sort results by

Use logical operators AND, OR, NOT and round brackets to construct complex queries. Whitespace-separated words are treated as ANDed.

Show articles per page in mode

Bruinsma, S.

Normalized to: Bruinsma, S.

4 article(s) in total. 6 co-authors, from 1 to 2 common article(s). Median position in authors list is 2,0.

[1]  oai:arXiv.org:1801.06092  [pdf] - 1709315
EUV Irradiance Inputs to Thermospheric Density Models: Open Issues and Path Forward
Comments: 20 pages, 3 figures, accepted in Space Weather Journal in Special section on Low Earth Orbit Satellite Drag: Science and Operational Impact
Submitted: 2018-01-18
One of the objectives of the NASA LWS Institute on Nowcasting of Atmospheric Drag for LEO Spacecraft was to investigate whether and how to increase the accuracy of atmospheric drag models by improving the quality of the solar forcing inputs, namely Extreme Ultraviolet (EUV) irradiance information. In this focused review, we examine the status of and issues with EUV measurements and proxies, discuss recent promising developments, and suggest a number of ways to improve the reliability, availability, and forecast accuracy of EUV measurements in the next solar cycle.
[2]  oai:arXiv.org:1503.03207  [pdf] - 1021919
Assessing the performance of thermospheric modelling with data assimilation throughout solar cycles 23 and 24
Comments: Accepted for publication in Space Weather. 11 pages, 6 figures, 1 table
Submitted: 2015-03-11
Data assimilation procedures have been developed for thermospheric models using satellite density measurements as part of the EU Framework Package 7 ATMOP Project. Two models were studied; one a general circulation model, TIEGCM, and the other a semi-empirical drag temperature model, DTM. Results of runs using data assimilation with these models were compared with independent density observations from CHAMP and GRACE satellites throughout solar cycles 23 and 24. Time periods of 60 days were examined at solar minimum and maximum, including the 2003 Hallowe'en storms. The differences between the physical and the semi-empirical models have been characterised. Results indicate that both models tend to show similar behaviour; underestimating densities at solar maximum, and overestimating them at solar minimum. DTM performed better at solar minimum, with both models less accurate at solar maximum. A mean improvement of ~4% was found using data assimilation with TIEGCM. With further improvements, the use of general circulation models in operational space weather forecasting (in addition to empirical methods currently used) is plausible. Future work will allow near-real-time assimilation of thermospheric data for improved forecasting.
[3]  oai:arXiv.org:1402.3946  [pdf] - 784844
Synoptic solar radio observations as proxies for upper atmosphere modelling
Comments: 13 pages
Submitted: 2014-02-17
The specification of the upper atmosphere strongly relies on solar proxies that can properly reproduce the solar energetic input in the UV. Whilst the microwave flux at 10.7 cm (also called F10.7 index) has been routinely used as a solar proxy, we show that the radio flux at other wavelengths provides valuable complementary information that enhances their value for upper atmospheric modelling. We merged daily observations from various observatories into a single homogeneous data set of fluxes at wavelengths of 30, 15, 10.7, 8 and 3.2 cm, spanning from 1957 to today. Using blind source separation (BSS), we show that their rotational modulation contains three contributions, which can be interpreted in terms of thermal bremsstrahlung and gyro-resonance emissions. The latter account for 90% of the rotational variability in the F10.7 index. Most solar proxies, such as the MgII index, are remarkably well reconstructed by simple linear combination of radio fluxes at various wavelengths. The flux at 30 cm stands out as an excellent proxy and is better suited than the F10.7 index for the modelling the thermosphere-ionosphere system, most probably because it receives a stronger contribution from thermal bremsstrahlung. This better performance is illustrated here through comparison between the observed thermospheric density, and reconstructions by the Drag Temperature Model.
[4]  oai:arXiv.org:1110.1469  [pdf] - 422681
Determination of the most pertinent EUV proxy for use in thermosphere modeling
Comments:
Submitted: 2011-10-07
Two major issues in the specification of the thermospheric density are the definition of proper solar inputs and the empirical modeling of thermosphere response to solar and to geomagnetic forcings. This specification is crucial for the tracking of low Earth orbiting satellites. Here we address both issues by using 14 years of daily density measurements made by the Stella satellite at 813 km altitude and by carrying out a multiscale statistical analysis of various solar inputs. First, we find that the spectrally integrated solar emission between 26-34 nm offers the best overall performance in the density reconstruction. Second, we introduce linear parametric transfer function models to describe the dynamic response of the density to the solar and geomagnetic forcings. These transfer function models lead to a major error reduction and in addition open new perspectives in the physical interpretation of the thermospheric dynamics.