The H0LiCOW collaboration inferred via gravitational lensing time delays a Hubble constant $H_0=73.3^{+1.7}_{-1.8}$ km s$^{-1}{\rm Mpc}^{-1}$, describing deflector mass density profiles by either a power-law or stars plus standard dark matter halos. The mass-sheet transform (MST) that leaves the lensing observables unchanged is considered the dominant source of residual uncertainty in $H_0$. We quantify any potential effect of the MST with flexible mass models that are maximally degenerate with H0. Our calculation is based on a new hierarchical approach in which the MST is only constrained by stellar kinematics. The approach is validated on hydrodynamically simulated lenses. We apply the method to the TDCOSMO sample of 7 lenses (6 from H0LiCOW) and measure $H_0=74.5^{+5.6}_{-6.1}$ km s$^{-1}{\rm Mpc}^{-1}$. In order to further constrain the deflector mass profiles, we then add imaging and spectroscopy for 33 strong gravitational lenses from the SLACS sample. For 9 of the SLAC lenses we use resolved kinematics to constrain the stellar anisotropy. From the joint analysis of the TDCOSMO+SLACS sample, we measure $H_0=67.4^{+4.1}_{-3.2}$ km s$^{-1}{\rm Mpc}^{-1}$, assuming that the TDCOSMO and SLACS galaxies are drawn from the same parent population. The blind H0LiCOW, TDCOSMO-only and TDCOSMO+SLACS analyses are in mutual statistical agreement. The TDCOSMO+SLACS analysis prefers marginally shallower mass profiles than H0LiCOW or TDCOSMO-only. While our new analysis does not statistically invalidate the mass profile assumptions by H0LiCOW, and thus their $H_0$ measurement relying on those, it demonstrates the importance of understanding the mass density profile of elliptical galaxies. The uncertainties on $H_0$ derived in this paper can be reduced by physical or observational priors on the form of the mass profile, or by additional data, chiefly spatially resolved kinematics of lens galaxies.

We present the X-shooter Lens Survey (XLENS) data. The main goal of XLENS is to disentangle the stellar and dark matter content of massive early-type galaxies (ETGs), through combined strong gravitational lensing, dynamics and spectroscopic stellar population studies. The sample consists of 11 lens galaxies covering the redshift range from $0.1$ to $0.45$ and having stellar velocity dispersions between $250$ and $380\,\mathrm{km}\,\mathrm{s}^{-1}$. All galaxies have multi-band, high-quality HST imaging. We have obtained long-slit spectra of the lens galaxies with X-shooter on the VLT. We are able to disentangle the dark and luminous mass components by combining lensing and extended kinematics data-sets, and we are also able to precisely constrain stellar mass-to-light ratios and infer the value of the low-mass cut-off of the IMF, by adding spectroscopic stellar population information. Our goal is to correlate these IMF parameters with ETG masses and investigate the relation between baryonic and non-baryonic matter during the mass assembly and structure formation processes. In this paper we provide an overview of the survey, highlighting its scientific motivations, main goals and techniques. We present the current sample, briefly describing the data reduction and analysis process, and we present the first results on spatially resolved kinematics.

We conduct a detailed lensing, dynamics and stellar population analysis of nine massive lens early-type galaxies (ETGs) from the X-Shooter Lens Survey (XLENS). Combining gravitational lensing constraints from HST imaging with spatially-resolved kinematics and line-indices constraints from VLT X-Shooter (XSH) spectra, we infer the low-mass slope and the low cut-off mass of the stellar Initial Mass Function (IMF): $x_{250}=2.37^{+0.12}_{-0.12}$ and $M_{{\rm low}, 250}= 0.131^{+0.023}_{-0.026}\, M_{\odot}$, respectively, for a reference point with $\sigma \equiv 250\, {{\rm kms}}^{-1}$ and R$_{{\rm eff}} \equiv 10$ kpc. All the XLENS systems are consistent with an IMF slope steeper than Milky Way-like. We find no significant correlations between IMF slope and any other quantity, except for an anti-correlation between total dynamical mass density and low-mass IMF slope at the 87% CL [$dx/d\log(\rho)$ = $ -0.19^{+0.15}_{-0.15}$]. This anti-correlation is consistent with the low redshift lenses found by Smith et al. (2015) that have high velocity dispersions and high stellar mass densities but surprisingly shallow IMF slopes.

