We apply the independent component analysis (ICA) to the real data from a gravitational wave detector for the first time. Specifically we use the iKAGRA data taken in April 2016, and calculate the correlations between the gravitational wave strain channel and 35 physical environmental channels. Using a couple of seismic channels which are found to be strongly correlated with the strain, we perform ICA. Injecting a sinusoidal continuous signal in the strain channel, we find that ICA recovers correct parameters with enhanced signal-to-noise ratio, which demonstrates usefulness of this method. Among the two implementations of ICA used here, we find the correlation method yields the optimal result for the case environmental noises act on the strain channel linearly.

KAGRA is a second-generation interferometric gravitational-wave detector with 3-km arms constructed at Kamioka, Gifu in Japan. It is now in its final installation phase, which we call bKAGRA (baseline KAGRA), with scientific observations expected to begin in late 2019. One of the advantages of KAGRA is its underground location of at least 200 m below the ground surface, which brings small seismic motion at low frequencies and high stability of the detector. Another advantage is that it cools down the sapphire test mass mirrors to cryogenic temperatures to reduce thermal noise. In April-May 2018, we have operated a 3-km Michelson interferometer with a cryogenic test mass for 10 days, which was the first time that km-scale interferometer was operated at cryogenic temperatures. In this article, we report the results of this "bKAGRA Phase 1" operation. We have demonstrated the feasibility of 3-km interferometer alignment and control with cryogenic mirrors.

The recent detections of gravitational waves (GWs) reported by LIGO/Virgo collaborations have made significant impact on physics and astronomy. A global network of GW detectors will play a key role to solve the unknown nature of the sources in coordinated observations with astronomical telescopes and detectors. Here we introduce KAGRA (former name LCGT; Large-scale Cryogenic Gravitational wave Telescope), a new GW detector with two 3-km baseline arms arranged in the shape of an "L", located inside the Mt. Ikenoyama, Kamioka, Gifu, Japan. KAGRA's design is similar to those of the second generations such as Advanced LIGO/Virgo, but it will be operating at the cryogenic temperature with sapphire mirrors. This low temperature feature is advantageous for improving the sensitivity around 100 Hz and is considered as an important feature for the third generation GW detector concept (e.g. Einstein Telescope of Europe or Cosmic Explorer of USA). Hence, KAGRA is often called as a 2.5 generation GW detector based on laser interferometry. The installation and commissioning of KAGRA is underway and its cryogenic systems have been successfully tested in May, 2018. KAGRA's first observation run is scheduled in late 2019, aiming to join the third observation run (O3) of the advanced LIGO/Virgo network. In this work, we describe a brief history of KAGRA and highlights of main feature. We also discuss the prospects of GW observation with KAGRA in the era of O3. When operating along with the existing GW detectors, KAGRA will be helpful to locate a GW source more accurately and to determine the source parameters with higher precision, providing information for follow-up observations of a GW trigger candidate.

Major construction and initial-phase operation of a second-generation gravitational-wave detector KAGRA has been completed. The entire 3-km detector is installed underground in a mine in order to be isolated from background seismic vibrations on the surface. This allows us to achieve a good sensitivity at low frequencies and high stability of the detector. Bare-bones equipment for the interferometer operation has been installed and the first test run was accomplished in March and April of 2016 with a rather simple configuration. The initial configuration of KAGRA is named {\it iKAGRA}. In this paper, we summarize the construction of KAGRA, including the study of the advantages and challenges of building an underground detector and the operation of the iKAGRA interferometer together with the geophysics interferometer that has been constructed in the same tunnel.

KAGRA is a 3-km interferometric gravitational wave telescope located in the Kamioka mine in Japan. It is the first km-class gravitational wave telescope constructed underground to reduce seismic noise, and the first km-class telescope to use cryogenic cooling of test masses to reduce thermal noise. The construction of the infrastructure to house the interferometer in the tunnel, and the initial phase operation of the interferometer with a simple 3-km Michelson configuration have been completed. The first cryogenic operation is expected in 2018, and the observing runs with a full interferometer are expected in 2020s. The basic interferometer configuration and the current status of KAGRA are described.

We have developed a new gravitaional-wave (GW) detector, TOrsion-Bar Antenna (TOBA), with multiple-output configuration. TOBA is a detector with bar-shaped test masses that rotate by the tidal force of the GWs. In our detector, three independent information about the GW signals can be derived by monitoring multiple rotational degrees of freedom, i.e., horizontal rotations and vertical rotations of the bars. Since the three outputs have different antenna pattern functions, the multi-output system improves the detection rate and the parameter estimation accuracy. It is effective in order to obtain further details of the GW sources, such as population and directions. We successfully operated the multi-output detector continuously for more than 24 hours with stable data quality. Also, the sensitivity of one of the signals is improved to be $1 \times 10^{-10}$ ${\rm Hz}^{-1/2}$ at 3 Hz by the combination of the passive and active vibration isolation systems, while sensitivities to possible GW signals derived from the vertical rotations are worse than that from the horizontal rotation.

