This white paper summarizes major scientific challenges and opportunities in understanding magnetic reconnection and related explosive phenomena as a fundamental plasma process.

Data from the NASA Magnetospheric Multiscale (MMS) mission are used to investigate asymmetric magnetic reconnection at the dayside boundary between the Earth's magnetosphere and the solar wind (the magnetopause). High-resolution measurements of plasmas, electric and magnetic fields, and waves are used to identify highly localized (~15 electron Debye lengths) standing wave structures with large electric-field amplitudes (up to 100 mV/m). These wave structures are associated with spatially oscillatory dissipation, which appears as alternatingly positive and negative values of J dot E (dissipation). For small guide magnetic fields the wave structures occur in the electron stagnation region at the magnetosphere edge of the EDR. For larger guide fields the structures also occur near the reconnection x-line. This difference is explained in terms of channels for the out-of-plane current (agyrotropic electrons at the stagnation point and guide-field-aligned electrons at the x-line).

A prediction of the steady-state reconnection electric field in asymmetric reconnection is obtained by maximizing the reconnection rate as a function of the opening angle made by the upstream magnetic field on the weak magnetic field (magnetosheath) side. The prediction is within a factor of two of the widely examined asymmetric reconnection model [Cassak and Shay, Phys. Plasmas 14, 102114, 2007] in the collisionless limit, and they scale the same over a wide parameter regime. The previous model had the effective aspect ratio of the diffusion region as a free parameter, which simulations and observations suggest is on the order of 0.1, but the present model has no free parameters. In conjunction with the symmetric case [Liu et al., Phys. Rev. Lett. 118, 085101, 2017], this work further suggests that this nearly universal number 0.1, essentially the normalized fast reconnection rate, is a geometrical factor arising from maximizing the reconnection rate within magnetohydrodynamic (MHD)-scale constraints.

A long-standing problem in magnetic reconnection is to explain why it tends to proceed at or below a normalized rate of 0.1. This article gives a review of observational and numerical evidence for this rate and discusses recent theoretical work addressing this problem. Some remaining open questions are summarized.

We present an analysis of the apparent elongation motion of flare ribbons along the polarity inversion line (PIL) as well as the shear of flare loops in several two-ribbon flares. Flare ribbons and loops spread along the PIL at a speed ranging from a few to a hundred km/s. The shear measured from conjugate foot-points is consistent with the measurement from flare loops, and both show the decrease of shear toward a potential field as a flare evolves and ribbons and loops spread along the PIL. Flares exhibiting fast bi-directional elongation appear to have a strong shear, which may indicate a large magnetic guide field relative to the reconnection field in the coronal current sheet. We discuss how the analysis of ribbon motion could help infer properties in the corona where reconnection takes place.

Simulations suggest collisionless steady-state magnetic reconnection of Harris-type current sheets proceeds with a rate of order 0.1, independent of dissipation mechanism. We argue this long-standing puzzle is a result of constraints at the magnetohydrodynamic (MHD) scale. We perform a scaling analysis of the reconnection rate as a function of the opening angle made by the upstream magnetic fields, finding a maximum reconnection rate close to 0.2. The predictions compare favorably to particle-in-cell simulations of relativistic electron-positron and non-relativistic electron-proton reconnection. The fact that simulated reconnection rates are close to the predicted maximum suggests reconnection proceeds near the most efficient state allowed at the MHD-scale. The rate near the maximum is relatively insensitive to the opening angle, potentially explaining why reconnection has a similar fast rate in differing models.

We perform a theoretical and numerical study of anti-parallel 2D magnetic reconnection with asymmetries in the density and reconnecting magnetic field strength in addition to a bulk flow shear across the reconnection site in the plane of the reconnecting fields, which commonly occurs at planetary magnetospheres. We predict the speed at which an isolated X-line is convected by the flow, the reconnection rate, and the critical flow speed at which reconnection no longer takes place for arbitrary reconnecting magnetic field strengths, densities, and upstream flow speeds, and confirm the results with two-fluid numerical simulations. The predictions and simulation results counter the prevailing model of reconnection at Earth's dayside magnetopause which says reconnection occurs with a stationary X-line for sub-Alfvenic magnetosheath flow, reconnection occurs but the X-line convects for magnetosheath flows between the Alfven speed and double the Alfven speed, and reconnection does not occur for magnetosheath flows greater than double the Alfven speed. We find that X-line motion is governed by momentum conservation from the upstream flows, which are weighted differently in asymmetric systems, so the X-line convects for generic conditions including sub-Alfvenic upstream speeds. For the reconnection rate, while the cutoff condition for symmetric reconnection is that the difference in flows on the two sides of the reconnection site is twice the Alfven speed, we find asymmetries cause the cutoff speed for asymmetric reconnection to be higher than twice the asymmetric form of the Alfven speed. The results compare favorably with an observation of reconnection at Earth's polar cusps during a period of northward interplanetary magnetic field, where reconnection occurs despite the magnetosheath flow speed being more than twice the magnetosheath Alfven speed, the previously proposed suppression condition.

