The Any Light Particle Search II (ALPS II) requires a sensitive detection of 1064 nm photons. Thus, a low dark count rate (DC) and a high detection efficiency (DE) is needed. ALPS has set up a transition-edge sensor (TES) detector system, namely the ALPS TES detector. It is found that thermal photons from room temperature surfaces are the main contribution of dark counts for 1064 nm photon signals. Furthermore, the current setup of the ALPS TES detector shows an improvement compared to using the ALPS I detector.

An essential design requirement of the ALPS-II experiment is the efficient detection of single photons with a very low instrumental background of 10 {\mu}Hz. In 2011 the ALPS collaboration started to set up a TES detector (Transition-Edge Sensor) for ALPS-II, the second phase of the experiment. Since mid of 2013 the setup is ready for characterization in the ALPS laboratory: an ADR cryostat (Adiabatic Demagnetization Refrigerator) as millikelvin environment, a low noise SQUID (Superconducting Quantum Interference Device) with electronics for read-out and a fiber-coupled high-efficient TES for near-infrared photons as sensor. First measurements have shown a good discrimination between noise and 1064 nm signals.

This document constitutes an excerpt of the Technical Design Report for the second stage of the "Any Light Particle Search" (ALPS-II) at DESY as submitted to the DESY PRC in August 2012 and reviewed in November 2012. ALPS-II is a "Light Shining through a Wall" experiment which searches for photon oscillations into weakly interacting sub-eV particles. These are often predicted by extensions of the Standard Model and motivated by astrophysical phenomena. The first phases of the ALPS-II project were approved by the DESY management on February 21st, 2013.