Normalized to: Burguet-Castell, J.
[1]
oai:arXiv.org:1710.09973 [pdf] - 1650026
Reconstructing the calibrated strain signal in the Advanced LIGO
detectors
Viets, A. D.;
Wade, M.;
Urban, A. L.;
Kandhasamy, S.;
Betzwieser, J.;
Brown, Duncan A.;
Burguet-Castell, J.;
Cahillane, C.;
Goetz, E.;
Izumi, K.;
Karki, S.;
Kissel, J. S.;
Mendell, G.;
Savage, R. L.;
Siemens, X.;
Tuyenbayev, D.;
Weinstein, A. J.
Submitted: 2017-10-26, last modified: 2018-03-13
Advanced LIGO's raw detector output needs to be calibrated to compute
dimensionless strain h(t). Calibrated strain data is produced in the time
domain using both a low-latency, online procedure and a high-latency, offline
procedure. The low-latency h(t) data stream is produced in two stages, the
first of which is performed on the same computers that operate the detector's
feedback control system. This stage, referred to as the front-end calibration,
uses infinite impulse response (IIR) filtering and performs all operations at a
16384 Hz digital sampling rate. Due to several limitations, this procedure
currently introduces certain systematic errors in the calibrated strain data,
motivating the second stage of the low-latency procedure, known as the
low-latency gstlal calibration pipeline. The gstlal calibration pipeline uses
finite impulse response (FIR) filtering to apply corrections to the output of
the front-end calibration. It applies time-dependent correction factors to the
sensing and actuation components of the calibrated strain to reduce systematic
errors. The gstlal calibration pipeline is also used in high latency to
recalibrate the data, which is necessary due mainly to online dropouts in the
calibrated data and identified improvements to the calibration models or
filters.
[4]
oai:arXiv.org:1201.2964 [pdf] - 672963
Detecting transient gravitational waves in non-Gaussian noise with
partially redundant analysis methods
Biswas, Rahul;
Brady, Patrick R.;
Burguet-Castell, Jordi;
Cannon, Kipp;
Clayton, Jessica;
Dietz, Alexander;
Fotopoulos, Nickolas;
Goggin, Lisa M.;
Keppel, Drew;
Pankow, Chris;
Price, Larry R.;
Vaulin, Ruslan
Submitted: 2012-01-13, last modified: 2012-04-25
There is a broad class of astrophysical sources that produce detectable,
transient, gravitational waves. Some searches for transient gravitational waves
are tailored to known features of these sources. Other searches make few
assumptions about the sources. Typically events are observable with multiple
search techniques. This work describes how to combine the results of searches
that are not independent, treating each search as a classifier for a given
event. This will be shown to improve the overall sensitivity to
gravitational-wave events while directly addressing the problem of consistent
interpretation of multiple trials.
[6]
oai:arXiv.org:1201.2959 [pdf] - 672962
Likelihood-ratio ranking of gravitational-wave candidates in a
non-Gaussian background
Biswas, Rahul;
Brady, Patrick R.;
Burguet-Castell, Jordi;
Cannon, Kipp;
Clayton, Jessica;
Dietz, Alexander;
Fotopoulos, Nickolas;
Goggin, Lisa M.;
Keppel, Drew;
Pankow, Chris;
Price, Larry R.;
Vaulin, Ruslan
Submitted: 2012-01-13, last modified: 2012-01-16
We describe a general approach to detection of transient gravitational-wave
signals in the presence of non-Gaussian background noise. We prove that under
quite general conditions, the ratio of the likelihood of observed data to
contain a signal to the likelihood of it being a noise fluctuation provides
optimal ranking for the candidate events found in an experiment. The
likelihood-ratio ranking allows us to combine different kinds of data into a
single analysis. We apply the general framework to the problem of unifying the
results of independent experiments and the problem of accounting for
non-Gaussian artifacts in the searches for gravitational waves from compact
binary coalescence in LIGO data. We show analytically and confirm through
simulations that in both cases the likelihood ratio statistic results in an
improved analysis.