The Transiting Exoplanet Survey Satellite (TESS) is observing bright known planet-host stars across almost the entire sky. These stars have been subject to extensive ground-based observations, providing a large number of radial velocity (RV) measurements. In this work we use the new TESS photometric observations to characterize the star $\lambda^2$ Fornacis, and following this to update the parameters of the orbiting planet $\lambda^2$ For b. We measure the p-mode oscillation frequencies in $\lambda^2$ For, and in combination with non-seismic parameters estimate the stellar fundamental properties using stellar models. Using the revised stellar properties and a time series of archival RV data from the UCLES, HIRES and HARPS instruments spanning almost 20 years, we refit the orbit of $\lambda^2$ For b and search the RV residuals for remaining variability. We find that $\lambda^2$ For has a mass of $1.16\pm0.03$M$_\odot$ and a radius of $1.63\pm0.04$R$_\odot$, with an age of $6.3\pm0.9$Gyr. This and the updated RV measurements suggest a mass of $\lambda^2$ For b of $16.8^{+1.2}_{-1.3}$M$_\oplus$, which is $\sim5$M$_\oplus$ less than literature estimates. We also detect a periodicity at 33 days in the RV measurements, which is likely due to the rotation of the host star. While previous literature estimates of the properties of $\lambda^2$ are ambiguous, the asteroseismic measurements place the star firmly at the early stage of its subgiant evolutionary phase. Typically only short time series of photometric data are available from TESS, but by using asteroseismology it is still possible to provide tight constraints on the properties of bright stars that until now have only been observed from the ground. This prompts a reexamination of archival RV data from the past few decades to update the characteristics of the planet hosting systems observed by TESS for which asteroseismology is possible.

Alhena A ($\gamma$ Gem A) is a bright Am star, with the strongest disc-integrated magnetic field strength reported so far for an Am star. Its spectrum exhibits standard circularly polarized Zeeman signatures, contrary to all previously studied Am stars that display abnormal signatures dominated by a single-signed lobe. We present here the result of follow-up observations of Alhena, using very high signal-to-noise spectropolarimetric data obtained over 25 observing nights with NARVAL at T\'elescope Bernard Lyot, in the frame of the BRITE (BRIght Target Explorer) spectropolarimetric survey. We confirm that Alhena A is magnetic and we determine its surface magnetic properties using different methods. Inclined dipole models are used to reproduce the longitudinal field measurements, as well as the Stokes V line profiles themselves. In both cases, the model is consistent with a polar field strength of $\sim$ 30 G. This is confirmed by a Zeeman-Doppler Imaging (ZDI) model, which also unveils smaller scale magnetic structures. A rotational period of 8.975 days was identified using intensity line profile variations. The ZDI inversion suggests that the surface magnetic field is sheared by differential rotation, with a difference in rotation rate between high and low latitudes at about 15\% of the solar value. This result challenges theories of the development of surface differential rotation in intermediate mass main sequence stars.

When modelling stars with masses larger than 1.2Msun with no observed chemical peculiarity, atomic diffusion is often neglected because, on its own, it causes unrealistic surface abundances compared with those observed. The reality is that atomic diffusion is in competition with other transport processes. The purpose of this study is to quantify the opposite or conjugated effects of atomic diffusion and rotationally induced mixing in stellar models of low mass stars. Our second goal is to estimate the impact of neglecting both rotational mixing and atomic diffusion in stellar parameter inferences for stars with masses larger than 1.3Msun. Using the AIMS code, we infer the masses and ages of a set of representative artificial stars for which models were computed with the CESTAM evolution code, taking into account rotationally induced mixing and atomic diffusion, including radiative accelerations. We show that for masses lower than 1.3Msun, rotation dominates the transport of chemical elements, and strongly reduces the effect of atomic diffusion, with net surface abundance modifications similar to solar ones. At larger mass, atomic diffusion and rotation are competing equally. Above 1.44Msun, atomic diffusion dominates in stellar models with initial rotation smaller than 80km.s-1 producing a chemical peculiarity which is not observed in Kepler-legacy stars. This indicates that a transport process of chemical elements is missing. Importantly, neglecting rotation and atomic diffusion (including radiative accelerations) in the models, when inferring the parameters of F-type stars, may lead to errors of 5%, 2.5% and 25% respectively for stellar masses, radii and ages. Atomic diffusion (including radiative accelerations) and rotational mixing should be taken into account in stellar models in order to determine accurate stellar parameters.

