We use The Sun Watcher with Active Pixel System detector and Image Processing (SWAP) imager onboard the Project for Onboard Autonomy 2 (PROBA2) mission to study the evolution of large-scale EUV structures in the solar corona observed throughout Solar Cycle 24 (from 2010 to 2019). We discuss the evolution of the on-disk coronal features and at different heights above the solar surface based on EUV intensity changes. We also look at the evolution of the corona in equatorial and polar regions and compare them at different phases of the solar cycle, as well as with sunspot number evolution and with the PROBA2/Lyman-Alpha Radiometer (LYRA) signal. The main results are as follows: The three time series (SWAP on-disk average brightness, sunspot number and LYRA irradiance) are very well correlated, with correlation coefficients around 0.9. The average rotation rate of bright features at latitudes of +15, 0, and -15 degrees was around 15 degree/day throughout the period studied. A secondary peak in EUV averaged intensity at the Poles was observed on the descending phase of SC24. These peaks (at North and South poles respectively) seem to be associated with the start of the development of the (polar) coronal holes. Large-scale off-limb structures were visible from around March 2010 to around March 2016, meaning that they were absent at the minimum phase of solar activity. A fan at the North pole persisted for more than 11 Carrington rotations (February 2014 to March 2015), and it could be seen up to altitudes of 1.6 Rs.

Methods: Stealth CMEs represent a particular class of solar eruptions that are clearly distinguished in coronagraph observations, but they don't have a clear source signature. A particular type of stealth CMEs occurs in the trailing current sheet of a previous ejection, therefore, we used the 2.5D MHD package of the code MPI-AMRVAC to numerically simulate consecutive CMEs by imposing shearing motions onto the inner boundary. The initial magnetic configuration consists of a triple arcade structure embedded into a bimodal solar wind, and the sheared polarity inversion line is found in the southern loop system. The mesh was continuously adapted through a refinement method that applies to current carrying structures. We then compared the obtained eruptions with the observed directions of propagation of an initial multiple coronal mass ejection (MCME) event that occurred in September 2009. We further analysed the simulated ejections by tracking the centre of their flux ropes in latitude and their total speed. Radial Poynting flux computation was employed as well to follow the evolution of electromagnetic energy introduced into the system. Results: Changes within 1\% in the shearing speed result in three different scenarios for the second CME, although the preceding eruption seems insusceptible to such small variations. Depending on the applied shearing speed, we thus obtain a failed eruption, a stealth, or a CME driven by the imposed shear, as the second ejection. The dynamics of all eruptions are compared with the observed directions of propagation of an MCME event and a good correlation is achieved. The Poynting flux analysis reveals the temporal variation of the important steps of eruptions. For the first time, a stealth CME is simulated in the aftermath of a first eruption, through changes in the applied shearing speed.

We present the evolution of a coronal cavity encompassing its quiescent and eruptive phases in the lower corona. Using the multi-vantage point observations from the SDO/AIA, STEREO SECCHI/EUVI and PROBA2/SWAP EUV imagers, we capture the sequence of quasi-static equilibria of the quiescent cavity which exhibited a slow rise and expansion phase during its passage on the solar disc from 2010 May 30 to 2010 June 13. By comparing the decay-index profiles of the cavity system during the different stages of its quiescent and pre-eruptive phases we find that the decay-index value at the cavity centroid height can be used as a good indicator to predict the cavity eruption in the context of torus instability. Combining the observations of SWAP and LASCO C2/C3 we show the evolution of the EUV cavity into the white-light cavity as a three-part structure of the associated CME observed to erupt on 2010 June 13. By applying successive geometrical fits to the cavity morphology we find that the cavity exhibited non self-similar expansion in the lower corona, below 2.2 +/- 0.2 Rs, which points to the spatial scale for the radius of source surface where the coronal magnetic field lines are believed to become radial. Furthermore, the kinematic study of the erupting cavity captures both the "impulsive" and "residual" phases of acceleration along with a strong deflection of the cavity at 1.3 Rs. We also discuss the role of driving forces behind the dynamics of the morphological and kinematic evolution of the cavity.