Pre-DECIGO consists of three spacecraft arranged in an equilateral triangle with 100km arm lengths orbiting 2000km above the surface of the earth. It is hoped that the launch date will be in the late 2020s. Pre-DECIGO has one clear target: binary black holes (BBHs) like GW150914 and GW151226. Pre-DECIGO can detect $\sim 30M_\odot-30M_\odot$ BBH mergers up to redshift $z\sim 30$. The cumulative event rate is $\sim 1.8\times 10^{5}\,{\rm events~yr^{-1}}$ in the Pop III origin model of BBHs like GW150914, and it saturates at $z\sim 10$, while in the primordial BBH (PBBH) model, the cumulative event rate is $ \sim 3\times 10^{4}\,{\rm events~ yr^{-1}}$ at $z=30$ even if only $0.1\%$ of the dark matter consists of PBHs, and it is still increasing at $z=30$. In the Pop I/II model of BBHs, the cumulative event rate is $(3-10)\times10^{5}\,{\rm events~ yr^{-1}}$ and it saturates at $z \sim 6$. We present the requirements on orbit accuracy, drag free techniques, laser power, frequency stability, and interferometer test mass. For BBHs like GW150914 at 1Gpc, SNR$\sim 90$ is achieved with the definition of Pre-DECIGO in the $0.01-100$Hz band. Pre-DECIGO can measure the mass spectrum and the $z$-dependence of the merger rate to distinguish various models of BBHs like GW150914. Pre-DECIGO can also predict the direction of BBHs at $z=0.1$ with an accuracy of $\sim 0.3\,{\rm deg}^2$ and a merging time accuracy of $\sim 1$s at about a day before the merger so that ground-based GW detectors further developed at that time as well as electromagnetic follow-up observations can prepare for the detection of merger in advance. For intermediate mass BBHs at a large redshift $z > 10$, the QNM frequency after the merger can be within the Pre-DECIGO band so that the ringing tail can also be detectable to confirm the Einstein theory of general relativity with SNR$\sim 35$. [abridged]

A rapidly spinning neutron star (NS) would emit a continuous gravitational wave (GW) detectable by the advanced LIGO, advanced Virgo, KAGRA and proposed third generation detectors such as the Einstein Telescope (ET). Such a GW does not propagate freely, but is affected by the Coulomb-type gravitational field of the NS itself. This effect appears as a phase shift in the GW depending on the NS mass. We have shown that mass of an isolated NS can, in principle, be determined if we could detect the continuous GW with two or more frequency modes. Indeed, our Monte Carlo simulations have demonstrated that mass of a NS with its ellipticity $10^{-6}$ at 1 kpc is typically measurable with precision of 20% using the ET, if the NS is precessing or has a pinned superfluid core and emits GWs with once and twice the spin frequencies. After briefly explaining our idea and results, this paper concerns with the effect of misalignment angle ("wobble angle" in the case of a precessing NS) on the mass measurement precision.

A torsion-bar antenna (TOBA) is a low-frequency terrestrial gravitational wave (GW) antenna which consists of two orthogonal bar-shaped test masses. We upgraded the prototype TOBA and achieved the strain sensitivity $10^{-10}$ Hz$^{-1/2}$ at around 1 Hz. We operated the upgraded TOBA (called the "Phase-II TOBA") located at Tokyo in Japan for 22.5 hours and performed an all-sky coherent search for continuous GWs using the $\mathcal{F}$-statistic. We place upper limits on continuous GWs from electromagnetically unknown sources in the frequency range from 6 Hz to 7 Hz with the first derivative of frequency less than $7.62 \times 10^{-11}$ Hz/s using data from the TOBA. As a result, no significant GW signals are found in the frequency band 6-7 Hz. The most stringent upper limit upper limit on the dimensionless GW strain with 95% confidence level in this band is $3.6 \times 10^{-12}$ at 6.84 Hz.

Recent studies show that an intermediate mass black hole (IMBH) may develop a dark matter (DM) mini-halo according to some BH formation scenarios. We consider a binary system composed of an IMBH surrounded by a DM mini-spike and a stellar mass object orbiting around the IMBH. The binary evolves due to gravitational pull and dynamical friction from the DM mini-spike and back-reaction from its gravitational wave (GW) radiation which can be detected by future space-borne GW experiments such as eLISA/NGO. We consider a single power-law model for the DM mini-spike which is assumed to consist of non-annihilating DM particles and demonstrate that an eLISA/NGO detection of GW from such a binary enables us to measure the DM mini-spike parameters very accurately. For instance, in our reference case originally advocated by Zhao and Silk (2005) and Bertone et al. (2005), we could determine the power-law index $\alpha$ of the DM mini-spike radial profile with a 1 $\sigma$ relative error of $\pm 5\times 10^{-6}$ for a GW signal with signal-to-noise-ratio 10 and assuming a 5 year observation with eLISA. We also investigate how accurately the DM parameters can be determined for various DM parameters and the masses of the IMBH-stellar mass object binary surrounded by a DM mini-spike. We find that we can determine the power-law index $\alpha$ at 10 % level even for a slightly flatter radial distribution of $\alpha \sim 1.7$.

An intermediate mass black hole (IMBH) may have a dark matter (DM) mini-halo around it and develop a spiky structure within less than a parsec from the IMBH. When a stellar mass object is captured by the mini-halo, it eventually infalls into such an IMBH due to gravitational wave back reaction which in turn could be observed directly by future space-borne gravitational wave experiments such as eLISA/NGO. In this paper, we show that the GW detectability strongly depends on the radial profile of the DM distribution. So if the GW is detected, the power index, that is, the DM density distribution would be determined very accurately. The DM density distribution obtained would make it clear how the IMBH has evolved from a seed BH and whether the IMBH has experienced major mergers in the past. Unlike the gamma ray observations of DM annihilation, GW is just sensitive to the radial profile of the DM distribution and even to non-interacting DM. Hence the effect we demonstrate here can be used as a new and powerful probe into DM properties.