Chemical element transport processes are among the crucial physical processes needed for precise stellar modelling. Atomic diffusion by gravitational settling nowadays is usually taken into account, and is essential for helioseismic studies. On the other hand, radiative accelerations are rarely accounted for, act differently on the various chemical elements, and can strongly counteract gravity in some stellar mass domains. In this study we aim at determining whether radiative accelerations impact the structure of solar-like oscillating main-sequence stars observed by asteroseismic space missions. We implemented the calculation of radiative accelerations in the CESTAM code using the Single-Valued Parameter method. We built and compared several grids of stellar models including gravitational settling, but some with and others without radiative accelerations. We found that radiative accelerations may not be neglected for stellar masses larger than 1.1~M$_{\odot}$ at solar metallicity. The difference in age due to their inclusion in models can reach 9\% for the more massive stars of our grids. We estimated that the percentage of the PLATO core program stars whose modelling would require radiative accelerations ranges between 33 and 58\% depending on the precision of the seismic data. We conclude that, in the context of Kepler, TESS, and PLATO missions, which provide (or will provide) high quality seismic data, radiative accelerations can have a significant effect when inferring the properties of solar-like oscillators properly. This is particularly important for age inferences. However, the net effect for each individual star results from the competition between atomic diffusion including radiative accelerations and other internal transport processes. This will be investigated in a forthcoming companion paper.

A precision of order one percent is needed on the parameters of exoplanet-hosts stars in order to correctly characterize the planets themselves. This will be achieved by asteroseismology. It is important in this context to test the influence on the derived parameters of introducing atomic diffusion with radiative accelerations in the models. In this paper, we begin this study with the case of the star 94 Ceti A. We performed a complete asteroseismic analysis of the exoplanet-host F-type star 94 Ceti A, from the first radial-velocity observations with HARPS up to the final computed best models. This star is hot enough to suffer from important effects of atomic diffusion, including radiative accelerations. We tested the influence of such effects on the computed frequencies and on the determined stellar parameters. We also tested the effect of including a complete atmosphere in the stellar models. The radial velocity observations were done with HARPS in 2007. The low degree modes were derived and identified using classical methods and compared with the results obtained from stellar models computed with the Toulouse Geneva Evolution Code (TGEC). We obtained precise parameters for the star 94 Ceti A. We showed that including atomic diffusion with radiative accelerations can modify the age by a few percents, whereas adding a complete atmosphere does not change the results by more than one percent.

We present a summary of the splinter session "Sun-like stars unlike the Sun" that was held on 09 June 2016 as part of the Cool Stars 19 conference (Uppsala, Sweden). We discussed the main limitations (in the theory and observations) in the derivation of very precise stellar parameters and chemical abundances of Sun-like stars. We outlined and discussed the most important and most debated processes that can produce chemical peculiarities in solar-type stars. Finally, in an open discussion between all the participants we tried to identify new pathways and prospects towards future solutions of the currently open questions.

Aims. Atomic diffusion, including the effect of radiative accelerations on individual elements, leads to important variations of the chemical composition inside the stars. The accumulation in specific layers of the elements, which are the main contributors of the local opacity, leads to hydrodynamical instabilities that modify the internal stellar structure and surface abundances. Our aim is to study these effects and compare the resulting surface abundances with spectroscopic observations Methods. We computed the detailed structure of A-type stars including these effects. We used the Toulouse-Geneva Evolution Code (TGEC), where radiative accelerations are computed using the Single Valued Parameter (SVP) method, and we added double-diffusive convection with mixing coefficients deduced from three-dimensional (3D) simulations. Results. We show that the modification of the initial chemical composition has important effects on the internal stellar mixing and leads to different surface abundances of the elements. The results fit the observed surface chemical composition well if the layers, which are individually mixed by double-diffusive convection, are connected.

