Getting insights into the 3D structure of the solar coronal magnetic field have been done in the past by two completely different approaches: (1.) Nonlinear force-free field (NLFFF) extrapolations, which use photospheric vector magnetograms as boundary condition. (2.) Stereoscopy of coronal magnetic loops observed in EUV coronal images from different vantage points. Both approaches have their strength and weaknesses. Extrapolation methods are sensitive to noise and inconsistencies in the boundary data and the accuracy of stereoscopy is affected by the ability of identifying the same structure in different images and by the separation angle between the view directions. As a consequence, for the same observational data, the computed 3D coronal magnetic field with the two methods do not necessarily coincide. In an earlier work (Paper I) we extended our NLFFF optimization code by the inclusion of stereoscopic constrains. The method was successfully tested with synthetic data and within this work we apply the newly developed code to a combined data-set from SDO/HMI, SDO/AIA and the two STEREO spacecraft. The extended method (called S-NLFFF) contains an additional term that monitors and minimizes the angle between the local magnetic field direction and the orientation of the 3D coronal loops reconstructed by stereoscopy. We find that prescribing the shape of the 3D stereoscopically reconstructed loops the S-NLFFF method leads to a much better agreement between the modeled field and the stereoscopically reconstructed loops. We also find an appreciable decrease by a factor of two in the angle between the current and the magnetic field which indicates the improved quality of the force-free solution obtained by S-NLFFF.

Observations of the early rise and propagation phases of solar eruptive prominences can provide clues about the forces acting on them through the behavior of their acceleration with height. We have analyzed such an event, observed on 13 April 2010 by SWAP on PROBA2 and EUVI on STEREO. A feature at the top of the erupting prominence was identified and tracked in images from the three spacecraft. The triangulation technique was used to derive the true direction of propagation of this feature. The reconstructed points were fitted with two mathematical models: i) a power-law polynomial function and ii) a cubic smoothing spline, in order to derive the accelerations. The first model is characterized by five degrees of freedom while the second one is characterized by ten degrees of freedom. The results show that the acceleration increases smoothly and it is continuously increasing with height. We conclude that the prominence is not accelerated immediately by local reconnection but rather is swept away as part of a large-scale relaxation of the coronal magnetic field.

In white-light coronagraph images, cool prominence material is sometimes observed as bright patches in the core of coronal mass ejections (CMEs). If, as generally assumed, this emission is caused by Thomson-scattered light from the solar surface, it should be strongly polarised tangentially to the solar limb. However, the observations of a CME made with the SECCHI/STEREO coronagraphs on 31 August 2007 show that the emission from these bright core patches is exceptionally low polarised. We used the polarisation ratio method of Moran and Davila (2004) to localise the barycentre of the CME cloud. By analysing the data from both STEREO spacecraft we could resolve the plane-of-the-sky ambiguity this method usually suffers from. Stereoscopic triangulation was used to independently localise the low-polarisation patch relative to the cloud. We demonstrated for the first time that the bright core material is located close to the centre of the CME cloud. We show that the major part of the CME core emission, more than 85% in our case, is H$\alpha$ radiation and only a small fraction is Thomson-scattered light. Recent calculations also imply that the plasma density in the patch is 8 10$^8$ cm$^{-3}$ or more compared to 2.6 10$^6$ cm$^{-3}$ for the Thomson-scattering CME environment surrounding the core material.