Normalized to: Bridges, N.
[1]
oai:arXiv.org:1710.06400 [pdf] - 1626348
Direct Measurement of Interparticle Forces of Titan Aerosol Analogs
("Tholin") Using Atomic Force Microscopy
Submitted: 2017-10-17, last modified: 2017-10-18
To understand the origin of the dunes on Titan, it is important to
investigate the material properties of Titan's organic sand particles on Titan.
The organic sand may behave distinctively compared to the quartz/basaltic sand
on terrestrial planets (Earth, Venus, Mars) due to differences in interparticle
forces. We measured the surface energy (through contact angle measurements) and
elastic modulus (through Atomic Force Microscopy, AFM) of the Titan aerosol
analog (tholin). We find the surface energy of a tholin thin film is about 70.9
mN/m and its elastic modulus is about 3.0 GPa (similar to hard polymers like
PMMA and polystyrene). For two 20 $\mu$m diameter particles, the theoretical
cohesion force is therefore 3.3 $\mu$N. We directly measured interparticle
forces for relevant materials: tholin particles are 0.8$\pm$0.6 $\mu$N, while
the interparticle cohesion between walnut shell particles (a typical model
materials for the Titan Wind Tunnel, TWT) is only 0.4$\pm$0.1 $\mu$N. The
interparticle cohesion forces are much larger for tholins and presumably Titan
sand particles than materials used in the TWT. This suggests we should increase
the interparticle force in both analog experiments (TWT) and threshold models
to correctly translate the results to real Titan conditions. The strong
cohesion of tholins may also inform us how the small aerosol particles ($\sim$1
$\mu$m) in Titan's atmosphere are transformed into large sand particles
($\sim$200 $\mu$m). It may also support the cohesive sand formation mechanism
suggested by Rubin and Hesp (2009), where only unidirectional wind is needed to
form linear dunes on Titan.
[2]
oai:arXiv.org:1706.09986 [pdf] - 1585349
The Effect of Adsorbed Liquid and Material Density on Saltation
Threshold: Insight from Laboratory and Wind Tunnel Experiments
Submitted: 2017-06-29
Saltation threshold, the minimum wind speed for sediment transport, is a
fundamental parameter in aeolian processes. The presence of liquid, such as
water on Earth or methane on Titan, may affect the threshold values to a great
extent. Sediment density is also crucial for determining threshold values. Here
we provide quantitative data on density and water content of common wind tunnel
materials that have been used to study conditions on Earth, Titan, Mars, and
Venus. The measured density values for low density materials are higher
compared to literature values, whereas for the high density materials, there is
no such discrepancy. We also find that low density materials have much higher
water content and longer atmospheric equilibration timescales compared to high
density sediments. In the Titan Wind Tunnel, we performed threshold experiments
with the standard walnut shells (125-150 \mu m, 7.2% water by mass) and dried
walnut shells (1.7% water by mass). The threshold results for the two scenarios
are almost the same, which indicates that humidity had a negligible effect on
threshold for walnut shells in this experimental regime. When the water content
is lower than 11.0%, the interparticle forces are dominated by adsorption
forces, whereas at higher values the interparticle forces are dominated by much
larger capillary forces. For materials with low equilibrium water content, like
quartz sand, capillary forces dominate. When the interparticle forces are
dominated by adsorption forces, the threshold does not increase with increasing
relative humidity (RH). Only when the interparticle forces are dominated by
capillary forces does the threshold start to increase with increasing RH/water
content. Since tholins have a low methane content (0.3% at saturation, Curtis
et al., 2008), we believe tholins would behave similarly to quartz sand when
subjected to methane moisture. [abridged abstract]
[3]
oai:arXiv.org:1402.1150 [pdf] - 780745
Hydrothermal formation of Clay-Carbonate alteration assemblages in the
Nili Fossae region of Mars
Submitted: 2014-02-05
The Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) has returned
observations of the Nili Fossae region indicating the presence of Mg- carbonate
in small (<10km sq2), relatively bright rock units that are commonly fractured
(Ehlmann et al., 2008b). We have analyzed spectra from CRISM images and used
co-located HiRISE images in order to further characterize these
carbonate-bearing units. We applied absorption band mapping techniques to
investigate a range of possible phyllosilicate and carbonate minerals that
could be present in the Nili Fossae region. We also describe a clay-carbonate
hydrothermal alteration mineral assemblage in the Archean Warrawoona Group of
Western Australia that is a potential Earth analog to the Nili Fossae
carbonate-bearing rock units. We discuss the geological and biological
implications for hydrothermal processes on Noachian Mars.