The observations of solar photosphere from the ground encounter significant problems due to the presence of Earth's turbulent atmosphere. Prior to applying image reconstruction techniques, the frames obtained in most favorable atmospheric conditions (so-called lucky frames) have to be carefully selected. However, the estimation of the quality of images containing complex photospheric structures is not a trivial task and the standard routines applied in night-time Lucky Imaging observations are not applicable. In this paper we evaluate 36 methods dedicated for the assessment of image quality which were presented in the rich literature over last 40 years. We compare their effectiveness on simulated solar observations of both active regions and granulation patches, using reference data obtained by the Solar Optical Telescope on the Hindoe satellite. To create the images affected by a known degree of atmospheric degradation, we employ the Random Wave Vector method which faithfully models all the seeing characteristics. The results provide useful information about the methods performance depending on the average seeing conditions expressed by the ratio of the telescope's aperture to the Fried parameter, $D/r_0$. The comparison identifies three methods for consideration by observers: Helmli and Scherer's Mean, Median Filter Gradient Similarity, and Discrete Cosine Transform Energy Ratio. While the first one requires less computational effort and can be used effectively virtually in any atmospherics conditions, the second one shows its superiority at good seeing ($D/r_0<4$). The last one should be considered mainly for the post-processing of strongly blurred images.

The BRITE mission is a pioneering space project aimed at the long-term photometric monitoring of the brightest stars in the sky by means of a constellation of nano-satellites. Its main advantage is high photometric accuracy and time coverage inaccessible from the ground. The main aim of this paper is the presentation of procedures used to obtain high-precision photometry from a series of images acquired by the BRITE satellites in two modes of observing, stare and chopping. We developed two pipelines corresponding to the two modes of observing. The assessment of the performance of both pipelines is presented. It is based on two comparisons, which use data from six runs of the UniBRITE satellite: (i) comparison of photometry obtained by both pipelines on the same data, which were partly affected by charge transfer inefficiency (CTI), (ii) comparison of real scatter with theoretical expectations. It is shown that for CTI-affected observations, the chopping pipeline provides much better photometry than the other pipeline. For other observations, the results are comparable only for data obtained shortly after switching to chopping mode. Starting from about 2.5 years in orbit, the chopping mode of observing provides significantly better photometry for UniBRITE data than the stare mode. This paper shows that high-precision space photometry with low-cost nano-satellites is achievable. The proposed meth- ods, used to obtain photometry from images affected by high impulsive noise, can be applied to data from other space missions or even to data acquired from ground-based observations.

In the article we present a hardware meteor detector. The detection principle is based on the electromagnetic wave reflection from the ionized meteor trail in the atmosphere. The detector uses the ANADIGM field programmable analogue array (FPAA), which is an attractive alternative for a typically used detecting equipment - a PC computer with dedicated software. We implement an analog signal path using most of available FPAA resources to obtain precise audio signal detection. Our new detector was verified in collaboration with the Polish Fireball Network - the organization which monitors meteor activity in Poland. When compared with currently used signal processing PC software employing real radio meteor scatter signals, our low-cost detector proved to be more precise and reliable. Due to its cost and efficiency superiority over the current solution, the presented module is going to be implemented in the planned distributed detectors system.