sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Chaabouni, H.

Normalized to: Chaabouni, H.

7 article(s) in total. 18 co-authors, from 1 to 7 common article(s). Median position in authors list is 2,0.

[1]  oai:arXiv.org:1801.08897  [pdf] - 1674851
Thermal desorption of formamide and methylamine from graphite and amorphous water ice surfaces
Comments: 7 Figures and 13 pages. Accepted for publication in Astronomy and Astrophysics Journal
Submitted: 2018-01-26
Formamide (NH2CHO) and methylamine (CH3NH2) are known to be the most abundant amine-containing molecules in many astrophysical environments. The presence of these molecules in the gas phase may result from thermal desorption of interstellar ices. The aim of this work is to determine the values of the desorption energies of formamide and methylamine from analogues of interstellar dust grain surfaces and to understand their interaction with water ice. TPD experiments of formamide and methylamine ices were performed in the submonolayer and monolayer regimes on graphite (HOPG) and non-porous amorphous solid water ice surfaces at 40-240 K. The desorption energy distributions of these two molecules were calculated from TPD measurements using a set of independent Polanyi-Wigner equations. The maximum of the desorption of formamide from both graphite and ASW ice surfaces occurs at 176 K after the desorption of H2O molecules, whereas the desorption profile of methylamine depends strongly on the substrate. Solid methylamine starts to desorb below 100 K from the graphite surface. Its desorption from the water ice surface occurs after 120 K and stops during the water ice sublimation around 150 K. It continues to desorb from the graphite surface at temperatures higher than 160 K. More than 95 % of NH2CHO diffuses through the water ice surface towards the graphitic substrate and is released into the gas phase with a desorption energy distribution (7460-9380 K), which is measured with the best-fit pre-exponential factor A=10^18 s-1. However, the desorption energy distribution of methylamine from the np-ASW ice surface (3850-8420 K) is measured with the best-fit pre-exponential factor A=10^12 s-1. A fraction of solid methylamine monolayer of roughly 0.15 diffuses through the water ice surface towards the HOPG substrate. This small amount desorbs later with higher binding energies (5050-8420 K).
[2]  oai:arXiv.org:1707.04063  [pdf] - 1670454
Deuteration of ammonia with D atoms on oxidized partly ASW covered graphite surface
Comments:
Submitted: 2017-07-13, last modified: 2017-07-14
The deuteration of ammonia by D atoms has been investigated experimentally in the sub-monolayer regime on realistic analogues of interstellar dust grain surfaces. About 0.8 monolayer of solid NH3 was deposited on top of an oxidized graphite surface held at 10 K, partly covered with ASW ice. Ammonia ice is subsequently exposed to D atoms for different exposure times using a differentially pumped beam-line. The deuteration experiments of ammonia were carried out by mass spectroscopy and temperature programmed desorption (TPD) technique. The experimental results showed the formation of three isotopologue ammonia species by direct exothermic H-D substitution surface reactions: NH3+D->NH2D+H, NH2D+D->NHD2+H, and NHD2+D->ND3+H. The formation of the deuterated isotopologues NH2D, NHD2, and ND3 at low surface temperature (10 K) is likely to occur through quantum tunneling process on the oxidized graphite surface. A kinetic model taking into account the diffusion of D atoms on the surface is developed to estimate the width and the hight of the activation energy barriers for the successive deuteration reactions of ammonia species by D atoms. Identical control experiments were performed using CH3OH and D atoms. The deuteration process of solid methanol is ruled by H abstraction and D addition mechanism, and is almost five orders of magnitude faster than ammonia deuteration process.
[3]  oai:arXiv.org:1402.5855  [pdf] - 832376
Efficient diffusive mechanisms of O atoms at very low temperatures on surfaces of astrophysical interest
Comments: 22 pages, 8 figures, final manuscript Faraday Discussions 168
Submitted: 2014-02-24, last modified: 2014-06-05
At the low temperatures of interstellar dust grains, it is well established that surface chemistry proceeds via diffusive mechanisms of H atoms weakly bound (physisorbed) to the surface. Until recently, however, it was unknown whether atoms heavier than hydrogen could diffuse rapidly enough on interstellar grains to react with other accreted species. In addition, models still require simple reduction as well as oxidation reactions to occur on grains to explain the abundances of various molecules. In this paper we investigate O-atom diffusion and reactivity on a variety of astrophysically relevant surfaces (water ice of three different morphologies, silicate, and graphite) in the 6.5 - 25 K temperature range. Experimental values were used to derive a diffusion law that emphasizes that O atoms diffuse by quantum mechanical tunnelling at temperatures as low as 6.5 K. The rate of diffusion on each surface, based on modelling results, were calculated and an empirical law is given as a function of the surface temperature. Relative diffusion rates are k_H2Oice > k_sil > k_graph >> k_expected. The implications of an efficient O-atom diffusion over astrophysically relevant time-scales are discussed. Our findings show that O atoms can scan any available reaction partners (e.g., either another H atom, if available, or a surface radical like O or OH) at a faster rate than that of accretion. Also, as dense clouds mature H2 becomes far more abundant than H and the O/H ratio grows, the reactivity of O atoms on grains is such that O becomes one of the dominant reactive partners together with H.
[4]  oai:arXiv.org:1402.3207  [pdf] - 783866
Quantum tunneling of oxygen atoms on very cold surfaces
