Normalized to: Bezuidenhout, M.
[1]
oai:arXiv.org:2006.08662 [pdf] - 2129422
Simultaneous multi-telescope observations of FRB 121102
Caleb, M.;
Stappers, B. W.;
Abbott, T. D.;
Barr, E. D.;
Bezuidenhout, M. C.;
Buchner, S. J.;
Burgay, M.;
Chen, W.;
Cognard, I.;
Driessen, L. N.;
Fender, R.;
Hilmarsson, G. H.;
Hoang, J.;
Horn, D. M.;
Jankowski, F.;
Kramer, M.;
Lorimer, D. R.;
Malenta, M.;
Morello, V.;
Pilia, M.;
Platts, E.;
Possenti, A.;
Rajwade, K. M.;
Ridolfi, A.;
Rhodes, L.;
Sanidas, S.;
Serylak, M.;
Spitler, L. G.;
Townsend, L. J.;
Weltman, A.;
Woudt, P. A.;
Wu, J.
Submitted: 2020-06-15
We present 11 detections of FRB 121102 in ~3 hours of observations during its
'active' period on the 10th of September 2019. The detections were made using
the newly deployed MeerTRAP system and single pulse detection pipeline at the
MeerKAT radio telescope in South Africa. Fortuitously, the Nancay radio
telescope observations on this day overlapped with the last hour of MeerKAT
observations and resulted in 4 simultaneous detections. The observations with
MeerKAT's wide band receiver, which extends down to relatively low frequencies
(900-1670 MHz usable L-band range), have allowed us to get a detailed look at
the complex frequency structure, intensity variations and frequency-dependent
sub-pulse drifting. The drift rates we measure for the full-band and sub-banded
data are consistent with those published between 600-6500 MHz with a slope of
-0.147 +/- 0.014 ms^-1. Two of the detected bursts exhibit fainter 'precursors'
separated from the brighter main pulse by ~28 ms and ~34 ms. A follow-up
multi-telescope campaign on the 6th and 8th October 2019 to better understand
these frequency drifts and structures over a wide and continuous band was
undertaken. No detections resulted, indicating that the source was 'inactive'
over a broad frequency range during this time.
[2]
oai:arXiv.org:1808.09762 [pdf] - 1741349
Assessment of a statistical approach that facilitates the constraint of
pulsar geometry via dualband light curve fitting
Submitted: 2018-08-29
The Large Area Telescope aboard the Fermi spacecraft has detected more than
200 $\gamma$-ray pulsars since its launch in 2008. By concurrently fitting
standard geometric model light curves onto Fermi and radio data, researchers
have constrained the inclination and observer angles of a number of pulsars. At
first this was done by comparing observed and modelled light curves by eye, and
later via statistical approaches. We fit modelled light curves of 16 pulsars to
radio and $\gamma$-ray data by optimising a custom test statistic that we have
developed for combining light curves across the two wavebands, taking their
disparate errors into account. We present geometrical constraints found using
this process, and compare them with results found by eye or using other
statistical methods.
[3]
oai:arXiv.org:1712.08178 [pdf] - 1607122
Calibration of statistical methods used to constrain pulsar geometries
via multiband light curve modelling
Submitted: 2017-12-21
Since its launch in 2008, the Fermi Large Area Telescope (LAT) has detected
over 200 -ray pulsars above 100 MeV. This population of pulsars is
characterised by a rich diversity of light curve morphologies. Researchers have
been using both the radio and -ray light curves to constrain the inclination
and observer angles for each of these pulsars. At first, this was done using a
by-eye technique and later via statistical approaches. We have also developed
two novel statistical approaches that place the radio and -ray data on equal
footing despite their disparate relative flux errors. We chose eleven pulsars
from the Second Fermi Pulsar Catalog, both old and young, and applied these new
techniques as well as the by-eye technique to constrain their geometric
parameters using standard pulsar models. We present first results on our
comparison of the best-fit parameters yielded by each of the aforementioned
techniques. This will assist us in determining the utility of our new
statistical approaches, and gauge the overlap of the best-fit parameters (plus
errors) from each of the different methods. Such a statistical fitting approach
will provide the means for further pulsar magnetospheric model development
using light curve data.