We test and compare a number of existing models predicting the location of magnetic reconnection at Earth's dayside magnetopause for various solar wind conditions. We employ robust image processing techniques to determine the locations where each model predicts reconnection to occur. The predictions are then compared to the magnetic separators, the magnetic field lines separating different magnetic topologies. The predictions are tested in distinct high-resolution simulations with interplanetary magnetic field (IMF) clock angles ranging from 30 to 165 degrees in global magnetohydrodynamic simulations using the three-dimensional Block-Adaptive Tree Solarwind Roe-type Upwind Scheme (BATS-R-US) code with a uniform resistivity, although the described techniques can be generally applied to any self-consistent magnetosphere code. Additional simulations are carried out to test location model dependence on IMF strength and dipole tilt. We find that most of the models match large portions of the magnetic separators when the IMF has a southward component, with the models saying reconnection occurs where the local reconnection rate and reconnection outflow speed are maximized performing best. When the IMF has a northward component, none of the models tested faithfully map the entire magnetic separator, but the maximum magnetic shear model is the best at mapping the separator in the cusp region where reconnection has been observed. Predictions for some models with northward IMF orientations improve after accounting for plasma flow shear parallel to the reconnecting components of the magnetic fields. Implications for observations are discussed.

Electron bulk heating during magnetic reconnection with symmetric inflow conditions is examined using kinetic particle-in-cell (PIC) simulations. The degree of electron heating is well correlated with the inflowing Alfv\'en speed $c_{Ar}$ based on the reconnecting magnetic field through the relation $\Delta T_e = 0.033 \,m_i\,c_{Ar}^2$, where $\Delta T_{e}$ is the increase in electron temperature. For the range of simulations performed, the heating shows almost no correlation with inflow total temperature $T_{tot} = T_i + T_e$ or plasma $\beta$. An out-of-plane (guide) magnetic field of similar magnitude to the reconnecting field does not affect the total heating, but it does quench perpendicular heating, with almost all heating being in the parallel direction. These results are qualitatively consistent with a recent statistical survey of electron heating in the dayside magnetopause, which also found that $\Delta T_e$ was proportional to the inflowing Alfv\'en speed. The net electron heating varies very little with distance downstream of the x-line. The simulations show at most a very weak dependence of electron heating on the ion to electron mass ratio. In the antiparallel reconnection case, the largely parallel heating is eventually isotropized downstream due a scattering mechanism such as stochastic particle motion or instabilities. The study highlights key properties that must be satisfied by an electron heating mechanism: (1) Preferential heating in the parallel direction; (2) Heating proportional to $m_i\,c_{Ar}^2$; (3) At most a weak dependence on electron mass; and (4) An exhaust electron temperature that varies little with distance from the x-line.

The structure of magnetic reconnection-driven outflows and their dissipation are explored with large-scale, 3-D particle-in-cell (PIC) simulations. Outflow jets resulting from 3-D reconnection with a finite length x-line form fronts as they propagate into the downstream medium. A large pressure increase ahead of this ``reconnection jet front'' (RJF), due to reflected and transmitted ions, slows the front so that its velocity is well below the velocity of the ambient ions in the core of the jet. As a result, the RJF slows and diverts the high-speed flow into the direction perpendicular to the reconnection plane. The consequence is that the RJF acts as a thermalization site for the ion bulk flow and contributes significantly to the dissipation of magnetic energy during reconnection even though the outflow jet is subsonic. This behavior has no counterpart in 2-D reconnection. A simple analytic model predicts the front velocity and the fraction of the ion bulk flow energy that is dissipated.

