Normalized to: Bauer, C.
[1]
oai:arXiv.org:1907.09220 [pdf] - 1920228
Trigger performance verification of the FlashCam prototype camera
Sailer, S.;
Werner, F.;
Hermann, G.;
Barcelo, M.;
Bauer, C.;
Bernhard, S.;
Biegger, M.;
Canelli, F.;
Capasso, M.;
Diebold, S.;
Eisenkolb, F.;
Eschbach, S.;
Florin, D.;
Föhr, C.;
Funk, S.;
Gadola, A.;
Garrecht, F.;
Jung, I.;
Kalekin, O.;
Kalkuhl, C.;
Kihm, T.;
Lahmann, R.;
Pfeifer, M.;
Principe, G.;
Pühlhofer, G.;
Pürckhauer, S.;
Reimer, O.;
Santangelo, A.;
Scalici, M.;
Schanz, T.;
Schwab, T.;
Steiner, S.;
Straumann, U.;
Tenzer, C.;
Vollhardt, A.;
Wolf, D.
Submitted: 2019-07-22
FlashCam is a camera proposed for the medium-sized telescopes of the
Cherenkov Telescope Array (CTA). We compare camera trigger rates obtained from
measurements with the camera prototype in the laboratory and Monte-Carlo
simulations, when scanning the parameter space of the fully-digital trigger
logic and the intensity of a continuous light source mimicking the night sky
background (NSB) during on-site operation. The comparisons of the measured data
results to the Monte-Carlo simulations are used to verify the FlashCam trigger
logic and the expected trigger performance.
[3]
oai:arXiv.org:1612.09528 [pdf] - 1533980
Performance Verification of the FlashCam Prototype Camera for the
Cherenkov Telescope Array
Werner, F.;
Bauer, C.;
Bernhard, S.;
Capasso, M.;
Diebold, S.;
Eisenkolb, F.;
Eschbach, S.;
Florin, D.;
Föhr, C.;
Funk, S.;
Gadola, A.;
Garrecht, F.;
Hermann, G.;
Jung, I.;
Kalekin, O.;
Kalkuhl, C.;
Kasperek, J.;
Kihm, T.;
Lahmann, R.;
Marszalek, A.;
Pfeifer, M.;
Principe, G.;
Pühlhofer, G.;
Pürckhauer, S.;
Rajda, P. J.;
Reimer, O.;
Santangelo, A.;
Schanz, T.;
Schwab, T.;
Steiner, S.;
Straumann, U.;
Tenzer, C.;
Vollhardt, A.;
Wolf, D.;
Zietara, K.
Submitted: 2016-12-30
The Cherenkov Telescope Array (CTA) is a future gamma-ray observatory that is
planned to significantly improve upon the sensitivity and precision of the
current generation of Cherenkov telescopes. The observatory will consist of
several dozens of telescopes with different sizes and equipped with different
types of cameras. Of these, the FlashCam camera system is the first to
implement a fully digital signal processing chain which allows for a traceable,
configurable trigger scheme and flexible signal reconstruction. As of autumn
2016, a prototype FlashCam camera for the medium-sized telescopes of CTA nears
completion. First results of the ongoing system tests demonstrate that the
signal chain and the readout system surpass CTA requirements. The stability of
the system is shown using long-term temperature cycling.
[6]
oai:arXiv.org:1509.02434 [pdf] - 1938108
FlashCam: a fully-digital camera for the medium-sized telescopes of the
Cherenkov Telescope Array
Pühlhofer, G.;
Bauer, C.;
Bernhard, S.;
Capasso, M.;
Diebold, S.;
Eisenkolb, F.;
Florin, D.;
Föhr, C.;
Funk, S.;
Gadola, A.;
Garrecht, F.;
Hermann, G.;
Jung, I.;
Kalekin, O.;
Kalkuhl, C.;
Kasperek, J.;
Kihm, T.;
Lahmann, R.;
Manalaysay, A.;
Marszalek, A.;
Pfeifer, M.;
Rajda, P. J.;
Reimer, O.;
Santangelo, A.;
Schanz, T.;
Schwab, T.;
Steiner, S.;
Straumann, U.;
Tenzer, C.;
Vollhardt, A.;
Weitzel, Q.;
Werner, F.;
Wolf, D.;
Zietara, K.
Submitted: 2015-09-08
The FlashCam group is currently preparing photomultiplier-tube based cameras
proposed for the medium-sized telescopes (MST) of the Cherenkov Telescope Array
(CTA). The cameras are designed around the FlashCam readout concept which is
the first fully-digital readout system for Cherenkov cameras, based on
commercial FADCs and FPGAs as key components for the front-end electronics
modules and a high performance camera server as back-end. This contribution
describes the progress of the full-scale FlashCam camera prototype currently
under construction, as well as performance results also obtained with earlier
demonstrator setups. Plans towards the production and implementation of
FlashCams on site are also briefly presented.
