Populating states in 22Mg via the (p,t) reaction in inverse kinematics with a 55 MeV/nucleon 24Mg beam, we have measured the proton-decay branching ratios of the levels at 5.96 MeV and 6.05 MeV and obtained an experimental upper limit on the branching ratio of the 5.71 MeV state. On the basis of the present and previous measurements, we assign spins and parities to the 5.96 MeV and 6.05 MeV states. We combine our branching ratios with independent measurements of the lifetimes of these states or their 22Ne analogs to compute the resonance strengths and thereby the astrophysical rate of the 21Na(p,g)22Mg reaction. We perform hydrodynamic calculations of nova outbursts with this new rate and analyze its impact on 22Na yields.

A recoil coincidence technique has been applied to measure the alpha-decay branching ratios of near-threshold states in 19Ne. Populating these states using the (p,t) reaction in inverse kinematics, we detected the recoils and their decay products with 100% geometric efficiency using a magnetic spectrometer. Combining our branching ratio measurements with independent determinations of the radiative widths of these states, we calculate the astrophysical rate of 15O(alpha,gamma)19Ne. Using this reaction rate, we perform hydrodynamic calculations of nova outbursts and conclude that no significant breakout from the hot CNO cycles into the rp process occurs in novae via 15O(alpha,gamma)19Ne.

The 15O(alpha,gamma)19Ne reaction is one of two routes for breakout from the hot CNO cycles into the rp process in accreting neutron stars. Its astrophysical rate depends critically on the decay properties of excited states in 19Ne lying just above the 15O + alpha threshold. We have measured the alpha-decay branching ratios for these states using the p(21Ne,t)19Ne reaction at 43 MeV/u. Combining our measurements with previous determinations of the radiative widths of these states, we conclude that no significant breakout from the hot CNO cycle into the rp process in novae is possible via 15O(alpha,gamma)19Ne, assuming current models accurately represent their temperature and density conditions.