The current model of planet formation lacks a good understanding of the growth of dust particles inside the protoplanetary disk beyond mm sizes. In order to investigate the low-velocity collisions between this type of particles, the NanoRocks experiment was flown on the International Space Station (ISS) between September 2014 and March 2016. We present the results of this experiment. We quantify the damping of energy in systems of multiple particles in the 0.1 to 1 mm size range while they are in the bouncing regime, and study the formation of clusters through sticking collisions between particles. We developed statistical methods for the analysis of the large quantity of collision data collected by the experiment. We measured the average motion of particles, the moment of clustering, and the cluster size formed. In addition, we ran simple numerical simulations in order to validate our measurements. We computed the average coefficient of restitution (COR) of collisions and find values ranging from 0.55 for systems including a population of fine grains to 0.94 for systems of denser particles. We also measured the sticking threshold velocities and find values around 1 cm/s, consistent with the current dust collision models based on independently collected experimental data. Our findings have the following implications that can be useful for the simulation of particles in PPDs and planetary rings: (1) The average COR of collisions between same-sized free-floating particles at low speeds (< 2 cm/s) is not dependent on the collision velocity; (2) The simplified approach of using a constant COR value will accurately reproduce the average behavior of a particle system during collisional cooling; (3) At speeds below 5 mm/s, the influence of particle rotation becomes apparent on the collision behavior; (4) Current dust collision models predicting sticking thresholds are robust.

One of the most intriguing facets of Saturn's rings are the sharp edges of gaps in the rings where the surface density abruptly drops to zero. This is despite of the fact that the range over which a moon transfers angular momentum onto the ring material is much larger. Recent UVIS-scans of the edges of the Encke and Keeler gap show that this drop occurs over a range approximately equal to the rings' thickness. Borderies et al. (1982, 1989) show that this striking feature is likely related to the local reversal of the usually outward directed viscous transport of angular momentum in strongly perturbed regions. In this article we revise the Borderies et al. (1989) model using a granular flow model to define the shear and bulk viscosities and incorporate the angular momentum flux reversal effect into the axisymmetric diffusion model we developed for gaps in dense planetary rings (Gr\"atz et al. 2018). Finally, we apply our model to the Encke and Keeler division in order to estimate the shear and bulk viscosities in the vicinity of both gaps.

The dusty regolith covering the surfaces of asteroids and planetary satellites differs in size, shape, and composition from terrestrial soil particles and is subject to very different environmental conditions. Experimental studies of the response of planetary regolith in the relevant environmental conditions are thus necessary to facilitate future Solar System exploration activities. We combined the results and provided new data analysis elements for a series of impact experiments into simulated planetary regolith in low-gravity conditions using two experimental setups: the Physics of Regolith Impacts in Microgravity Experiment (PRIME) and the COLLisions Into Dust Experiment (COLLIDE). Results of these experimental campaigns found that there is a significant change in the regolith behavior with the gravity environment. In a 10-2g environment (Lunar g levels), only embedding of the impactor was observed and ejecta production was produced for most impacts at > 20 cm/s. Once at microgravity levels (<10-4g), the lowest impact energies also produced impactor rebound. In these microgravity conditions, ejecta started to be produced for impacts at > 10 cm/s. The measured ejecta speeds were lower than the ones measured at reduced-gravity levels, but the ejected masses were higher. The mean ejecta velocity shows a power-law dependence on the impact energy with an index of ~0.7. When projectile rebound occurred, we observed that its coefficients of restitution on the bed of regolith simulant decrease by a factor of 10 with increasing impact speeds from ~5 cm/s up to 100 cm/s. We could also observe an increased cohesion between the JSC-1 grains compared to the quartz sand targets.

Future remote sensing of exoplanets will be enhanced by a thorough investigation of our solar system Ice Giants (Neptune-size planets). What can the configuration of the magnetic field tell us (remotely) about the interior, and what implications does that field have for the structure of the magnetosphere; energy input into the atmosphere, and surface geophysics (for example surface weathering of satellites that might harbour sub-surface oceans). How can monitoring of auroral emission help inform future remote observations of emission from exoplanets? Our Solar System provides the only laboratory in which we can perform in-situ experiments to understand exoplanet formation, dynamos, systems and magnetospheres.

In an effort to better understand the early stages of planet formation, we have developed a 1.5U payload that flew on the International Space Station (ISS) in the NanoRacks NanoLab facility between September 2014 and March 2016. This payload, named NanoRocks, ran a particle collision experiment under long-term microgravity conditions. The objectives of the experiment were (a) to observe collisions between mm-sized particles at relative velocities of $<$1~cm/s, and (b) to study the formation and disruption of particle clusters for different particle types and collision velocities. Four types of particles were used: mm-sized acrylic, glass, and copper beads, and 0.75 mm-sized JSC-1 lunar regolith simulant grains. The particles were placed in sample cells carved out of an aluminum tray. This tray was attached to one side of the payload casing with three springs. Every 60~s, the tray was agitated and the resulting collisions between the particles in the sample cells were recorded by the experiment camera. During the 18 months the payload stayed on ISS, we obtained 158 videos, thus recording a great number of collisions. The average particle velocities in the sample cells after each shaking event were around 1 cm/s. After shaking stopped, the inter-particle collisions damped the particle kinetic energy in less than 20~s, reducing the average particle velocity to below 1 mm/s, and eventually slowing them to below our detection threshold. As the particle velocity decreased, we observed the transition from bouncing to sticking collisions. We recorded the formation of particle clusters at the end of each experiment run. This paper describes the design and performance of the NanoRocks ISS payload.

We have performed detailed dynamical modeling of the structure of a faint dust band observed in coadded IRAS data at an ecliptic latitude of 17$^{\circ}$ that convincingly demonstrates that it is the result of a relatively recent (significantly less than 1 Ma) disruption of an asteroid and is still in the process of forming. We show here that young dust bands retain information on the size distribution and cross-sectional area of dust released in the original asteroid disruption, before it is lost to orbital and collisional decay. We find that the Emilkowalski cluster is the source of this partial band and that the dust released in the disruption would correspond to a regolith layer $\sim$3 m deep on the $\sim$10 km diameter source body's surface. The dust in this band is described by a cumulative size-distribution inverse power-law index with a lower bound of 2.1 (implying domination of cross-sectional area by small particles) for dust particles with diameters ranging from a few $\mu$m up to a few cm. The coadded observations show that the thermal emission of the dust band structure is dominated by large (mm--cm size) particles. We find that dust particle ejection velocities need to be a few times the escape velocity of the Emilkowalski cluster source body to provide a good fit to the inclination dispersion of the observations. We discuss the implications that such a significant release of material during a disruption has for the temporal evolution of the structure, composition, and magnitude of the zodiacal cloud.