The 16 Cyg system is composed of two solar analogs with similar masses and ages. A red dwarf is in orbit around 16 Cyg A whereas 16 Cyg B hosts a giant planet. The abundances of heavy elements are similar in the two stars but lithium is much more depleted in 16 Cyg B that in 16 Cyg A, by a factor of at least 4.7. The interest of studying the 16 Cyg system is that the two star have the same age and the same initial composition. The presently observed differences must be due to their different evolution, related to the fact that one of them hosts a planet contrary to the other one. We computed models of the two stars which precisely fit the observed seismic frequencies. We used the Toulouse Geneva Evolution Code (TGEC) that includes complete atomic diffusion (including radiative accelerations). We compared the predicted surface abundances with the spectroscopic observations and confirmed that another mixing process is needed. We then included the effect of accretion-induced fingering convection. The accretion of planetary matter does not change the metal abundances but leads to lithium destruction which depends on the accreted mass. A fraction of earth mass is enough to explain the lithium surface abundances of 16 Cyg B. We also checked the beryllium abundances. In the case of accretion of heavy matter onto stellar surfaces, the accreted heavy elements do not remain in the outer convective zones but they are mixed downwards by fingering convection induced by the unstable $\mu$-gradient. Depending on the accreted mass, this mixing process may transport lithium down to its nuclear destruction layers and lead to an extra lithium depletion at the surface. A fraction of earth mass is enough to explain a lithium ratio of 4.7 in the 16 Cyg system. In this case beryllium is not destroyed. Such a process may be frequent in planet host stars and should be studied in other cases in the future.

Iron-rich layers are known to form in the stellar subsurface through a combination of gravitational settling and radiative levitation. Their presence, nature and detailed structure can affect the excitation process of various stellar pulsation modes, and must therefore be modeled carefully in order to better interpret Kepler asteroseismic data. In this paper, we study the interplay between atomic diffusion and fingering convection in A-type stars, and its role in the establishment and evolution of iron accumulation layers. To do so, we use a combination of three-dimensional idealized numerical simulations of fingering convection, and one-dimensional realistic stellar models. Using the three-dimensional simulations, we first validate the mixing prescription for fingering convection recently proposed by Brown et al. (2013), and identify what system parameters (total mass of iron, iron diffusivity, thermal diffusivity, etc.) play a role in the overall evolution of the layer. We then implement the Brown et al. (2013) prescription in the Toulouse-Geneva Evolution code to study the evolution of the iron abundance profile beneath the stellar surface. We find, as first discussed by Th\'eado et al. (2009), that when the concurrent settling of helium is ignored, this accumulation rapidly causes an inversion in the mean molecular weight profile, which then drives fingering convection. The latter mixes iron with the surrounding material very efficiently, and the resulting iron layer is very weak. However, taking helium settling into account partially stabilizes the iron profile against fingering convection, and a large iron overabundance can accumulate. The opacity also increases significantly as a result, and in some cases ultimately triggers dynamical convection.

Recent observations of a large number of DA and DB white dwarfs show evidence of debris disks, which are the remnants of old planetary systems. The infrared excess detected with \emph{Spitzer} and the lines of heavy elements observed in their atmospheres with high-resolution spectroscopy converge on the idea that planetary material accretes onto these stars. Accretion rates have been derived by several authors with the assumption of a steady state between accretion and gravitational settling. The results are unrealistically different for DA and DB white dwarfs. When heavy matter is accreted onto stars, it induces an inverse $\mu$-gradient that leads to fingering (thermohaline) convection. The aim of this letter is to study the impact of this specific process on the derived accretion rates in white dwarfs and on the difference between DA and DB. We solve the diffusion equation for the accreted heavy elements with a time-dependent method. The models we use have been obtained both with the IRAP code, which computes static models, and the La Plata code, which computes evolutionary sequences. Computations with pure gravitational settling are compared with computations that include fingering convection. The most important result is that fingering convection has very important effects on DAs but is inefficient in DBs. When only gravitational settling is taken into account, the time-dependent computations lead to a steady state, as postulated by previous authors. When fingering convection is added, this steady state occurs much later. The surprising difference found in the past for the accretion rates derived for DA and DB white dwarfs disappears. The derived accretion rates for DAs are increased when fingering convection is taken into account, whereas those for DBs are not modified. More precise and developed results will be given in a forthcoming paper.

Heavy elements are observed in the atmospheres of many DA and DB white dwarfs, and their presence is attributed to the accretion of matter coming from debris disks. Several authors have deduced accretion rates from the observed abundances, taking into account the mixing induced by the convective zones and the gravitational settling. The obtained values are different for DA and DB white dwarfs. Here we show that an important process was forgotten in all these computations: thermohaline mixing, induced by the inverse $\mu$-gradient built during the accretion process. Taking this mixing into account leads to an increase of the derived accretion rates, specially for DA white dwarfs, and modifies the conclusions.