The paper describes the project, implementation and test of a C-band (5GHz) Low Noise Amplifier (LNA) using new low noise Pseudomorphic High Electron Mobility Transistors (pHEMTS) from Avago. The amplifier was developed to be used as a cost effective solution in a receiver chain for Galactic Emission Mapping (GEM-P) project in Portugal with the objective of finding affordable solutions not requiring strong cryogenic operation, as is the case of massive projects like the Square Kilometer Array (SKA), in Earth Sensing projects and other niches like microwave reflectometry. The particular application and amplifier requirements are first introduced. Several commercially available low noise devices were selected and the noise performance simulated. An ultra-low noise pHEMT was used for an implementation that achieved a Noise Figure of 0.6 dB with 13 dB gain at 5 GHz. The design, simulation and measured results of the prototype are presented and discussed.

In the context of the Galactic Emission Mapping, a new receiver at 5GHz was developed to characterize the galactic foreground to the Cosmic Microwave Background Radiation. This is a 5GHz super heterodyne polarimeter with double down conversion, with a high gain IF chain using the latest RF technology working at 600MHz central frequency that feeds a four channel digital correlator. This paper describes the receiver and its current status. Design options and constraints are presented with some simulations and experimental results of a circuit prototype.

The international Galactic Emission Mapping project aims to map and characterize the polarization field of the Milky Way. In Portugal it will cartograph the C-band sky polarized emission of the Northern Hemisphere and provide templates for map calibration and foreground control of microwave space probes like ESA Planck Surveyor mission. The receiver system is equipped with a novel receiver with a full digital back-end using an Altera Field Programmable Gate Array, having a very favorable cost/performance relation. This new digital backend comprises a base-band complex cross-correlator outputting the four Stokes parameters of the incoming polarized radiation. In this document we describe the design and implementation of the complex correlator using COTS components and a processing FPGA, detailing the method applied in the several algorithm stages and suitable for large sky area surveys.

In the context of the Galactic Emission Mapping collaboration, a galactic survey at 5GHz is in preparation to properly characterize the galactic foreground to the Cosmic Microwave Background Radiation (CMBR). For the North sky survey, a new receiver is being developed. This 5GHz heterodyne polarimeter has a high gain IF (intermediate frequency) chain using the latest RF technology and microstrip design that we describe in the present article. Working at 600MHz central frequency, it consists of a pre-amplifier with an integral band-pass filter followed by an amplifier with digitally controlled gain and a frequency converter to zero-IF that feeds the ADC of a four channel digital correlator (outside the scope of the present article). This paper focuses the design options and constraints and presents the simulations and experimental results of a circuit prototype.

We probed for Radio Frequency Interference (RFI) for the three potential Galactic Emission Mapping Experiment (GEM) sites at Portugal using custom made omnidirectional disconic antennas. For the installation of a 10-meter dish dedicated to the mapping of Polarized Galactic Emission foreground planned for 2005-2007 in the 5-10 GHz band, the three sites chosen as suitable to host the antenna were surveyed for local radio pollution in the frequency range [0.01-10] GHz. Tests were done to look for radio broadcasting and mobile phone emission lines in the radio spectrum. The results show one of the sites to be almost entirely RFI clean and showing good conditions to host the experiment.