Saltation threshold, the minimum wind speed for sediment transport, is a fundamental parameter in aeolian processes. The presence of liquid, such as water on Earth or methane on Titan, may affect the threshold values to a great extent. Sediment density is also crucial for determining threshold values. Here we provide quantitative data on density and water content of common wind tunnel materials that have been used to study conditions on Earth, Titan, Mars, and Venus. The measured density values for low density materials are higher compared to literature values, whereas for the high density materials, there is no such discrepancy. We also find that low density materials have much higher water content and longer atmospheric equilibration timescales compared to high density sediments. In the Titan Wind Tunnel, we performed threshold experiments with the standard walnut shells (125-150 \mu m, 7.2% water by mass) and dried walnut shells (1.7% water by mass). The threshold results for the two scenarios are almost the same, which indicates that humidity had a negligible effect on threshold for walnut shells in this experimental regime. When the water content is lower than 11.0%, the interparticle forces are dominated by adsorption forces, whereas at higher values the interparticle forces are dominated by much larger capillary forces. For materials with low equilibrium water content, like quartz sand, capillary forces dominate. When the interparticle forces are dominated by adsorption forces, the threshold does not increase with increasing relative humidity (RH). Only when the interparticle forces are dominated by capillary forces does the threshold start to increase with increasing RH/water content. Since tholins have a low methane content (0.3% at saturation, Curtis et al., 2008), we believe tholins would behave similarly to quartz sand when subjected to methane moisture. [abridged abstract]

The Trojan asteroids remain quite poorly understood, yet their physical properties provide unique perspective on chemical and dynamical processes that shaped the Solar System. The current study was undertaken to investigate surface compositions of these objects. We present 66 new near-infrared (NIR; 0.7 to 2.5 microns) spectra of 58 Trojans, including members of both the leading and trailing swarms. We also include in the analysis previously published NIR spectra of 13 Trojans (3 of which overlap with the new sample). This data set permits not only a direct search for compositional signatures, but also a search for patterns that may reveal clues to the origin of the Trojans. We do not report any confirmed absorption features in the new spectra. Analysis of the spectral slopes, however, reveals an interesting bimodality among the NIR data. The two spectral groups identified appear to be equally abundant in the leading and trailing swarms. The spectral groups are not a result of family membership; they occur in the background, non-family population. The average albedos of the two groups are the same within uncertainties (0.051\pm0.016 and 0.055\pm0.016). No correlations between spectral slope and any other physical or orbital parameter are detected, with the exception of a possible weak correlation with inclination among the less-red spectral group. Synthesizing these results with previously published properties, we conclude that the two spectral groups represent objects with different intrinsic compositions. We further suggest that while the less-red group originated near Jupiter or in the main asteroid belt, the redder spectral group originated farther out in the Solar System. If correct, the Trojan swarms offer the most readily accessible large reservoir of Kuiper Belt material as well as a unique reservoir for the study of material from the middle part of the solar nebula.