Comments: 13 pages, 4 figures
Submitted: 2014-02-13
Any evolving system can change of state via thermal mechanisms (hopping a barrier) or via quantum tunneling. Most of the time, efficient classical mechanisms dominate at high temperatures. This is why an increase of the temperature can initiate the chemistry. We present here an experimental investigation of O-atom diffusion and reactivity on water ice. We explore the 6-25 K temperature range at sub-monolayer surface coverages. We derive the diffusion temperature law and observe the transition from quantum to classical diffusion. Despite of the high mass of O, quantum tunneling is efficient even at 6 K. As a consequence, the solid-state astrochemistry of cold regions should be reconsidered and should include the possibility of forming larger organic molecules than previously expected.
[5]  oai:arXiv.org:1202.2473  [pdf] - 475832
Sticking coefficient of hydrogen and deuterium on silicates under interstellar conditions
Comments: 7 pages and 3 Postscript figures. Published in Astronomy & Astrophysics journal AA-2011-17409
Submitted: 2012-02-11
Sticking of H and D atoms on interstellar dust grains is the first step in molecular hydrogen formation, which is a key reaction in the InterStellar Medium (ISM). After studying the sticking coefficients of H2 and D2 molecules on amorphous silicate surfaces experimentally and theoretically, we extrapolate the results to the sticking coefficient of atoms and propose a formulae that gives the sticking coefficients of H and D on both silicates and icy dust grains. In our experiments, we used the King and Wells method for measuring the sticking coefficients of H2 and D2 molecules on a silicate surface held at 10 K. It consists of measuring with a QMS (quadrupole mass spectrometer) the signals of H2 and D2 molecules reflected by the surface during the exposure of the sample to the molecular beam at a temperature ranging from 20 K to 340 K. We tested the efficiency of a physical model, developed previously for sticking on water-ice surfaces. We applied this model to our experimental results for the sticking coefficients of H2 and D2 molecules on a silicate surface and estimated the sticking coefficient of atoms by a single measurement of atomic recombination and propose an extrapolation. Sticking of H, D, HD, H2, and D2 on silicates grains behaves the same as on icy dust grains. The sticking decreases with the gas temperature, and is dependent on the mass of the impactor. The sticking coefficient for both surfaces and impactors can be modeled by an analytical formulae S(T), which describes both the experiments and the thermal distribution expected in an astrophysical context. The parameters S0 and T0 are summarized in a table. Previous estimates for the sticking coefficient of H atoms are close to the new estimation; however, we find that, when isotopic effects are taken into account, the sticking coefficient variations can be as much as a factor of 2 at T=100 K.
[6]  oai:arXiv.org:1011.5344  [pdf] - 1579344
Changes in the morphology of interstellar ice analogues after hydrogen atom exposure
Comments: 9 pages, 7 figures, submitted to PCCP
Submitted: 2010-11-24, last modified: 2011-03-21
The morphology of water ice in the interstellar medium is still an open question. Although accretion of gaseous water could not be the only possible origin of the observed icy mantles covering dust grains in cold molecular clouds, it is well known that water accreted from the gas phase on surfaces kept at 10 K forms ice films that exhibit a very high porosity. It is also known that in the dark clouds H2 formation occurs on the icy surface of dust grains and that part of the energy (4.48 eV) released when adsorbed atoms react to form H2 is deposited in the ice. The experimental study described in the present work focuses on how relevant changes of the ice morphology result from atomic hydrogen exposure and subsequent recombination. Using the temperature-programmed desorption (TPD) technique and a method of inversion analysis of TPD spectra, we show that there is an exponential decrease in the porosity of the amorphous water ice sample following D-atom irradiation. This decrease is inversely proportional to the thickness of the ice and has a value of Phi_0 = 2 x 10^16 D-atoms/cm^2 per layer of H2O. We also use a model which confirms that the binding sites on the porous ice are destroyed regardless of their energy depth, and that the reduction of the porosity corresponds in fact to a reduction of the effective area. This reduction appears to be compatible with the fraction of D2 formation energy transferred to the porous ice network. Under interstellar conditions, this effect is likely to be efficient and, together with other compaction processes, provides a good argument to believe that interstellar ice is amorphous and non-porous.
[7]  oai:arXiv.org:0907.5173  [pdf] - 1003174
Experimental evidence for water formation via ozone hydrogenation on dust grains at 10 K
Comments: 16 pages, 2 figures, to be published on ApJL
Submitted: 2009-07-29, last modified: 2009-10-05
The formation of water molecules from the reaction between ozone (O3) and D-atoms is studied experimentally for the first time. Ozone is deposited on non-porous amorphous solid water ice (H2O), and D-atoms are then sent onto the sample held at 10 K. HDO molecules are detected during the desorption of the whole substrate where isotope mixing takes place, indicating that water synthesis has occurred. The efficiency of water formation via hydrogenation of ozone is of the same order of magnitude of that found for reactions involving O atoms or O2 molecules and exhibits no apparent activation barrier. These experiments validate the assumption made by models using ozone as one of the precursors of water formation via solid-state chemistry on interstellar dust grains.