The LAMP (Lightweight Asymmetry and Magnetism Probe) X-ray telescope is a mission concept to measure the polarization of X-ray astronomical sources at 250 eV via imaging mirrors that reflect at incidence angles near the polarization angle, i.e., 45 deg. Hence, it will require the adoption of multilayer coatings with a few nanometers d-spacing in order to enhance the reflectivity. The nickel electroforming technology has already been successfully used to fabricate the high angular resolution imaging mirrors of the X-ray telescopes SAX, XMM-Newton, and Swift/XRT. We are investigating this consolidated technology as a possible technique to manufacture focusing mirrors for LAMP. Although the very good reflectivity performances of this kind of mirrors were already demonstrated in grazing incidence, the reflectivity and the scattering properties have not been tested directly at the unusually large angle of 45 deg. Other possible substrates are represented by thin glass foils or silicon wafers. In this paper we present the results of the X-ray reflectivity campaign performed at the BEAR beamline of Elettra - Sincrotrone Trieste on multilayer coatings of various composition (Cr/C, Co/C), deposited with different sputtering parameters on nickel, silicon, and glass substrates, using polarized X-rays in the spectral range 240 - 290 eV.

We present a method for the production of segmented optics. It is a novel processing developed at INAF-Osservatorio Astronomico di Brera (INAF-OAB) employing commercial of-the-shelf materials. It is based on the shaping of thin glass foils by means of forced bending, this occurring at room temperature (cold-shaping). The glass is then assembled into a sandwich structure for retaining the imposed shape. The principal mechanical features of the mirrors are the very low weight, rigidity and environmental robustness. The cost and production time also turns to be very competitive. In this paper we sum up the results achieved during the r&d performed in the past years. We have investigated the theoretical limits of the structural components by means of parametric finite elements analyses; we also discuss the effects caused by the most common structural loads. Finally, the process implementation, the more significant validation tests and the mass production at the industry is described.