[8]
oai:arXiv.org:1307.3677 [pdf] - 1941893
FlashCam: A fully digital camera for the Cherenkov Telescope Array
Pühlhofer, G.;
Bauer, C.;
Eisenkolb, F.;
Florin, D.;
Föhr, C.;
Gadola, A.;
Hermann, G.;
Kalkuhl, C.;
Kasperek, J.;
Kihm, T.;
Koziol, J.;
Manalaysay, A.;
Marszalek, A.;
Rajda, P. J.;
Romaszkan, W.;
Rupinski, M.;
Schanz, T.;
Steiner, S.;
Straumann, U.;
Tenzer, C.;
Vollhardt, A.;
Weitzel, Q.;
Winiarski, K.;
Zietara, K.
Submitted: 2013-07-13
FlashCam is a Cherenkov camera development project centered around a fully
digital trigger and readout scheme with smart, digital signal processing, and a
"horizontal" architecture for the electromechanical implementation. The fully
digital approach, based on commercial FADCs and FPGAs as key components,
provides the option to easily implement different types of triggers as well as
digitization and readout scenarios using identical hardware, by simply changing
the firmware on the FPGAs. At the same time, a large dynamic range and high
resolution of low-amplitude signals in a single readout channel per pixel is
achieved using compression of high amplitude signals in the preamplifier and
signal processing in the FPGA. The readout of the front-end modules into a
camera server is Ethernet-based using standard Ethernet switches. In its
current implementation, data transfer and backend processing rates of ~3.8
GBytes/sec have been achieved. Together with the dead-time-free front end event
buffering on the FPGAs, this permits the cameras to operate at trigger rates of
up to several tens of kHz.
In the horizontal architecture of FlashCam, the photon detector plane (PDP),
consisting of photon detectors, preamplifiers, high voltage-, control-, and
monitoring systems, is a self-contained unit, which is interfaced through
analogue signal transmission to the digital readout system. The horizontal
integration of FlashCam is expected not only to be more cost efficient, it also
allows PDPs with different types of photon detectors to be adapted to the
FlashCam readout system. This paper describes the FlashCam concept, its
verification process, and its implementation for a 12 m class CTA telescope
with PMT-based PDP.
[9]
oai:arXiv.org:1211.3684 [pdf] - 1941855
FlashCam: A fully digital camera for CTA telescopes
Pühlhofer, G.;
Bauer, C.;
Biland, A.;
Florin, D.;
Föhr, C.;
Gadola, A.;
Hermann, G.;
Kalkuhl, C.;
Kasperek, J.;
Kihm, T.;
Koziol, J.;
Manalaysay, A.;
Marszalek, A.;
Rajda, P. J.;
Schanz, T.;
Steiner, S.;
Straumann, U.;
Tenzer, C.;
Vogler, P.;
Vollhardt, A.;
Weitzel, Q.;
Winiarski, K.;
Zietara, K.
Submitted: 2012-11-15
The future Cherenkov Telescope Array (CTA) will consist of several tens of
telescopes of different mirror sizes. CTA will provide next generation
sensitivity to very high energy photons from few tens of GeV to >100 TeV.
Several focal plane instrumentation options are currently being evaluated
inside the CTA consortium. In this paper, the current status of the FlashCam
prototyping project is described. FlashCam is based on a fully digital camera
readout concept and features a clean separation between photon detector plane
and signal digitization/triggering electronics.
[10]
oai:arXiv.org:0812.0762 [pdf] - 19120
A Trigger and Readout Scheme for future Cherenkov Telescope Arrays
Submitted: 2008-12-03
The next generation of ground-based gamma-ray observatories, such as e.g.
CTA, will consist of about 50-100 telescopes, and cameras with in total ~100000
to ~200000 channels. The telescopes of the core array will cover and effective
area of ~ 1 km2 and will be possibly accompanied by a large halo of smaller
telescopes spread over about 10 km2 . In order to make maximum use of the
stereoscopic approach, a very flexible inter-telescope trigger scheme is needed
which allows to couple telescopes that located up to ~1 km apart. The
development of a cost effective readout scheme for the camera signals exhibits
a major technological challenge. Here we present ideas on a new asynchronous
inter-telescope trigger scheme, and a very cost-effective, high-bandwidth
frontend to backend data transfer system, both based on standard Ethernet
components and an Ethernet front-end interface based on mass production
standard FPGAs.
[11]
oai:arXiv.org:astro-ph/0502113 [pdf] - 70904
Fluctuating annihilation cross sections and the generation of density
perturbations
Submitted: 2005-02-07, last modified: 2005-04-14
Fluctuations in the mass and decay rate of a heavy particle which for some
period dominates the energy density of the universe are known to lead to
adiabatic density perturbations. We show that generically the annihilation
cross section of the same particle also receives fluctuations, which leads to
entropy perturbations at freeze-out. If the particle comes to dominate the
energy density of the universe and subsequently decays, this leads to an
additional source of adiabatic density perturbations. On the other hand,
non-adiabatic density perturbations result when the particle does not decay but
contributes to the observed dark matter.
[12]
oai:arXiv.org:astro-ph/0412007 [pdf] - 141336
Light Scalars and the Generation of Density Perturbations During
Preheating or Inflaton Decay
Submitted: 2004-12-01, last modified: 2005-01-14
Reheating after inflation can occur through inflaton decay or efficient
parametric resonant production of particles from the oscillation of the
inflaton. If the particles produced interact with scalars that were light
during inflation, then significant super-horizon density perturbations are
generated during this era. These perturbations can be highly non-Gaussian.