles within different sites of the eruptive event. During the filament slow emergence, a decrease in the field line inclination angles was revealed to occur in its channel neighboring, whereas the field line inclination angles dramatically grew in the neutral line neighboring within the flare region after the flare onset. The flare ribbons at all the stages of their existence are shown to be located under the photosphere sites with the field modulus local maxima and with minima of the field line inclination angles. We show that, near the photospheric magnetic field polarity inversion line (PIL), the azimuth decreases after the flare onset, which means a decrease in the angle \b{eta} between PIL and the magnetic induction vector projection onto the sky plane.

A solar eruptive event SOL2010-06-13 observed with SDO/AIA has been discussed in the contexts of the CME gebesis and an associated EUV transient in terms of a shock driven by the apparent CME rim. We have revealed in this event an erupting flux rope, studied its properties, and detected wave signatures inside the developing CME. These findings have allowed us to establish new features in the genesis of the CME and associated EUV wave and to reconcile all of the episodes into a causally-related sequence. (1) A hot 11 MK flux rope developed from a compact filament, accelerated up to 3 km/s$^2$ 1 min before a hard X-ray burst and earlier than other structures, reached 420 km/s, and decelerated to 50 km/s. (2) The CME development was driven by the flux rope. Closed structures above the rope got sequentially involved in the expansion from below upwards, came closer together, and disappeared to reveal their envelope, the rim, which became the outer boundary of the cavity. The rim was associated with the separatrix surface of a magnetic domain, which contained the pre-eruptive filament. (3) The rim formation was associated with a successive compression of the upper active-region structures into the CME frontal structure (FS). When the rim was formed, it resembled a piston. (4) The disturbance responsible for the CME formation was excited by the flux rope inside the rim, and then propagated outward. EUV structures at different heights started to accelerate, when their trajectories in the distance-time diagram were crossed by the front of this disturbance. (5) Outside the rim and FS, the disturbance propagated like a blast wave, manifesting in a type II radio burst and a leading part of the EUV transient. Its main, trailing part was the FS, which consisted of swept-up 2 MK loops enveloping the rim. The wave decelerated and decayed soon, being not driven by the trailing piston, which slowed down.

Calibration of a PMT matrix is crucial for the treatment of the data obtained with Cherenkov tracking detector. Furthermore, due to high variability of the aerosol abundance in the atmosphere depending on season, weather etc. A constant monitoring of the atmospheric transparency is required during the measurements. For this purpose, besides traditional methods, a station for laser atmospheric probing is used.

We continue our study (Grechnev et al. (2013), doi:10.1007/s11207-013-0316-6; Paper I) on the 18 November 2003 geoffective event. To understand possible impact on geospace of coronal transients observed on that day, we investigated their properties from solar near-surface manifestations in extreme ultraviolet, LASCO white-light images, and dynamic radio spectra. We reconcile near-surface activity with the expansion of coronal mass ejections (CMEs) and determine their orientation relative to the earthward direction. The kinematic measurements, dynamic radio spectra, and microwave and X-ray light curves all contribute to the overall picture of the complex event and confirm an additional eruption at 08:07 - 08:20 UT close to the solar disk center presumed in Paper I. Unusual characteristics of the ejection appear to match those expected for a source of the 20 November superstorm but make its detection in LASCO images hopeless. On the other hand, none of the CMEs observed by LASCO seem to be a promising candidate for a source of the superstorm being able to produce, at most, a glancing blow on the Earth's magnetosphere. Our analysis confirms free propagation of shock waves revealed in the event and reconciles their kinematics with "EUV waves" and dynamic radio spectra up to decameters.

We present a summary of the measurements of mass sensitive parameters at the highest cosmic ray energies done by several experiments. The Xmax distribution as a function of energy has been measured with fluorescence telescopes by the HiRes, TA and Auger experiments and with Cherenkov light detectors by Yakutsk. The <Xmax> or the average mass (<lnA>) has been also inferred using ground detectors, such as muon and water Cherenkov detectors. We discuss the different data analyses elaborated by each collaboration in order to extract the relevant information. Special attention is given to the different approaches used in the analysis of the data measured by fluorescence detectors in order to take into account detector biases. We present a careful analysis of the stability and performance of each analysis. The results of the different experiments will be compared and the discrepancies or agreements will be quantified.

The joint use of high-resolution data from PROBA2 and SDO satellites and LASCO/SOHO coronographs enabled us to examine early stages of initiation and propagation of six limb CMEs registered in June 2010 - June 2011. For five events under consideration, the CME initiation is marked by filament (prominence) eruption or by a loop-like structure having another nature. Subsequently, several loop-like structures having higher brightness and following each other at different velocities appear in the region of the CME initiation. The CME frontal structure is formed by these loop-like structures. The time-dependent velocities and acceleration of the ejection front have been obtained for all CMEs under consideration. We have drawn a conclusion about the possible existence of two CME types dependent on the time profile of their velocity. The first CME type comprises the ejections whose velocity decreases abruptly by more than 100 km/s after having reached the maximum; it thereupon passes to slow deceleration/variation. The second CME type is formed by the ejections whose velocity varies insignificantly after reaching the maximum. The CME angular size is shown to increase up to threefold at the initial stage of propagation; it increases twofold 3.5-11 minutes after the first measurement of this parameter. When considering 3 CMEs, we see that their broadening exceeds their extension in the longitudinal direction during a certain period of time at the initial propagation stage.