The combination of strong gravitational lensing and stellar kinematics provides a powerful and robust method to investigate the mass and dynamical structure of early-type galaxies. We demonstrate this approach by analysing two massive ellipticals from the XLENS Survey for which both high-resolution HST imaging and X-Shooter spectroscopic observations are available. We adopt a flexible axisymmetric two-component mass model for the lens galaxies, consisting of a generalised NFW dark halo and a realistic self-gravitating stellar mass distribution. For both systems, we put constraints on the dark halo inner structure and flattening, and we find that they are dominated by the luminous component within one effective radius. By comparing the tight inferences on the stellar mass from the combined lensing and dynamics analysis with the values obtained from stellar population studies, we conclude that both galaxies are characterised by a Salpeter-like stellar initial mass function.

The long-standing assumption that the stellar initial mass function (IMF) is universal has recently been challenged by a number of observations. Several studies have shown that a "heavy" IMF (e.g., with a Salpeter-like abundance of low mass stars and thus normalisation) is preferred for massive early-type galaxies, while this IMF is inconsistent with the properties of less massive, later-type galaxies. These discoveries motivate the hypothesis that the IMF may vary (possibly very slightly) across galaxies and across components of individual galaxies (e.g. bulges vs discs). In this paper we use a sample of 19 late-type strong gravitational lenses from the SWELLS survey to investigate the IMFs of the bulges and discs in late-type galaxies. We perform a joint analysis of the galaxies' total masses (constrained by strong gravitational lensing) and stellar masses (constrained by optical and near-infrared colours in the context of a stellar population synthesis [SPS] model, up to an IMF normalisation parameter). Using minimal assumptions apart from the physical constraint that the total stellar mass within any aperture must be less than the total mass within the aperture, we find that the bulges of the galaxies cannot have IMFs heavier (i.e. implying high mass per unit luminosity) than Salpeter, while the disc IMFs are not well constrained by this data set. We also discuss the necessity for hierarchical modelling when combining incomplete information about multiple astronomical objects. This modelling approach allows us to place upper limits on the size of any departures from universality. More data, including spatially resolved kinematics (as in paper V) and stellar population diagnostics over a range of bulge and disc masses, are needed to robustly quantify how the IMF varies within galaxies.

We conduct a detailed investigation of the properties of the stellar initial mass function (IMF) in two massive early-type lens galaxies with velocity dispersions of sigma ~245 km/s and sigma ~325 km/s, for which both HST imaging and X-Shooter spectra are available. We compare the inferences obtained from two fully independent methods: (i) a combined gravitational lensing and stellar dynamics (L&D) analysis of the data sets employing self-consistent axisymmetric models, and (ii) a spectroscopic simple stellar population (SSP) analysis of optical line-strength indices, assuming single power-law IMFs. The results from the two approaches are found to be in agreement within the 1-sigma uncertainties. Both galaxies are consistent with having a Salpeter IMF (power-law slope of x = 2.35), which is strongly favoured over a Chabrier IMF (x = 1.8), with probabilities inferred from the joint analysis of 89% and 99%, respectively. Bottom-heavy IMFs significantly steeper than Salpeter (x >= 3.0) are ruled out with decisive evidence (Bayes factor B > 1000) for both galaxies, as they exceed the total mass derived from the L&D constraints. Our analysis allows, for the first time, the inference of the low-mass cut-off of the IMF (M_low). Combining the joint L&D and SSP analyses of both galaxies, we infer an IMF slope of x = 2.22 +/- 0.14, consistent with Salpeter IMF, and a low-mass limit M_low = 0.13 +/- 0.03 M_sun, just above the hydrogen burning limit.

