In 2018-2019 the VERITAS VHE gamma-ray observatory was augmented with highspeed optical instrumentation and continuous data recording electronics to create a sensitive Stellar Intensity Interferometry (SII) observatory, VERITAS-SII. The primary science goal of VERITAS-SII is to perform stellar diameter measurements and image analysis in the visible wavebands on a selection of bright (m< 6), hot (O/B/A) stars. The VERITAS Collaboration has agreed to the deployment and operation of VERITAS-SII during several days each month around the full moon period when VERITAS does not perform VHE gamma-ray observations. The VERITAS-SII augmentation employs custom high-speed/low-noise focal plane instrumentation using high quantum efficiency photomultiplier tubes, and a battery-powered, fiber-optic controlled High Voltage supply. To reduce engineering time, VERITAS-SII uses commercially available high-speed (250 MS/sec), continuously streaming electronics to record the time dependence of the intensity fluctuations at each VERITAS telescope. VERITAS-SII also uses fast ( < 100 psec) data acquisition clock synchronization over inter-telescope distances (greater than 100 m) using a commercially available White Rabbit based timing solution. VERITAS-SII is now in full operation at the VERITAS observatory, F.L.Whipple Observatory, Amado, AZ USA. This paper describes the design of the instrumentation hardware used for VERITAS-SII augmentation of the VERITAS observatory, the status of initial VERITAS-SII observations, and plans for future improvements to VERITAS-SII.

Beginning in Fall 2018, the VERITAS high energy gamma-ray observatory (Amado, AZ) was upgraded to enable Stellar Intensity Interferometry (SII) observations during bright moon conditions. The system potentially allows VERITAS to spatially characterize stellar objects at visible wavelengths with sub-milliarcsecond angular resolution. This research project was on the construction of a high voltage power supply for the photomultiplier tubes (PMTs) used in the SII camera. The high voltage supply was designed to be electrically isolated from all other electronics (except for the PMT) to reduce noise pickup. The HV supply operates on a Li-Ion battery, and the high voltage level is remotely programmed using a pulse width modulation (PWM) signal that is generated by an Arduino Yun microcontroller and distributed through a fiber optic cable. The electrical isolation of the fiber optic control system suppresses the pickup of radio frequency interference through ground loops. A separate fiber optic transceiver pair is used for the on-off control of the high voltage power supply. Tests were performed that show the high voltage level is reproducible to within one volt for a given duty cycle of the PWM signal. Furthermore, the high voltage output level was shown to be stable with respect to variations in the input battery voltage used to power the high voltage supply. The high voltage system is currently being used in regular SII observations at VERITAS. This poster will describe the detailed design and performance of the system.