Normalized to: Daley, C.
[1]
oai:arXiv.org:1904.00027 [pdf] - 1871561
The Mass of Stirring Bodies in the AU Mic Debris Disk Inferred from
Resolved Vertical Structure
Daley, Cail;
Hughes, A. Meredith;
Carter, Evan S.;
Flaherty, Kevin;
Lambros, Zachary;
Pan, Margaret;
Schlichting, Hilke;
Chiang, Eugene;
Wyatt, Mark;
Wilner, David;
Andrews, Sean;
Carpenter, John
Submitted: 2019-03-29, last modified: 2019-04-08
The vertical distribution of dust in debris disks is sensitive to the number
and size of large planetesimals dynamically stirring the disk, and is therefore
well-suited for constraining the prevalence of otherwise unobservable Uranus
and Neptune analogs. Information regarding stirring bodies has previously been
inferred from infrared and optical observations of debris disk vertical
structure, but theoretical works predict that the small particles traced by
short-wavelength observations will be `puffed up' by radiation pressure,
yielding only upper limits. The large grains that dominate the disk emission at
millimeter wavelengths are much less sensitive to the effects of stellar
radiation or stellar winds, and therefore trace the underlying mass
distribution more directly. Here we present ALMA 1.3 mm dust continuum
observations of the debris disk around the nearby M star AU Mic. The 3 au
spatial resolution of the observations, combined with the favorable edge-on
geometry of the system, allows us to measure the vertical thickness of the
disk. We report a scale height-to-radius aspect ratio of $h =
0.031_{-0.004}^{+0.005}$ between radii of $\sim 23$ au and $\sim 41$ au.
Comparing this aspect ratio to a theoretical model of size-dependent velocity
distributions in the collisional cascade, we find that the perturbing bodies
embedded in the local disk must be larger than about 400 km, and the largest
perturbing body must be smaller than roughly 1.8 M$_\odot$. These measurements
rule out the presence of a gas giant or Neptune analog near the $\sim 40$ au
outer edge of the debris ring, but are suggestive of large planetesimals or an
Earth-sized planet stirring the dust distribution.
[2]
oai:arXiv.org:1710.00703 [pdf] - 1599732
CO emission tracing a warp or radial flow within $\lesssim$ 100 au in
the HD 100546 protoplanetary disk
Submitted: 2017-10-02, last modified: 2017-12-06
We present spatially resolved ALMA images of CO J=3-2 emission from the
protoplanetary disk around HD100546. We model the spatially-resolved kinematic
structure of the CO emission. Assuming a velocity profile which prescribes a
flat or flared emitting surface in Keplerian rotation, we uncover significant
residuals with a peak of $\approx7\delta v$, where $\delta v = 0.21$ km
s$^{-1}$ is the width of a spectral resolution element. The residuals reveal
the possible presence of a severely warped and twisted inner disk extending to
at most 100au. Adapting the model to include a misaligned inner gas disk with
(i) an inclination almost edge-on to the line of sight, and (ii) a position
angle almost orthogonal to that of the outer disk reduces the residuals to $<
3\delta v$. However, these findings are contrasted by recent VLT/SPHERE,
MagAO/GPI, and VLTI/PIONIER observations of HD100546 that show no evidence of a
severely misaligned inner dust disk down to spatial scales of $\sim 1$au. An
alternative explanation for the observed kinematics are fast radial flows
mediated by (proto)planets. Inclusion of a radial velocity component at close
to free-fall speeds and inwards of $\approx 50$au results in residuals of
$\approx 4 \delta v$. Hence, the model including a radial velocity component
only does not reproduce the data as well as that including a twisted and
misaligned inner gas disk. Molecular emission data at a higher spatial
resolution (of order 10au) are required to further constrain the kinematics
within $\lesssim 100$au. HD100546 joins several other protoplanetary disks for
which high spectral resolution molecular emission shows that the gas velocity
structure cannot be described by a purely Keplerian velocity profile with a
universal inclination and position angle. Regardless of the process, the most
likely cause is the presence of an unseen planetary companion. (Abridged)
[3]
oai:arXiv.org:1704.01972 [pdf] - 1567764
Radial Surface Density Profiles of Gas and Dust in the Debris Disk
around 49 Ceti
Hughes, A. M.;
Lieman-Sifry, J.;
Flaherty, K. M.;
Daley, C. M.;
Roberge, A.;
Kospal, A.;
Moor, Attila;
Kamp, Inga;
Wilner, D. J.;
Andrews, S. M.;
Kastner, J. H.;
Abraham, P.
Submitted: 2017-04-06
We present ~0.4 resolution images of CO(3-2) and associated continuum
emission from the gas-bearing debris disk around the nearby A star 49 Ceti,
observed with the Atacama Large Millimeter/Submillimeter Array (ALMA). We
analyze the ALMA visibilities in tandem with the broad-band spectral energy
distribution to measure the radial surface density profiles of dust and gas
emission from the system. The dust surface density decreases with radius
between ~100 and 310 au, with a marginally significant enhancement of surface
density at a radius of ~110 au. The SED requires an inner disk of small grains
in addition to the outer disk of larger grains resolved by ALMA. The gas disk
exhibits a surface density profile that increases with radius, contrary to most
previous spatially resolved observations of circumstellar gas disks. While ~80%
of the CO flux is well described by an axisymmetric power-law disk in Keplerian
rotation about the central star, residuals at ~20% of the peak flux exhibit a
departure from axisymmetry suggestive of spiral arms or a warp in the gas disk.
The radial extent of the gas disk (~220 au) is smaller than that of the dust
disk (~300 au), consistent with recent observations of other gas-bearing debris
disks. While there are so far only three broad debris disks with well
characterized radial dust profiles at millimeter wavelengths, 49 Ceti's disk
shows a markedly different structure from two radially resolved gas-poor debris
disks, implying that the physical processes generating and sculpting the gas
and dust are fundamentally different.