We construct a fully self-consistent mass model for the lens galaxy J2141 at z=0.14, and use it to improve on previous studies by modelling its gravitational lensing effect, gas rotation curve and stellar kinematics simultaneously. We adopt a very flexible axisymmetric mass model constituted by a generalized NFW dark matter halo and a stellar mass distribution obtained by deprojecting the MGE fit to the high-resolution K'-band LGSAO imaging data of the galaxy, with the (spatially constant) M/L ratio as a free parameter. We model the stellar kinematics by solving the anisotropic Jeans equations. We find that the inner logarithmic slope of the dark halo is weakly constrained (gamma = 0.82^{+0.65}_{-0.54}), and consistent with an unmodified NFW profile. We infer the galaxy to have (i) a dark matter fraction within 2.2 disk radii of 0.28^{+0.15}_{-0.10}, independent of the galaxy stellar population, implying a maximal disk for J2141; (ii) an apparently uncontracted dark matter halo, with concentration c_{-2} = 7.7_{-2.5}^{+4.2} and virial velocity v_{vir} = 242_{-39}^{+44} km/s, consistent with LCDM predictions; (iii) a slightly oblate halo (q_h = 0.75^{+0.27}_{-0.16}), consistent with predictions from baryon-affected models. Comparing the stellar mass inferred from the combined analysis (log_{10} Mstar/Msun = 11.12_{-0.09}^{+0.05}) with that inferred from SPS modelling of the galaxies colours, and accounting for a cold gas fraction of 20+/-10%, we determine a preference for a Chabrier IMF over Salpeter IMF by a Bayes factor of 5.7 (substantial evidence). We infer a value beta_{z} = 1 - sigma^2_{z}/sigma^2_{R} = 0.43_{-0.11}^{+0.08} for the orbital anisotropy parameter in the meridional plane, in agreement with most studies of local disk galaxies, and ruling out at 99% CL that the dynamics of this system can be described by a two-integral distribution function. [Abridged]

We present gravitational lens models for 20 strong gravitational lens systems observed as part of the Sloan WFC Edge-on Late-type Lens Survey (SWELLS) project. Fifteen of the lenses are taken from paper I while five are newly discovered systems. The systems are galaxy-galaxy lenses where the foreground deflector has an inclined disc, with a wide range of morphological types, from late-type spiral to lenticular. For each system, we compare the total mass inside the critical curve inferred from gravitational lens modelling to the stellar mass inferred from stellar population synthesis (SPS) models, computing the stellar mass fraction f* = M(SPS)/M(lens). We find that, for the lower mass SWELLS systems, adoption of a Salpeter stellar initial mass function (IMF) leads to estimates of f* that exceed 1. This is unphysical, and provides strong evidence against the Salpeter IMF being valid for these systems. Taking the lower mass end of the SWELLS sample sigma(SIE) < 230 km/s, we find that the IMF is lighter (in terms of stellar mass-to-light ratio) than Salpeter with 98% probability, and consistent with the Chabrier IMF and IMFs between the two. This result is consistent with previous studies of spiral galaxies based on independent techniques. In combination with recent studies of massive early-type galaxies that have favoured a heavier Salpeter-like IMF, this result strengthens the evidence against a universal stellar IMF.

This paper presents the full VLT/VIMOS-IFU data set and related data products from an ESO Large Programme with the observational goal of obtaining two-dimensional kinematic data of early-type lens galaxies, out to one effective radius. The sample consists of 17 early-type galaxies (ETG) selected from the SLACS gravitational-lens survey. The galaxies cover the redshift range from 0.08 to 0.35 and have stellar velocity dispersions between 200 and 350 km/s. This programme is complemented by a similar observational programme on Keck, using long-slit spectroscopy. In combination with multi-band imaging data, the kinematic data provide stringent constraints on the inner mass profiles of ETGs beyond the local universe. Our Large Programme thus extends studies of nearby early-type galaxies (e.g. SAURON/ATLAS3D) by an order of magnitude in distance and toward higher masses. We provide an overview of our observational strategy, the data products (luminosity-weighted spectra and Hubble Space Telescope images) and derived products (i.e. two-dimensional fields of velocity dispersions and streaming motions) that have been used in a number of published and forthcoming lensing, kinematic and stellar-population studies.These studies also pave the way for future studies of early-type galaxies at z=1 with the upcoming extremely large telescopes.

We show that fluid stationary models are able to reproduce the observed, negative vertical gradient of the rotation velocity of the extra-planar gas in spiral galaxies. We have constructed models based on the simple condition that the pressure of the medium does not depend on density alone (baroclinic instead of barotropic solutions: isodensity and isothermal surfaces do not coincide). As an illustration, we have successfully applied our method to reproduce the observed velocity gradient of the lagging gaseous halo of NGC 891. The fluid stationary models discussed here can describe a hot homogeneous medium as well as a "gas" made of discrete, cold HI clouds with an isotropic velocity dispersion distribution. Although the method presented here generates a density and velocity field consistent with observational constraints, the stability of these configurations remains an open question.