A planetesimal moves through the gas of its protoplanetary disc where it experiences a head wind. Though the ambient pressure is low, this wind can erode and ultimately destroy the planetesimal if the flow is strong enough. For the first time, we observe wind erosion in ground based and microgravity experiments at pressures relevant in protoplanetary discs, i.e. down to $10^{-1}\, \rm mbar$. We find that the required shear stress for erosion depends on the Knudsen number related to the grains at the surface. The critical shear stress to initiate erosion increases as particles become comparable to or larger than the mean free path of the gas molecules. This makes pebble pile planetesimals more stable at lower pressure. However, it does not save them as the experiments also show that the critical shear stress to initiate erosion is very low for sub-millimetre sized grains.

We developed an experiment to study different aspects of granular matter under microgravity. The 1.5U small experiment was carried out on the International Space Station. About 3500 almost identical spherical glass particles with 856 um diameter were placed in a container of 50*50 mm cross section. Adjusting the height between 5 and 50 mm, the filling factor can be varied. The sample was vibrated under different frequencies and amplitudes. The majority of the data are video images of the particles motion. Here, we first give an overview of the general setup and a first qualitative account of different phenomena observed in about 700 experimental runs. These phenomena include collisional cooling, collective motion via gas-cluster coupling, and the influence of electrostatic forces on particle-particle interactions.

We carried out wind tunnel experiments on parabolic flights with 100 $\mu$m Mojave Mars simulant sand. The experiments result in shear stress thresholds and erosion rates for varying g-levels at 600 Pa pressure. Our data confirm former results on JSC Mars 1A simulant where the threshold shear stress is lower under Martian gravity than extrapolated from earlier ground-based studies which fits observations of Martian sand activity. The data are consistent with a model by Shao and Lu (2000) and can also be applied to other small terrestrial (exo)-planets with low pressure atmospheres.

Collisional growth of dust occurs in all regions of protoplanetary disks with certain materials dominating between various condensation lines. The sticking properties of the prevalent dust species depend on the specific temperatures. The inner disk is the realm of silicates spanning a wide range of temperatures from room temperature up to sublimation beyond $1500\,\mathrm{K}$. For the first time, we carried out laboratory collision experiments with hot levitated basalt dust aggregates of $1\, \rm mm$ in size. The aggregates are compact with a filling factor of $0.37 \pm 0.06$. The constituent grains have a wide size distribution that peaks at about $0.6\,\mu \mathrm{m}$. Temperatures in the experiments are varied between approximately $600\,\mathrm{K}$ and $1100\,\mathrm{K}$. Collisions are slow with velocities between $0.002\,\mathrm{m}\,\mathrm{s}^{-1}$ and $0.15\,\mathrm{m}\,\mathrm{s}^{-1}$, i.e., relevant for protoplanetary disks. Aside from variations of the coefficients of restitution due to varying collision velocities, the experiments show low sticking probability below $900\,\mathrm{K}$ and an increasing sticking probability starting at $900\,\mathrm{K}$. This implies that dust can grow to larger size in hot regions, which might change planet formation. One scenario is an enhanced probability for local planetesimal formation. Another scenario is a reduction of planetesimal formation as larger grains are more readily removed as a consequence of radial drift. However, the increased growth at high temperatures likely changes planetesimal formation one way or the other.

In parabolic flight experiments we studied the wind induced erosion of granular beds composed of spherical glass beads at low gravity and low ambient pressure. Varying g-levels were set by centrifugal forces. Expanding existing parameter sets to a pressure range between $p=300-1200\,$Pa and to g-levels of $g=1.1-2.2\,\rm m\,s^{-2}$ erosion thresholds are still consistent with the existing model for wind erosion on planetary surfaces by Shao & Lu (2000). These parameters were the lowest values that could technically be reached by the experiment. The experiments decrease the necessary range of extrapolation of erosion thresholds from verified to currently still unknown values at the conditions of planetesimals in protoplanetary discs. We apply our results to the stability of planetesimals. In inner regions of protoplanetary discs, pebble pile planetesimals below a certain size are not stable but will be disassembled by a head wind.

Dust and sand motion are a common sight on Mars. Understanding the interaction of atmosphere and Martian soil is fundamental to describe the planet's weather, climate and surface morphology. We set up a wind tunnel to study the lift of a mixture between very fine sand and dust in a Mars simulant soil. The experiments were carried out under Martian gravity in a parabolic flight. The reduced gravity was provided by a centrifuge under external microgravity. The onset of saltation was measured for a fluid threshold shear velocity of 0.82$\pm$0.04 m/s. This is considerably lower than found under Earth gravity. In addition to a reduction in weight, this low threshold can be attributed to gravity dependent cohesive forces within the sand bed, which drop by 2/3 under Martian gravity. The new threshold for saltation leads to a simulation of the annual dust cycle with a Mars GCM that is in agreement with observations.

Dust drifting inward in protoplanetary disks is subject to increasing temperatures. In laboratory experiments, we tempered basaltic dust between 873 K and 1273 K and find that the dust grains change in size and composition. These modifications influence the outcome of self-consistent low speed aggregation experiments showing a transition temperature of 1000\,K. Dust tempered at lower temperatures grows to a maximum aggregate size of $2.02 \pm 0.06$ mm, which is $1.49 \pm 0.08$ times the value for dust tempered at higher temperatures. A similar size ratio of $1.75 \pm 0.16$ results for a different set of collision velocities. This transition temperature is in agreement with orbit temperatures deduced for observed extrasolar planets. Most terrestrial planets are observed at positions equivalent to less than 1000 K. Dust aggregation on the millimeter-scale at elevated temperatures might therefore be a key factor for terrestrial planet formation.

In laboratory experiments, we studied collisions of ensembles of compact (filling factor 0.33) millimeter dust aggregates composed of micrometer quartz grains. We used cylindrical aggregates, triangular aggregates, square aggregates, and rectangular aggregates. Ensembles of equal size aggregates as well as ensembles with embedded larger aggregates were studied. The typical collision velocities are 10-20 mm $\rm s^{-1}$. High spatial and temporal resolution imaging unambiguously shows that individual collisions lead to sticking with a high probability of 20 percent. This leads to connected clusters of aggregates. The contact areas between two aggregates increase with collision velocity. However, this cluster growth is only temporary, as subsequent collisions of aggregates and clusters eventually lead to the detachment of all aggregates from a cluster. The contacts are very fragile as aggregates cannot be compressed further or fragment under our experimental conditions to enhance the contact stability. Therefore, the evolution of the ensemble always leads back to a distribution of individual aggregates of initial size. This supports and extends earlier experiments showing that a bouncing barrier in planetesimal formation would be robust against shape and size variations.