With an estimated diameter in the 320 to 350 km range, (704) Interamnia is the fifth largest main belt asteroid and one of the few bodies that fills the gap in size between the four largest bodies with $D$ > 400 km (Ceres, Vesta, Pallas and Hygiea) and the numerous smaller bodies with $D$ $\lesssim$ 200 km. However, despite its large size, little is known about the shape and spin state of Interamnia and, therefore, about its bulk composition and past collisional evolution. We aimed to test at what size and mass the shape of a small body departs from a nearly ellipsoidal equilibrium shape (as observed in the case of the four largest asteroids) to an irregular shape as routinely observed in the case of smaller ($D$ $\lesssim$ 200 km) bodies. We observed Interamnia as part of our ESO VLT/SPHERE large program (ID: 199.C-0074) at thirteen different epochs. In addition, several new optical lightcurves were recorded. These data, along with stellar occultation data from the literature, were fed to the All-Data Asteroid Modeling (ADAM) algorithm to reconstruct the 3D-shape model of Interamnia and to determine its spin state. Interamnia's volume-equivalent diameter of 332 $\pm$ 6 km implies a bulk density of $\rho$=1.98 $\pm$ 0.68 gcm$^{-3}$ , which suggests that Interamnia - like Ceres and Hygiea - contains a high fraction of water ice, consistent with the paucity of apparent craters. Our observations reveal a shape that can be well approximated by an ellipsoid, and that is compatible with a fluid hydrostatic equilibrium at the 2 $\sigma$ level. The rather regular shape of Interamnia implies that the size and mass limit, under which the shapes of minor bodies with a high amount of water ice in the subsurface become irregular, has to be searched among smaller ($D$ $\lesssim$ 300km) less massive ($m$ $\lesssim$ 3x10$^{19}$ kg) bodies.

We present physical models, i.e. convex shapes, directions of the rotation axis, and sidereal rotation periods, of 18 asteroids out of which 10 are new models and 8 are refined models based on much larger data sets than in previous work. The models were reconstructed by the lightcurve inversion method from archived publicly available lightcurves and our new observations with BlueEye600 robotic observatory. One of the new results is the shape model of asteroid (1663)~van~den~Bos with the rotation period of 749\,hr, which makes it the slowest rotator with known shape. We describe our strategy for target selection that aims at fast production of new models using the enormous potential of already available photometry stored in public databases. We also briefly describe the control software and scheduler of the robotic observatory and we discuss the importance of building a database of asteroid models for studying asteroid physical properties in collisional families.

Asteroid modeling efforts in the last decade resulted in a comprehensive dataset of almost 400 convex shape models and their rotation states. This amount already provided a deep insight into physical properties of main-belt asteroids or large collisional families. We aim to increase the number of asteroid shape models and rotation states. Such results are an important input for various further studies such as analysis of asteroid physical properties in different populations, including smaller collisional families, thermophysical modeling, and scaling shape models by disk-resolved images, or stellar occultation data. This provides, in combination with known masses, bulk density estimates, but constrains also theoretical collisional and evolutional models of the Solar System. We use all available disk-integrated optical data (i.e., classical dense-in-time photometry obtained from public databases and through a large collaboration network as well as sparse-in-time individual measurements from a few sky surveys) as an input for the convex inversion method, and derive 3D shape models of asteroids, together with their rotation periods and orientations of rotation axes. The key ingredient is the support of more that one hundred observers who submit their optical data to publicly available databases. We present updated shape models for 36 asteroids, for which mass estimates are currently available in the literature or their masses will be most likely determined from their gravitational influence on smaller bodies, which orbital deflection will be observed by the ESA Gaia astrometric mission. This was achieved by using additional optical data from recent apparitions for the shape optimization. Moreover, we also present new shape model determinations for 250 asteroids, including 13 Hungarias and 3 near-Earth asteroids.

We determine the temporal evolution of the luminosity L(WD), radius R(WD) and effective temperature Teff of the white dwarf (WD) pseudophotosphere of V339 Del from its discovery to around day 40. Another main objective was studying the ionization structure of the ejecta. These aims were achieved by modelling the optical/near-IR spectral energy distribution (SED) using low-resolution spectroscopy (3500 - 9200 A), UBVRcIc and JHKLM photometry. During the fireball stage (Aug. 14.8 - 19.9, 2013), Teff was in the range of 6000 - 12000 K, R(WD) was expanding non-uniformly in time from around 66 to around 300 (d/3 kpc) R(Sun), and L(WD) was super-Eddington, but not constant. After the fireball stage, a large emission measure of 1.0-2.0E+62 (d/3 kpc)**2 cm**(-3) constrained the lower limit of L(WD) to be well above the super-Eddington value. The evolution of the H-alpha line and mainly the transient emergence of the Raman-scattered O VI 1032 A line suggested a biconical ionization structure of the ejecta with a disk-like H I region persisting around the WD until its total ionization, around day 40. It is evident that the nova was not evolving according to the current theoretical prediction. The unusual non-spherically symmetric ejecta of nova V339 Del and its extreme physical conditions and evolution during and after the fireball stage represent interesting new challenges for the theoretical modelling of the nova phenomenon.

FF Cam is a variable star near the North celestial pole with hydrogen lines in emission. Its optical variability of ~0.3 mag was discovered by HIPPARCOS. The spectral type assigned to the star in SIMBAD is B9, but its position coincides with a ROSAT X-ray source. This suggests the presence of a high-temperature region in the system that could originate at or near a companion object. We undertook a spectroscopic monitoring of FF Cam since the beginning of 2012 and found an extremely variable H-alpha line profile as well as periodically variable radial velocities of numerous absorption lines. The main conclusion from our study is that FF Cam is a binary system with an orbital period of 7.785 days, a B-type primary and a K-type secondary component. We discuss the spectral features, their variations, and the nature of FF Cam.

The larger number of models of asteroid shapes and their rotational states derived by the lightcurve inversion give us better insight into both the nature of individual objects and the whole asteroid population. With a larger statistical sample we can study the physical properties of asteroid populations, such as main-belt asteroids or individual asteroid families, in more detail. Shape models can also be used in combination with other types of observational data (IR, adaptive optics images, stellar occultations), e.g., to determine sizes and thermal properties. We use all available photometric data of asteroids to derive their physical models by the lightcurve inversion method and compare the observed pole latitude distributions of all asteroids with known convex shape models with the simulated pole latitude distributions. We used classical dense photometric lightcurves from several sources and sparse-in-time photometry from the U.S. Naval Observatory in Flagstaff, Catalina Sky Survey, and La Palma surveys (IAU codes 689, 703, 950) in the lightcurve inversion method to determine asteroid convex models and their rotational states. We also extended a simple dynamical model for the spin evolution of asteroids used in our previous paper. We present 119 new asteroid models derived from combined dense and sparse-in-time photometry. We discuss the reliability of asteroid shape models derived only from Catalina Sky Survey data (IAU code 703) and present 20 such models. By using different values for a scaling parameter cYORP (corresponds to the magnitude of the YORP momentum) in the dynamical model for the spin evolution and by comparing synthetics and observed pole-latitude distributions, we were able to constrain the typical values of the cYORP parameter as between 0.05 and 0.6.