The analysis of the surface texture from the particle (grain size, shape and internal structure) to its organization (surface roughness) provides information on the geological processes. CRISM multi-angular observations (varied emission angles) allow to characterize the surface scattering behavior which depends on the composition but also the material physical properties (e.g., grain size, shape, internal structure, the surface roughness). After an atmospheric correction by the Multi-angle Approach for Retrieval of the Surface Reflectance from CRISM Observations, the surface reflectances at different geometries are analyzed by inverting the Hapke photometric model depending on the single scattering albedo, the 2-term phase function, the macroscopic roughness and the 2-term opposition effects. Surface photometric maps are created to observe the spatial variations of surface scattering properties as a function of geological units at the CRISM spatial resolution (200m/pixel). An application at the Mars Exploration Rover (MER) landing sites located at Gusev Crater and Meridiani Planum where orbital and in situ observations are available, is presented. Complementary orbital observations (e.g. CRISM spectra, THermal EMission Imaging System, High Resolution Imaging Science Experiment images) are used for interpreting the estimated Hapke photometric parameters in terms of physical properties. The in situ observations are used as ground truth to validate the interpretations. Varied scattering properties are observed inside a CRISM observation (5x10km) suggesting that the surfaces are controlled by local geological processes (e.g. volcanic resurfacing, aeolian and impact processes) rather than regional or global. Consistent results with the in situ observations are observed thus validating the approach and the use of photometry for the characterization of Martian surface physical properties.

We propose a new method to retrieve the optical depth of Martian aerosols (AOD) from OMEGA and CRISM hyperspectral imagery at a reference wavelength of 1 {\mu}m. Our method works even if the underlying surface is completely made of minerals, corresponding to a low contrast between surface and atmospheric dust, while being observed at a fixed geometry. Minimizing the effect of the surface reflectance properties on the AOD retrieval is the second principal asset of our method. The method is based on the parametrization of the radiative coupling between particles and gas determining, with local altimetry, acquisition geometry, and the meteorological situation, the absorption band depth of gaseous CO2. Because the last three factors can be predicted to some extent, we can define a new parameter {\beta} that expresses specifically the strength of the gas-aerosols coupling while directly depending on the AOD. Combining estimations of {\beta} and top of the atmosphere radiance values extracted from the observed spectra within the CO2 gas band at 2 {\mu}m, we evaluate the AOD and the surface reflectance by radiative transfer inversion. One should note that practically {\beta} can be estimated for a large variety of mineral or icy surfaces with the exception of CO2 ice when its 2 {\mu}m solid band is not sufficiently saturated. Validation of the proposed method shows that it is reliable if two conditions are fulfilled: (i) the observation conditions provide large incidence or/and emergence angles (ii) the aerosol are vertically well mixed in the atmosphere. Experiments conducted on OMEGA nadir looking observations as well as CRISM EPF acquisitions with incidence angles higher than 65{\deg} and 33{\deg} respectively produce very satisfactory results. Finally in a companion paper the method is applied to monitoring atmospheric dust spring activity at high southern latitudes on Mars using OMEGA.

The present article proposes an approach to analyze the photometric properties of the surface materials from multi-angle observations acquired by the Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) on-board the Mars Reconnaissance Orbiter. We estimate photometric parameters using Hapke model in a Bayesian inversion framework. This work also represents a validation of the atmospheric correction provided by the Multi-angle Approach for Retrieval of Surface Reflectance from CRISM Observations (MARS-ReCO) proposed in the companion article.The latter algorithm retrieves photometric curves of surface materials in reflectance units after removing the aerosol contribution. This validation is done by comparing the estimated photometric parameters to those obtained from in situ measurements by Panoramic Camera instrument at the Mars Exploration Rover (MER)-Spirit and MER-Opportunity landing sites. Consistent photometric parameters with those from in situ measurements are found, demonstrating that MARS-ReCO gives access to accurate surface reflectance. Moreover the assumption of a non-Lambertian surface as included in MARS-ReCO is shown to be significantly more precise to estimate surface photometric properties from space in comparison to methods based on a Lambertian surface assumption. In the future, the presented method will allow us to map from orbit the surface bidirectional reflectance and the related photometric parameters in order to characterize the Martian surface.