Because of the complex physics that governs the formation of chromospheric lines, interpretation of solar chromospheric observations is difficult. The origin and characteristics of many chromospheric features are, because of this, unresolved. We focus here on studying two prominent features: long fibrils and flare ribbons. To model them, we use a 3D MHD simulation of an active region which self-consistently reproduces both of them. We model the H$\alpha$, Mg II k, Ca II K, and Ca II 8542 {\AA} lines using the 3D non-LTE radiative transfer code Multi3D. This simulation reproduces long fibrils that span between the opposite-polarity sunspots and go up to 4 Mm in height. They can be traced in all lines due to density corrugation. Opposite to previous studies, H$\alpha$, Mg II h&k, and Ca II H&K, are formed at similar height in this model. Magnetic field lines are aligned with the H$\alpha$ fibrils, but the latter holds to a lesser extent for the Ca II 8542 {\AA} line. The simulation shows structures in the H$\alpha$ line core that look like flare ribbons. The emission in the ribbons is caused by a dense chromosphere and a transition region at high column mass. The ribbons are visible in all chromospheric lines, but least prominent in Ca II 8542 {\AA} line. In some pixels, broad asymmetric profiles with a single emission peak are produced, similar to the profiles observed in flare ribbons. They are caused by a deep onset of the chromospheric temperature rise and large velocity gradients. The simulation produces long fibrils similar to what is seen in observations. It also produces structures similar to flare ribbons despite the lack of non-thermal electrons in the simulation. The latter suggests that thermal conduction might be a significant agent in transporting flare energy to the chromosphere in addition to non-thermal electrons.

Ellerman bombs (EBs) and UV bursts are both brightenings related to flux emergence regions and specifically to magnetic flux of opposite polarity that meet in the photosphere. These two reconnection-related phenomena, nominally formed far apart, occasionally occur in the same location and at the same time, thus challenging our understanding of reconnection and heating of the lower solar atmosphere. We consider the formation of an active region, including long fibrils and hot and dense coronal plasma. The emergence of a untwisted magnetic flux sheet, injected $2.5$~Mm below the photosphere, is studied as it pierces the photosphere and interacts with the preexisting ambient field. Specifically, we aim to study whether EBs and UV bursts are generated as a result of such flux emergence and examine their physical relationship. The Bifrost radiative magnetohydrodynamics code was used to model flux emerging into a model atmosphere that contained a fairly strong ambient field, constraining the emerging field to a limited volume wherein multiple reconnection events occur as the field breaks through the photosphere and expands into the outer atmosphere. Synthetic spectra of the different reconnection events were computed using the $1.5$D RH code and the fully 3D MULTI3D code. The formation of UV bursts and EBs at intensities and with line profiles that are highly reminiscent of observed spectra are understood to be a result of the reconnection of emerging flux with itself in a long-lasting current sheet that extends over several scale heights through the chromosphere. Synthetic diagnostics suggest that there are no compelling reasons to assume that UV bursts occur in the photosphere. Instead, EBs and UV bursts are occasionally formed at opposite ends of a long current sheet that resides in an extended bubble of cool gas.

CHROMIS, a new imaging spectrometer at the Swedish 1-m Solar Telescope (SST), can observe the chromosphere in the H and K lines of Ca II at high spatial and spectral resolution. Accurate modeling as well as an understanding of the formation of these lines are needed to interpret the SST/CHROMIS observations. Such modeling is computationally challenging because these lines are influenced by strong departures from local thermodynamic equilibrium, three-dimensional radiative transfer, and partially coherent resonance scattering of photons. We aim to model the CaII H&K lines in 3D model atmospheres to understand their formation and to investigate their diagnostic potential for probing the chromosphere. We model the synthetic spectrum of Ca II using the radiative transfer code Multi3D in three different radiation-magnetohydrodynamic model atmospheres computed with the Bifrost code. We classify synthetic intensity profiles according to their shapes and study how their features are related to the physical properties in the model atmospheres. We investigate whether the synthetic data reproduce the observed spatially-averaged line shapes, center-to-limb variation and compare with SST/CHROMIS images. The spatially-averaged synthetic line profiles show too low central emission peaks, and too small separation between the peaks. The trends of the observed center-to-limb variation of the profiles properties are reproduced by the models. The Ca II H&K line profiles provide a temperature diagnostic of the temperature minimum and the temperature at the formation height of the emission peaks. The Doppler shift of the central depression is an excellent probe of the velocity in the upper chromosphere.

3D non-LTE radiative transfer problems are computationally demanding, and this sets limits on the size of the problems that can be solved. So far Multilevel Accelerated Lambda Iteration (MALI) has been to the method of choice to perform high-resolution computations in multidimensional problems. The disadvantage of MALI is that its computing time scales as $\mathcal{O}(n^2)$, with $n$ the number of grid points. When the grid gets finer, the computational cost increases quadratically. We aim to develop a 3D non-LTE radiative transfer code that is more efficient than MALI. We implement a non-linear multigrid, fast approximation storage scheme, into the existing Multi3D radiative transfer code. We verify our multigrid implementation by comparing with MALI computations. We show that multigrid can be employed in realistic problems with snapshots from 3D radiative-MHD simulations as input atmospheres. With multigrid, we obtain a factor 3.3-4.5 speedup compared to MALI. With full-multigrid the speed-up increases to a factor 6. The speedup is expected to increase for input atmospheres with more grid points and finer grid spacing. Solving 3D non-LTE radiative transfer problems using non-linear multigrid methods can be applied to realistic atmospheres with a substantial speed-up.