Standing shocks are believed to be responsible for stationary Type II solar radio bursts, whereas drifting Type II bursts are excited by moving shocks often related to coronal mass ejections (CMEs). Observations of either stationary or drifting Type II bursts are common, but a transition between the two states has not yet been reported. Here, we present a Type II burst which shows a clear, continuous transition from a stationary to a drifting state, the first observation of its kind. Moreover, band splitting is observed in the stationary parts of the burst, as well as intriguing negative and positive frequency-drift fine structures within the stationary emissions. The relation of the radio emissions to an observed jet and a narrow CME was investigated across multiple wavelengths, and the mechanisms leading to the transitioning Type II burst were determined. We find that a jet eruption generates a streamer-puff CME and that the interplay between the CME-driven shock and the streamer is likely to be responsible for the observed radio emissions.

The observed properties (i.e., source size, source position, time duration, decay time) of solar radio emission produced through plasma processes near the local plasma frequency, and hence the interpretation of solar radio bursts, are strongly influenced by propagation effects in the inhomogeneous turbulent solar corona. In this work, a 3D stochastic description of the propagation process is presented, based on the Fokker-Planck and Langevin equations of radio-wave transport in a medium containing anisotropic electron density fluctuations. Using a numerical treatment based on this model, we investigate the characteristic source sizes and burst decay times for Type III solar radio bursts. Comparison of the simulations with the observations of solar radio bursts shows that predominantly perpendicular density fluctuations in the solar corona are required, with an anisotropy factor $\sim 0.3$ for sources observed at around 30~MHz. The simulations also demonstrate that the photons are isotropized near the region of primary emission, but the waves are then focused by large-scale refraction, leading to plasma radio emission directivity that is characterized by a half-width-half-maximum of about 40~degrees near 30~MHz. The results are applicable to various solar radio bursts produced via plasma emission.

Coronal Mass Ejections (CMEs) are believed to be effective in producing shocks in the solar corona and the interplanetary space. One of the important signatures of shocks and shock acceleration are Type II solar radio bursts that drift with the shock speed and produce bands of fundamental and higher harmonic plasma radio emission. An intriguing aspect of Type II radio bursts is the occasional split of a harmonic band into thinner lanes, known as band-splitting. Here, we report a detailed imaging and spectroscopic observation of a CME-driven shock producing band-splitting in a Type II burst. Using the Low Frequency Array (LOFAR), we examine the spatial and temporal relation of the Type II burst to the associated CME event, use source imaging to calculate the apparent coronal density, and demonstrate how source imaging can be used to estimate projection effects. We consider two widely accepted band-splitting models that make opposing predictions regarding the locations of the true emission sources with respect to the shock front. Our observations suggest that the locations of the upper and lower sub-band sources are spatially separated by $\sim 0.2 \pm 0.05 \, \mathrm{R_\odot}$. However, we quantitatively show, for the first time, that such separation is consistent with radio-wave scattering of plasma radio emission from a single region, implying that the split-band Type II sources could originate from nearly co-spatial locations. Considering the effects of scattering, the observations provide supporting evidence for the model that interprets the band-splitting as emission originating in the upstream and downstream regions of the shock front, two virtually co-spatial areas.