The European Space Agency Gaia satellite was launched into orbit around L2 in December 2013. This ambitious mission has strict requirements on residual systematic errors resulting from instrumental corrections in order to meet a design goal of sub-10 microarcsecond astrometry. During the design and build phase of the science instruments, various critical calibrations were studied in detail to ensure that this goal could be met in orbit. In particular, it was determined that the video-chain offsets on the analogue side of the analogue-to-digital conversion electronics exhibited instabilities that could not be mitigated fully by modifications to the flight hardware. We provide a detailed description of the behaviour of the electronic offset levels on microsecond timescales, identifying various systematic effects that are known collectively as offset non-uniformities. The effects manifest themselves as transient perturbations on the gross zero-point electronic offset level that is routinely monitored as part of the overall calibration process. Using in-orbit special calibration sequences along with simple parametric models, we show how the effects can be calibrated, and how these calibrations are applied to the science data. While the calibration part of the process is relatively straightforward, the application of the calibrations during science data processing requires a detailed on-ground reconstruction of the readout timing of each charge-coupled device (CCD) sample on each device in order to predict correctly the highly time-dependent nature of the corrections. We demonstrate the effectiveness of our offset non-uniformity models in mitigating the effects in Gaia data. We demonstrate for all CCDs and operating instrument and modes on board Gaia that the video-chain noise-limited performance is recovered in the vast majority of science samples.

This paper presents the specification, design, and development of the Radial Velocity Spectrometer (RVS) on the European Space Agency's Gaia mission. Starting with the rationale for the full six dimensions of phase space in the dynamical modelling of the Galaxy, the scientific goals and derived top-level instrument requirements are discussed, leading to a brief description of the initial concepts for the instrument. The main part of the paper is a description of the flight RVS, considering the optical design, the focal plane, the detection and acquisition chain, and the as-built performance drivers and critical technical areas. After presenting the pre-launch performance predictions, the paper concludes with the post-launch developments and mitigation strategies, together with a summary of the in-flight performance at the end of commissioning.

The Gaia all-sky astrometric survey is challenged by several issues affecting the spacecraft stability. Amongst them, we find the focus evolution, straylight and basic angle variations Contrary to pre-launch expectations, the image quality is continuously evolving, during commissioning and the nominal mission. Payload decontaminations and wavefront sensor assisted refocuses have been carried out to recover optimum performance. Straylight and basic angle variations several orders of magnitude greater than foreseen were found and studied during commissioning by the Gaia scientists (payload experts). Building on their investigations, an ESA-Airbus DS working group was established during the early nominal mission and worked on a detailed root cause analysis. In parallel, Gaia scientists have also continued analysing the data, most notably comparing the BAM signal to global astrometric solutions, with remarkable agreement. In this contribution, a status review of these issues will be provided, with emphasis on the mitigation schemes and the lessons learned for future space missions where extreme stability is a key requirement.

The ESA Gaia mission uses two telescopes to create the most ambitious survey of the Galaxy. The angle between them must be known with exquisite precision and accuracy. An interferometer: the Basic Angle Monitoring system measures its variations. High quality data have been retrieved and analysed for more than a year. A summary of the in-orbit performance and some early results are presented

The Gaia payload ensures maximum passive stability using a single material, SiC, for most of its elements. Dedicated metrology instruments are, however, required to carry out two functions: monitoring the basic angle and refocusing the telescope. Two interferometers fed by the same laser are used to measure the basic angle changes at the level of $\mu$as (prad, micropixel), which is the highest level ever achieved in space. Two Shack-Hartmann wavefront sensors, combined with an ad-hoc analysis of the scientific data are used to define and reach the overall best-focus. In this contribution, the systems, data analysis, procedures and performance achieved during commissioning are presented