sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Deighan, J. I.

Normalized to: Deighan, J.

2 article(s) in total. 4 co-authors, from 1 to 2 common article(s). Median position in authors list is 2,0.

[1]  oai:arXiv.org:1303.3826  [pdf] - 639965
Characterization of a Thick Ozone Layer in Mars' Past
Comments:
Submitted: 2013-03-15
All three terrestrial planets with atmospheres support O3 layers of some thickness. While currently only that of Earth is substantial enough to be climatically significant, we hypothesize that ancient Mars may also have supported a thick O3 layer during volcanically quiescent periods whenthe atmosphere was oxidizing. To characterize such an O3 layer and determine the significance of its fedback on the Martian climate, we apply a 1D line-by-line radiative-convective model under clear sky conditions coupled to a simple photochemical model. The parameter space of atmospheric pressure, insolation, and O2 mixing fraction are explored to find conditions favorable to O3 formation. We find that a substantial O3 layer is most likely for surface pressures of 0.3-1.0 bar, and could produce an O3 column comparable to that of modern Earth for O2 mixing fractions approaching 1%. However, even for thinner O3 layers, significant UV shielding of the surface occurs along with feedback on both the energy budget and photochemistry of the atmosphere. In particular, CO2 condensation in the middle atmosphere is inhibited and the characteristics of H2O dissociation are modified, shifting from a direct photolysis dominated state similar to modern Mars to a more Earth-like state controlled by O(1D) attack.
[2]  oai:arXiv.org:1111.2808  [pdf] - 1091593
Thermally driven escape from Pluto's atmosphere: A combined fluid/kinetic model
Comments:
Submitted: 2011-11-11
A combined fluid/kinetic model is developed to calculate thermally driven escape of N2 from Pluto's atmosphere for two solar heating conditions: no heating above 1450 km and solar minimum heating conditions. In the combined model, one-dimensional fluid equations are applied for the dense part of the atmosphere, while the exobase region is described by a kinetic model and calculated by the direct simulation Monte Carlo method. Fluid and kinetic parts of the model are iteratively solved in order to maintain constant total mass and energy fluxes through the simulation region. Although the atmosphere was found to be highly extended, with an exobase altitude at ~6000 km at solar minimum, the outflow remained subsonic and the escape rate was within a factor of two of the Jeans rate for the exobase temperatures determined. This picture is drastically different from recent predictions obtained solely using a fluid model which, in itself, requires assumptions about atmospheric density, flow velocity and energy flux carried away by escaping molecules at infinity. Gas temperature, density, velocity and heat flux versus radial distance are consistent between the hydrodynamic and kinetic model up to the exobase, only when the energy flux across the lower boundary and escape rate used to solve the hydrodynamic equations is obtained from the kinetic model. This limits the applicability of fluid models to atmospheric escape problems. Finally, the recent discovery of CO at high altitudes, the effect of Charon and the conditions at the New Horizon encounter are briefly considered.