We have measured the root-mean-square (RMS) amplitude of intensity fluctuations, $\Delta I$, in plume and interplume regions of a polar coronal hole. These intensity fluctuations correspond to density fluctuations. Using data from the \rev{Sun Watcher using Active Pixel System detector and Image Processing} (SWAP) on \textit{Project for Onboard Autonomy (Proba2)}, our results extend up to a height of about 1.35~$R_{\sun}$. One advantage of the RMS analysis is that it does not rely on a detailed evaluation of the power spectrum, which is limited by noise levels to low heights in the corona. The RMS approach can be performed up to larger heights where the noise level is greater, provided that the noise itself can be quantified. At low heights, both the absolute $\Delta I$, and the amplitude relative to the mean intensity, $\Delta I/I$, decrease with height. However, starting at about 1.2~$R_{\sun}$ $\Delta I/I$ increases, reaching 20--40\% by 1.35~$R_{\sun}$. This corresponds to density fluctuations of $\Delta n_{\mathrm{e}}/n_{\mathrm{e}} \approx$~10--20\%. The increasing relative amplitude implies that the density fluctuations are generated in the corona itself. One possibility is that the density fluctuations are generated by an instability of Alfv\'en waves. This generation mechanism is consistent with some theoretical models and with observations of Alfv\'en wave amplitudes in coronal holes. Although we find that the energy of the observed density fluctuations is small, these fluctuations are likely to play an important indirect role in coronal heating by promoting the reflection of Alfv\'en waves and driving turbulence.

On 2010 August 14, a wide-angled coronal mass ejection (CME) was observed. This solar eruption originated from a destabilized filament that connected two active regions and the unwinding of this filament gave the eruption an untwisting motion that drew the attention of many observers. In addition to the erupting filament and the associated CME, several other low-coronal signatures that typically indicate the occurrence of a solar eruption were associated to this event. However, contrary to what is expected, the fast CME ($\mathrm{v}>900~\mathrm{km}~\mathrm{s}^{-1}$) was accompanied by only a weak C4.4 flare. We investigate the various eruption signatures that were observed for this event and focus on the kinematic evolution of the filament in order to determine its eruption mechanism. Had this solar eruption occurred just a few days earlier, it could have been a significant event for space weather. The risk to underestimate the strength of this eruption based solely on the C4.4 flare illustrates the need to include all eruption signatures in event analyses in order to obtain a complete picture of a solar eruption and assess its possible space weather impact.

Many natural processes exhibit power-law behavior. The power-law exponent is linked to the underlying physical process and therefore its precise value is of interest. With respect to the energy content of nanoflares, for example, a power-law exponent steeper than 2 is believed to be a necessary condition to solve the enigmatic coronal heating problem. Studying power-law distributions over several orders of magnitudes requires sufficient data and appropriate methodology. In this paper we demonstrate the shortcomings of some popular methods in solar physics that are applied to data of typical sample sizes. We use synthetic data to study the effect of the sample size on the performance of different estimation methods and show that vast amounts of data are needed to obtain a reliable result with graphical methods (where the power-law exponent is estimated by a linear fit on a log-transformed histogram of the data). We revisit published results on power laws for the angular width of solar coronal mass ejections and the radiative losses of nanoflares. We demonstrate the benefits of the maximum likelihood estimator and advocate its use.

Solar eruptions are usually associated with a variety of phenomena occurring in the low corona before, during, and after onset of eruption. Though easily visible in coronagraph observations, so-called stealth coronal mass ejections (CMEs) do not obviously exhibit any of these low-coronal signatures. The presence or absence of distinct low coronal signatures can be linked to different theoretical models to establish the mechanisms by which the eruption is initiated and driven. In this study, 40 CMEs without low coronal signatures, occurring in 2012, are identified. Their observational and kinematic properties are analyzed and compared to those of regular CMEs. Solar eruptions without clear on-disk or low coronal signatures can lead to unexpected space weather impacts, since many early warning signs for significant space weather activity are not present in these events. A better understanding of their initiation mechanism(s) will considerably improve the ability to predict such space weather events.

The Sun Watcher with Active Pixels and Image Processing (SWAP) is an EUV solar telescope on board ESA's Project for Onboard Autonomy 2 (PROBA2) mission launched on 2 November 2009. SWAP has a spectral bandpass centered on 17.4 nm and provides images of the low solar corona over a 54x54 arcmin field-of-view with 3.2 arcsec pixels and an imaging cadence of about two minutes. SWAP is designed to monitor all space-weather-relevant events and features in the low solar corona. Given the limited resources of the PROBA2 microsatellite, the SWAP telescope is designed with various innovative technologies, including an off-axis optical design and a CMOS-APS detector. This article provides reference documentation for users of the SWAP image data.