A new, efficient, and highly accurate method for tracing magnetic separators in global magnetospheric simulations with arbitrary clock angle is presented. The technique is to begin at a magnetic null and iteratively march along the separator by finding where four magnetic topologies meet on a spherical surface. The technique is verified using exact solutions for separators resulting from an analytic magnetic field model that superposes dipolar and uniform magnetic fields. Global resistive magnetohydrodynamic simulations are performed using the three-dimensional BATS-R-US code with a uniform resistivity, in eight distinct simulations with interplanetary magnetic field (IMF) clock angles ranging from 0 (parallel) to 180 degrees (anti-parallel). Magnetic nulls and separators are found in the simulations, and it is shown that separators traced here are accurate for any clock angle, unlike the last closed field line on the Sun-Earth line that fails for southward IMF. Trends in magnetic null locations and the structure of magnetic separators as a function of clock angle are presented and compared with those from the analytic field model. There are many qualitative similarities between the two models, but quantitative differences are also noted. Dependence on solar wind density is briefly investigated.

A model of supra-arcade downflows (SADs), dark low density regions also known as tadpoles that propagate sunward during solar flares, is presented. It is argued that the regions of low density are flow channels carved by sunward-directed outflow jets from reconnection. The solar corona is stratified, so the flare site is populated by a lower density plasma than that in the underlying arcade. As the jets penetrate the arcade, they carve out regions of depleted plasma density which appear as SADs. The present interpretation differs from previous models in that reconnection is localized in space but not in time. Reconnection is continuous in time to explain why SADs are not filled in from behind as they would if they were caused by isolated descending flux tubes or the wakes behind them due to temporally bursty reconnection. Reconnection is localized in space because outflow jets in standard two-dimensional reconnection models expand in the normal (inflow) direction with distance from the reconnection site, which would not produce thin SADs as seen in observations. On the contrary, outflow jets in spatially localized three-dimensional reconnection with an out-of-plane (guide) magnetic field expand primarily in the out-of-plane direction and remain collimated in the normal direction, which is consistent with observed SADs being thin. Two-dimensional proof-of-principle simulations of reconnection with an out-of-plane (guide) magnetic field confirm the creation of SAD-like depletion regions and the necessity of density stratification. Three-dimensional simulations confirm that localized reconnection remains collimated.

We use more than 4,500 microflares from the Reuven Ramaty High Energy Solar Spectroscopic Imager (RHESSI) microflare data set (Christe et al., 2008, Ap. J., 677, 1385) to estimate electron densities and volumetric filling factors of microflare loops using a cooling time analysis. We show that if the filling factor is assumed to be unity, the calculated conductive cooling times are much shorter than the observed flare decay times, which in turn are much shorter than the calculated radiative cooling times. This is likely unphysical, but the contradic- tion can be resolved by assuming the radiative and conductive cooling times are comparable, which is valid when the flare loop temperature is a maximum and when external heating can be ignored. We find that resultant radiative and con- ductive cooling times are comparable to observed decay times, which has been used as an assumption in some previous studies. The inferred electron densities have a mean value of 10^11.6 cm^-3 and filling factors have a mean of 10^-3.7. The filling factors are lower and densities are higher than previous estimates for large flares, but are similar to those found for two microflares by Moore et al. (Ap. J., 526, 505, 1999).

This work employs Hall magnetohydrodynamic (MHD) simulations to study the X-lines formed during the reconnection of magnetic fields with differing strengths and orientations embedded in plasmas of differing densities. Although random initial perturbations trigger the growth of X-lines with many orientations, at late time a few robust X-lines sharing an orientation reasonably consistent with the direction that maximizes the outflow speed, as predicted by Swisdak and Drake [Geophys. Res. Lett., 34, L11106, (2007)], dominate the system. The existence of reconnection in the geometry examined here contradicts the suggestion of Sonnerup [J. Geophys. Res., 79, 1546 (1974)] that reconnection occurs in a plane normal to the equilibrium current. At late time the growth of the X-lines stagnates, leaving them shorter than the simulation domain.

There is currently no explanation of why the corona has the temperature and density it has. We present a model which explains how the dynamics of magnetic reconnection regulates the conditions in the corona. A bifurcation in magnetic reconnection at a critical state enforces an upper bound on the coronal temperature for a given density. We present observational evidence from 107 flares in 37 sun-like stars that stellar coronae are near this critical state. The model may be important to self-organized criticality models of the solar corona.