We investigated how a target's porosity affects the outcome of a collision, with respect to the impactor's fate. Laboratory impact experiments using peridot projectiles were performed at a speed range between 0.3 and 3.0 km/s, onto high porosity water-ice (40%) and fine-grained calcium carbonate (70%) targets. We report that the amount of implanted material in the target body increases with increasing target's porosity, while the size frequency distribution of the projectile's ejecta fragments becomes steeper. A supplementary Raman study showed no sign of change of the Raman spectra of the recovered olivine projectile fragments indicate minimal physical change.

Recent observations of asteroidal surfaces indicate the presence of materials that do not match the bulk lithology of the body. A possible explanation for the presence of these exogenous materials is that they are products of inter-asteroid impacts in the Main Belt, and thus interest has increased in understanding the fate of the projectile during hypervelocity impacts. In order to gain insight into the fate of impactor we have carried out a laboratory programme, covering the velocity range of 0.38 - 3.50 km/s, devoted to measuring the survivability, fragmentation and final state of the impactor. Forsterite olivine and synthetic basalt projectiles were fired onto low porosity (<10%) pure water-ice targets using the University of Kent's Light Gas Gun (LGG). We developed a novel method to identify impactor fragments which were found in ejecta and implanted into the target. We applied astronomical photometry techniques, using the SOURCE EXTRACTOR software, to automatically measure the dimensions of thousands of fragments. This procedure enabled us to estimate the implanted mass on the target body, which was found to be a few percent of the initial mass of the impactor. We calculated an order of magnitude difference in the energy density of catastrophic disruption, Q*, between peridot and basalt projectiles. However, we found very similar behaviour of the size frequency distributions for the hypervelocity shots (>1 km/s). After each shot, we examined the largest peridot fragments with Raman spectroscopy and no melt or alteration in the final state of the projectile was observed.

The known encounter velocity (6.1kms-1) and particle incidence angle (perpendicular) between the Stardust spacecraft and the dust emanating from the nucleus of comet Wild 2 fall within a range that allows simulation in laboratory light gas gun experiments designed to validate analytical methods for the interpretation of dust impacts on the aluminum foil components of the Stardust collector. Buckshot of a wide size, shape and density range of mineral, glass, polymer and metal grains, have been fired to impact perpendicularly upon samples of Stardust Al1100 foil, tightly wrapped onto aluminium alloy plate as an analogue of foil on the spacecraft collector. We have not yet been able to produce laboratory impacts by projectiles with weak and porous aggregate structure, as may occur in some cometary dust grains. In this report we present information on crater gross morphology and its dependence on particle size and density, the pre-existing major and trace element composition of the foil, geometrical issues for energy dispersive X-ray analysis of the impact residues in scanning electron microscopes, and the modification of dust chemical composition during creation of impact craters as revealed by analytical transmission electron microscopy. Together, these observations help to underpin the interpretation of size, density and composition for particles impacted upon the Stardust aluminum foils.